参数资料
型号: ISL33001IUZ
厂商: Intersil
文件页数: 6/18页
文件大小: 0K
描述: IC BUS BUFF HOTSWAP 2WR 8MSOP
标准包装: 50
类型: 缓冲器
Tx/Rx类型: I²C Logic
电容 - 输入: 10pF
电源电压: 2.3 V ~ 5.5 V
电流 - 电源: 4mA
安装类型: 表面贴装
封装/外壳: 8-TSSOP,8-MSOP(0.118",3.00mm 宽)
供应商设备封装: 8-MSOP
包装: 管件
配用: ISL33001MSOPEVAL1Z-ND - EVAL BOARD ISL33001 8MSOP
ISL33001, ISL33002, ISL33003
14
Intersil products are manufactured, assembled and tested utilizing ISO9001 quality systems as noted
in the quality certifications found at www.intersil.com/en/support/qualandreliability.html
Intersil products are sold by description only. Intersil Corporation reserves the right to make changes in circuit design, software and/or specifications at any time
without notice. Accordingly, the reader is cautioned to verify that data sheets are current before placing orders. Information furnished by Intersil is believed to be
accurate and reliable. However, no responsibility is assumed by Intersil or its subsidiaries for its use; nor for any infringements of patents or other rights of third
parties which may result from its use. No license is granted by implication or otherwise under any patent or patent rights of Intersil or its subsidiaries.
For information regarding Intersil Corporation and its products, see www.intersil.com
FN7560.5
December 19, 2013
For additional products, see www.intersil.com/en/products.html
About Intersil
Intersil Corporation is a leader in the design and manufacture of high-performance analog, mixed-signal and power management
semiconductors. The company's products address some of the largest markets within the industrial and infrastructure, personal
computing and high-end consumer markets. For more information about Intersil, visit our website at www.intersil.com.
For the most updated datasheet, application notes, related documentation and related parts, please see the respective product
information page found at www.intersil.com. You may report errors or suggestions for improving this datasheet by visiting
www.intersil.com/en/support/ask-an-expert.html. Reliability reports are also available from our website at
Revision History
The revision history provided is for informational purposes only and is believed to be accurate, but not warranted. Please go to web to make sure you
have the latest revision.
DATE
REVISION
CHANGE
December 19, 2013
FN7560.5
Added Note 13 at the end of the "Elec Spec" table on page 5 as follows:
“13. If the Vcc1 and Vcc2 voltages diverge, then the shut-down Icc increases on the higher voltage
supply."
Added reference "(Note 13)" after "ISL33003 only" in rows for Vcc1 and Vcc2 "Shut-down Supply
current" parameters (last 2 rows of "Power Supplies" section) on page 4.
October 12, 2012
FN7560.4
Changed “SDA_IN, SCL_IN...0.3V to +(VCC1 + 0.3)V, SDA_OUT, SCL_OUT...0.3V to +(VCC2 + 0.3)V,
ENABLE, READY, ACC...0.3V to +(VCC1 + 0.3)V” to “SDA_IN, SCL_IN, SDA_OUT, SCL_OUT, READY...0.3V
to +7V; ENABLE, ACC...0.3V to +(VCC1 + 0.3)V”, in the Absolute Maximum Ratings section at the top of
Removed “Pb-free Reflow Profile” and link from “Thermal Information” section at the top of page 4.
Added “open drain” and “Connect to 10k pull-up resistor to VCC1.”, in Pin Descriptions in the READY
section on page 3.
10/11/11
FN7560.3
Converted to new datasheet template.
Changed Title of datasheet from: “2-Wire Bus Buffer With Rise Time Accelerators and Hot Swap
Capability”
to: I2C Bus Buffer with Rise Time Accelerators and Hot Swap Capability
Pg 1, added to Related Literature: AN1637, “Level Shifting Between 1.8V and 3.3V Using I2C Buffers”
Replaced POD M8.118 Rev 3 with Rev 4 due to the following changes:
Corrected lead width dimension in side view 1 from "0.25 - 0.036" to "0.25 - 0.36"
Replaced POD M8.15 Rev 1 with Rev 3 due to the following changes:
Changed in Typical Recommended Land Pattern the following:
2.41(0.095) to 2.20(0.087)
0.76 (0.030) to 0.60(0.023)
0.200 to 5.20(0.205)
Figure 3 (was Fig1) - Added:
- If tDELAY1 < tEN-LH then tDELAY2 = tEN-LH + tIDLE + tREADY-LH
- If tDELAY1 > tEN-LH then tDELAY2 = tEN-LH + tREADY-LH
and replaced graph
9/13/10
FN7560.2
Added SOIC package information to datasheet for ISL33001.
4/30/10
FN7560.1
Changed typical value of “Supply Current from VCC1” on page 4 for ISL33001 only from 2.2mA to
2.1mA.
Changed typical value of “Input-Output Offset Voltage” on page 5 from 100mV to 50mV.
3/18/10
FN7560.0
Initial Release.
相关PDF资料
PDF描述
ISL33001IBZ IC BUS BUFFER HOTSWAP I2C 8SOIC
ISL33002IRTZ IC BUS BUFF HOTSWAP 2WR 8TDFN
ISL33001IRTZ IC BUS BUFF HOTSWAP 2WR 8TDFN
VE-B34-IX-F2 CONVERTER MOD DC/DC 48V 75W
PIC12HV615-I/MD IC PIC MCU FLASH 1KX14 8DFN
相关代理商/技术参数
参数描述
ISL33001IUZ-T 功能描述:I2C 接口集成电路 W/ANNEAL VIS25 8INCH I2C BUFR IND(-40 RoHS:否 制造商:NXP Semiconductors 电源电压-最大:5.5 V 电源电压-最小:2.3 V 最大工作频率:400 KHz 最大工作温度:+ 85 C 封装 / 箱体:TSSOP-16
ISL33001MSOPEVAL1Z 功能描述:EVAL BOARD ISL33001 8MSOP RoHS:是 类别:编程器,开发系统 >> 评估演示板和套件 系列:- 标准包装:1 系列:PCI Express® (PCIe) 主要目的:接口,收发器,PCI Express 嵌入式:- 已用 IC / 零件:DS80PCI800 主要属性:- 次要属性:- 已供物品:板
ISL33002 制造商:INTERSIL 制造商全称:Intersil Corporation 功能描述:I2C Bus Buffer with Rise Time Accelerators and Hot Swap Capability
ISL33002IRT2Z 功能描述:I2C 接口集成电路 VIS25 8 INCH I2C BUFFER 8LD IND RoHS:否 制造商:NXP Semiconductors 电源电压-最大:5.5 V 电源电压-最小:2.3 V 最大工作频率:400 KHz 最大工作温度:+ 85 C 封装 / 箱体:TSSOP-16
ISL33002IRT2Z-T 功能描述:I2C 接口集成电路 VIS25 8 INCH I2C BUFFER 8LD IND RoHS:否 制造商:NXP Semiconductors 电源电压-最大:5.5 V 电源电压-最小:2.3 V 最大工作频率:400 KHz 最大工作温度:+ 85 C 封装 / 箱体:TSSOP-16