- 您现在的位置：买卖IC网 > PDF目录15163 > ISL6307CRZ (Intersil)IC REG CTRLR BUCK PWM VM 48-QFN PDF资料下载
参数资料
| 型号： | ISL6307CRZ |
| 厂商： | Intersil |
| 文件页数： | 26/34页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR BUCK PWM VM 48-QFN |
| 标准包装： | 43 |
| PWM 型： | 电压模式 |
| 输出数： | 6 |
| 频率 - 最大： | 275kHz |
| 占空比： | 66.7% |
| 电源电压： | 4.75 V ~ 5.25 V |
| 降压： | 是 |
| 升压： | 无 |
| 回扫： | 无 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | 0°C ~ 70°C |
| 封装/外壳： | 48-VFQFN 裸露焊盘 |
| 包装： | 管件 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页当前第26页第27页第28页第29页第30页第31页第32页第33页第34页
ISL6307
compensate the temperature impact on the sensed current.
The block diagram of this function is shown in Figure 18.
TM
0.39*Vcc
0.33*Vcc
V CC
I sen6
0.28*Vcc
VR_FAN
R TM1
TM
Non-linear
A/D
Channel current sense
I sen5
I sen4
I sen3
I sen2
VR_HOT
T1
T2
T3
Temperature
o c
R NTC
V CC
D/A
k i
I 6
I 5
I 4
I 3
I 2
I 1
I sen1
FIGURE 17. VR_HOTAND VR_FAN SIGNAL VS TM VOLTAGE
R TC1
Based on the NTC temperature characteristics and the
desired threshold of VR_HOT signal, the pull-up resistor
TCOMP
4-bit
A/D
Droop, Iout &
Over current protection
RTM1 of TM pin is given by:
R TM1 = 2.75xR NTC ( T3 )
(EQ. 18)
R TC2
FIGURE 18. BLOCK DIAGRAM OF INTEGRATED
R NTC(T3) is the NTC resistance at the VR_HOT threshold
temperature T3.
The NTC resistance at the set point T2 and release point T1
of VR_FAN signal can be calculated as:
TEMPERATURE COMPENSATION
When the TM NTC is placed close to the current sense
component (inductor or MOSFET), the temperature of the
NTC will track the temperature of the current sense
component. Therefore, the TM voltage can be utilized to
R NTC ( T2 ) = 1.267xR NTC ( T3 )
R NTC ( T1 ) = 1.644xR NTC ( T3 )
(EQ. 19)
(EQ. 20)
obtain the temperature of the current sense component.
Based on Vcc voltage, ISL6307 converts the TM pin voltage
to a 6-bit TM digital signal for temperature compensation.
With the non-linear A/D converter of ISL6307, TM digital
With the NTC resistance value obtained from Equations 19 &
20, the temperature value T2 and T1 can be found from the
NTC datasheet.
Temperature Compensation
ISL6307 supports inductor DCR sensing, MOSFET R DS(ON)
sensing, or resistive sensing techniques. Both inductor DCR
and MSOFET R DS(ON) have the positive temperature
coefficient, which is about +0.38%/°C. Because the voltage
across inductor or MOSFET is sensed for the output current
information, the sensed current has the same positive
temperature coefficient as the inductor DCR or MOSFET
R DS(ON) .
In order to obtain the correct current information, there
should be a way to correct the temperature impact on the
current sense component. ISL6307 provides two methods:
integrated temperature compensation and external
temperature compensation.
Integrated Temperature Compensation
When TCOMP voltage is equal or greater than Vcc/15,
ISL6307 will utilize the voltage at TM and TCOMP pins to
26
signal is linearly proportional to the NTC temperature. For
accurate temperature compensation, the ratio of the TM
voltage to the NTC temperature of the practical design
should be similar to that in Figure 16.
Depending on the location of the NTC and the air-flowing,
the NTC may be cooler or hotter than the current sense
component. TCOMP pin voltage can be utilized to correct
the temperature difference between NTC and the current
sense component. When a different NTC type or different
voltage divider is used for the TM function, TCOMP voltage
can also be used to compensate for the difference between
the recommended TM voltage curve in Figure 17 and that of
the actual design. According to the Vcc voltage, ISL6307
converts the TCOMP pin voltage to a 4-bit TCOMP digital
signal as TCOMP factor N.
TCOMP factor N is an integer between 0 and 15. The
integrated temperature compensation function is disabled for
N = 0. For N = 4, the NTC temperature is equal to the
temperature of the current sense component. For N < 4, the
NTC is hotter than the current sense component. The NTC is
cooler than the current sense component for N > 4. When
N > 4, the larger TCOMP factor N, the larger the difference
FN9224.0
March 9, 2006
相关PDF资料 |
PDF描述 |
|---|---|
| VE-2TX-EY-B1 | CONVERTER MOD DC/DC 5.2V 50W |
| CAT1023ZI-45-GT3 | IC SUPERVISOR CPU 2K EEPR 8MSOP |
| VE-J5P-EY-F2 | CONVERTER MOD DC/DC 13.8V 50W |
| VE-2TX-EW-F3 | CONVERTER MOD DC/DC 5.2V 100W |
| CAT1023ZI-42-GT3 | IC SUPERVISOR CPU 2K EEPR 8MSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ISL6307CRZ-T | 功能描述:IC REG CTRLR BUCK PWM VM 48-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:275kHz 占空比:50% 电源电压:18 V ~ 110 V 降压:无 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:是 工作温度:-40°C ~ 85°C 封装/外壳:8-SOIC（0.154"，3.90mm 宽） 包装:带卷 (TR) |
| ISL6307IRZ | 功能描述:IC REG CTRLR BUCK PWM VM 48-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:275kHz 占空比:50% 电源电压:18 V ~ 110 V 降压:无 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:是 工作温度:-40°C ~ 85°C 封装/外壳:8-SOIC（0.154"，3.90mm 宽） 包装:带卷 (TR) |
| ISL6307IRZ-T | 功能描述:IC REG CTRLR BUCK PWM VM 48-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:275kHz 占空比:50% 电源电压:18 V ~ 110 V 降压:无 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:是 工作温度:-40°C ~ 85°C 封装/外壳:8-SOIC（0.154"，3.90mm 宽） 包装:带卷 (TR) |
| ISL6308ACRZ | 功能描述:IC CTRLR PWM BUCK 3PHASE 40-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 专用型 系列:- 标准包装:43 系列:- 应用:控制器，Intel VR11 输入电压:5 V ~ 12 V 输出数:1 输出电压:0.5 V ~ 1.6 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:48-VFQFN 裸露焊盘 供应商设备封装:48-QFN（7x7） 包装:管件 |
| ISL6308ACRZR5609 | 制造商:Intersil Corporation 功能描述:PB-FREE DAC-LESS MULTI-PHASE PWM CONTR W/3-DRIVERS, HARD WI - Rail/Tube |
发布紧急采购，3分钟左右您将得到回复。