- 您现在的位置：买卖IC网 > PDF目录67722 > IS80C32-12PL (INTEGRATED SILICON SOLUTION INC) 8-BIT, 12 MHz, MICROCONTROLLER, PQCC44 PDF资料下载
参数资料
| 型号： | IS80C32-12PL |
| 厂商： | INTEGRATED SILICON SOLUTION INC |
| 元件分类： | 微控制器/微处理器 |
| 英文描述： | 8-BIT, 12 MHz, MICROCONTROLLER, PQCC44 |
| 封装： | PLASTIC, LCC-44 |
| 文件页数： | 24/48页 |
| 文件大小： | 379K |
| 代理商： | IS80C32-12PL |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页当前第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页
IS80C52
IS80C32
30
Integrated Silicon Solution, Inc. — 1-800-379-4774
MC004-1D
11/19/98
ISSI
Priority Level Structure
Each interrupt source can also be individually programmed
to one of two priority levels by setting or clearing a bit in
Special Function Register IP (interrupt priority) at address
0B8H. IP is cleared after a system reset to place all
interrupts at the lower priority level by default. A low-
priority interrupt can be interrupted by a high-priority
interrupt but not by another low-priority interrupt. A high-
priority interrupt can not be interrupted by any other
interrupt source.
If two requests of different priority levels are received
simultaneously, the request of higher priority level is
serviced. If requests of the same priority level are received
simultaneously, an internal polling sequence determines
which request is serviced. Thus, within each priority level
there is a second priority structure determined by the
polling sequence, as follows:
Source
Priority Within Level
1.
IE0
(Highest)
2.
TF0
3.
IE1
4.
TF1
5.
RI + TI
6.
TF2 + EXF2
(Lowest)
Note that the "priority within level" structure is only used
to resolve
simultaneous requests of the same priority
level.
How Interrupts Are Handled
The interrupt flags are sampled at S5P2 of every machine
cycle. The samples are polled during the following machine
cycle (the Timer 2 interrupt cycle is different, as described
in the Response Timer Section). If one of the flags was in
a set condition at S5P2 of the preceding cycle, the polling
cycle will find it and the interrupt system will generate an
LCALL to the appropriate service routine, provided this
hardware generated LCALL is not blocked by any of the
following conditions:
1. An interrupt of equal or higher priority level is already
in progress.
2. The current (polling) cycle is not the final cycle in the
execution of the instruction in progress.
3. The instruction in progress is RETI or any write to the
IE or IP registers.
Any of these three conditions will block the generation of
the LCALL to the interrupt service routine. Condition 2
ensures that the instruction in progress will be completed
before vectoring to any service routine. Condition 3 ensures
that if the instruction in progress is RETI or any access to
IE or IP, then at least one more instruction will be executed
before any interrupt is vectored to.
The polling cycle is repeated with each machine cycle,
and the values polled are the values that were present at
S5P2 of the previous machine cycle. If an active interrupt
flag is not being serviced because of one of the above
conditions and is not still active when the blocking condition
is removed, the denied interrupt will not be serviced. In
other words, the fact that the interrupt flag was once active
but not serviced is not remembered. Every polling cycle is
new. The polling cycle/LCALL sequence is illustrated in
Figure 20.
Note that if an interrupt of higher priority level goes active
prior to S5P2 of the machine cycle labeled C3 in Figure 20,
then in accordance with the above rules it will be serviced
during C5 and C6, without any instruction of the lower
priority routine having been executed.
Figure 20. Interrupt Response Timing Diagram
INTERRUPT
GOES ACTIVE
INTERRUPTS
ARE POLLED
INTERRUPT
ROUTINE
LONG CALL TO
INTERRUPT
VECTOR ADDRESS
INTERRUPT
LATCHED
C4
C3
C2
C1
C5
S5P2
S6
E
相关PDF资料 |
PDF描述 |
|---|---|
| IS80C32-40PLI | 8-BIT, 40 MHz, MICROCONTROLLER, PQCC44 |
| IS80C52PL | 8-BIT, MROM, 24 MHz, MICROCONTROLLER, PQCC44 |
| IS80C732-C | 8-BIT, 12 MHz, MICROCONTROLLER, PQCC44 |
| IS80C732-M | 8-BIT, 12 MHz, MICROCONTROLLER, PQCC44 |
| IS82C55A-596 | 24 I/O, PIA-GENERAL PURPOSE, PQCC44 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| IS80C32-12PLI | 制造商:ISSI 制造商全称:Integrated Silicon Solution, Inc 功能描述:CMOS SINGLE CHIP LOW VOLTAGE 8-BIT MICROCONTROLLER |
| IS80C32-12PQ | 制造商:ISSI 制造商全称:Integrated Silicon Solution, Inc 功能描述:CMOS SINGLE CHIP LOW VOLTAGE 8-BIT MICROCONTROLLER |
| IS80C32-12PQI | 制造商:ISSI 制造商全称:Integrated Silicon Solution, Inc 功能描述:CMOS SINGLE CHIP LOW VOLTAGE 8-BIT MICROCONTROLLER |
| IS80C32-12R | 制造商:未知厂家 制造商全称:未知厂家 功能描述:8-Bit Microcontroller |
| IS80C32-12W | 制造商:ISSI 制造商全称:Integrated Silicon Solution, Inc 功能描述:CMOS SINGLE CHIP LOW VOLTAGE 8-BIT MICROCONTROLLER |
发布紧急采购，3分钟左右您将得到回复。