参数资料
| 型号： | ISL6262CRZ-T |
| 厂商： | Intersil |
| 文件页数： | 17/27页 |
| 文件大小： | 0K |
| 描述： | IC CORE REG 2PHASE 48-QFN |
| 标准包装： | 4,000 |
| 应用： | 转换器，Intel IMVP-6 |
| 输入电压： | 5 V ~ 25 V |
| 输出数： | 1 |
| 输出电压： | 0.3 V ~ 1.5 V |
| 工作温度： | -10°C ~ 100°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 48-VFQFN 裸露焊盘 |
| 供应商设备封装： | 48-QFN（7x7） |
| 包装： | 带卷 (TR) |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页当前第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页
ISL6262
While transitioning to single-phase operation, the controller
smoothly transitions current from the idling-phase to the
active-phase, and detects the idling-phase zero-current
condition. During transitions into automatic-DCM or forced-
CCM mode, the timing is carefully adjusted to eliminate
output voltage excursions. When a phase is added, the
current balance between phases is quickly restored.
While PSI# is high, both phases are switching. If PSI# is
asserted low and either DPRSTP# or DPRSLPVR are not
asserted, the controller will transition to CCM operation with
only phase 1 switching, and both FET's of phase 2 will be off.
The controller will thus eliminate switching losses associated
with the unneeded channel.
V OUT & V SOFT
and the ISL6262 will turn-off the lower FET of channel 1
whenever the channel 1 current decays to zero. As load is
further reduced, the phase 1 channel switching frequency
will decrease, thus maintaining high efficiency.
Dynamic Operation
Refer to Figure 29, the ISL6262 responds to changes in VID
command voltage by slewing to new voltages with a dV/dt
set by the SOFT capacitor and by the state of DPRSLPVR.
With C SOFT = 15nF and DPRSLPVR HIGH, the output
voltage will move at ±2.8mV/s for large changes in voltage.
For DPRSLPVR LOW, the large signal dV/dt will be
±13mV/s. As the output voltage approaches the VID
command value, the dV/dt moderates to prevent overshoot.
Keeping DPRSLPVR HIGH for voltage transitions into and
out of Deeper Sleep will result in low dV/dt output voltage
-2.5mV/μs
DPRSLPVR
VID #
2.5mV/μs
10mV/μs
changes with resulting minimized audio noise. For fastest
recovery from Deeper Sleep to Active mode, holding
DPRSLPVR LOW will result in maximum dV/dt. Therefore,
the ISL6262 is IMVP-6 compliant for DPRSTP# and
DPRSLPVR logic.
Intersil's R 3 Technology? has intrinsic voltage feedforward.
As a result, high-speed input voltage steps do not result in
significant output voltage perturbations. In response to load
current step increases, the ISL6262 will transiently raise the
switching frequency so that response time is decreased and
current is shared by two channels.
FIGURE 29. DEEPER SLEEP TRANSITION SHOWING
DPRSLPVR'S EFFECT ON EXIT SLEW RATE
When PSI#, DPRSTP#, and DPRSLPVR are all asserted,
the controller will transition to single-phase DCM mode. In
Protection
The ISL6262 provides overcurrent, overvoltage, under-
voltage protection and over-temperature protection as
shown in Table 3.
this mode, both FET's associated with phase 2 will be off,
TABLE 3. FAULT-PROTECTION SUMMARY OF ISL6262
FAULT DURATION PRIOR
TO PROTECTION
PROTECTION ACTIONS
FAULT RESET
Overcurrent fault
120μs
PWM1, PWM2 three-state,
VR_ON toggle or VDD toggle
PGOOD latched low
Way-Overcurrent fault
<2μs
PWM1, PWM2 three-state,
VR_ON toggle or VDD toggle
PGOOD latched low
Overvoltage fault (1.7V)
Immediately
Low-side FET on until Vcore
VDD toggle
<0.85V, then PWM three-state,
PGOOD latched low (OV-1.7V
always)
Overvoltage fault (+200mV)
1ms
PWM1, PWM2 three-state,
VR_ON toggle or VDD toggle
PGOOD latched low
Undervoltage fault
(-300mV)
Unbalance fault
(7.5mV)
Over-temperature
1ms
1ms
Immediately
PWM1, PWM2 three-state,
PGOOD latched low
PWM1, PWM2 three-state,
PGOOD latched low
VR_TT# goes low
VR_ON toggle or VDD toggle
VR_ON toggle or VDD toggle
N/A
fault (NTC <1.18V)
17
FN9199.2
May 15, 2006
相关PDF资料 |
PDF描述 |
|---|---|
| X40030S14I-CT1 | IC VOLTAGE MONITOR TRPL 14-SOIC |
| ASC25DREN-S13 | CONN EDGECARD 50POS .100 EXTEND |
| X40030S14I-C | IC VOLTAGE MONITOR TRPL 14-SOIC |
| X40030S14I-BT1 | IC VOLTAGE MONITOR TRPL 14-SOIC |
| ISL6336AIRZ | IC CTRLR PWM 6PHASE BUCK 48-QFN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ISL6262CRZ-TK | 功能描述:直流/直流开关调节器 TWO-PHS DC/DC BUCK CNTRLR IMVP-6 4 8LD RoHS:否 制造商:International Rectifier 最大输入电压:21 V 开关频率:1.5 MHz 输出电压:0.5 V to 0.86 V 输出电流:4 A 输出端数量: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:PQFN 4 x 5 |
| ISL6262CRZ-TR5242 | 制造商:Intersil Corporation 功能描述:53350B01 MASK ONLY AND DOT ON BRAND - Tape and Reel |
| ISL6262IRZ | 功能描述:直流/直流开关调节器 TWO-PHS DC/DC BUCK CNTRLR IMVP-6 4 8LD RoHS:否 制造商:International Rectifier 最大输入电压:21 V 开关频率:1.5 MHz 输出电压:0.5 V to 0.86 V 输出电流:4 A 输出端数量: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:PQFN 4 x 5 |
| ISL6262IRZ-T | 功能描述:直流/直流开关调节器 TWO-PHS DC/DC BUCK CNTRLR IMVP-6 4 8LD RoHS:否 制造商:International Rectifier 最大输入电压:21 V 开关频率:1.5 MHz 输出电压:0.5 V to 0.86 V 输出电流:4 A 输出端数量: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:PQFN 4 x 5 |
| ISL6263 | 制造商:INTERSIL 制造商全称:Intersil Corporation 功能描述:5-Bit VID Single-Phase Voltage Regulator for IMVP-6 Santa Rosa GPU Core |
发布紧急采购，3分钟左右您将得到回复。