参数资料
| 型号： | ISL6752AAZA-T |
| 厂商： | Intersil |
| 文件页数： | 15/16页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR PWM CM 16-QSOP |
| 标准包装： | 2,500 |
| PWM 型： | 电流模式 |
| 输出数： | 6 |
| 频率 - 最大： | 2MHz |
| 占空比： | 100% |
| 电源电压： | 9 V ~ 16 V |
| 降压： | 无 |
| 升压： | 无 |
| 回扫： | 无 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | -40°C ~ 105°C |
| 封装/外壳： | 16-SSOP（0.154"，3.90mm 宽） |
| 包装： | 带卷 (TR) |
ISL6752
When the PWM outputs are delayed, the 50% upper outputs
are equally delayed, so the resonant delay setting is
CT
OUTLL
OUTLR
OUTLLN
(SR1)
OUTLRN
(SR2)
unaffected.
On/Off Control
The ISL6753 does not have a separate enable/disable
control pin. The PWM outputs, OUTLL/OUTLR, may be
disabled by pulling VERR to ground. Doing so reduces the
duty cycle to zero, but the upper 50% duty cycle outputs,
OUTUL/OUTUR, will continue operation. Likewise, the SR
outputs OUTLLN/OUTLRN will be active high.
If the application requires that all outputs be off, then the
supply voltage, VDD, must be removed from the IC. This
may be accomplished as shown in Figure 19.
+VDD
FIGURE 17. WAVEFORM TIMING WITH PWM OUTPUTS
DELAYED, 0V < VADJ < 2.425V
ISL6752
VADJ
VREF
VERR
VDD
OUTLL
OUTLR
CT
CTBUF
OUTUL
RTD
OUTUR
ON/OFF
OUTLL
RESDEL
CT
CS
OUTLLN
OUTLRN
GND
(OPEN = OFF
GND = ON)
OUTLR
OUTLLN
(SR1)
OUTLRN
(SR2)
FIGURE 18. WAVEFORM TIMING WITH SR OUTPUTS
DELAYED, 2.575V < VADJ < 5.00V
Setting VADJ to VREF/2 results in no delay on any output.
The no delay voltage has a ±75mV tolerance window.
Control voltages below the VREF/2 zero delay threshold
cause the PWM outputs, OUTLL/LR, to be delayed. Control
voltages greater than the VREF/2 zero delay threshold
cause the SR outputs, OUTLLN/LRN, to be delayed. It
should be noted that when the PWM outputs, OUTLL/LR,
are delayed, the CS to output propagation delay is increased
by the amount of the added delay.
The delay feature is provided to compensate for mismatched
propagation delays between the PWM and SR outputs as
may be experienced when one set of signals crosses the
primary-secondary isolation boundary. If required, individual
output pulses may be stretched or compressed as required
using external resistors, capacitors, and diodes.
15
FIGURE 19. ON/OFF CONTROL USING VDD
Fault Conditions
A fault condition occurs if VREF or VDD fall below their
undervoltage lockout (UVLO) thresholds or if the thermal
protection is triggered. When a fault is detected the outputs
are disabled low. When the fault condition clears the outputs
are re-enabled.
An overcurrent condition is not considered a fault and does
not result in a shutdown.
Thermal Protection
Internal die over-temperature protection is provided. An
integrated temperature sensor protects the device should
the junction temperature exceed +140°C. There is
approximately +15°C of hysteresis.
Ground Plane Requirements
Careful layout is essential for satisfactory operation of the
device. A good ground plane must be employed. VDD and
VREF should be bypassed directly to GND with good high
frequency capacitance.
References
[1] Ridley, R., “A New Continuous-Time Model for Current
Mode Control”, IEEE Transactions on Power
Electronics, Vol. 6, No. 2, April 1991.
FN9181.3
October 31, 2008
相关PDF资料 |
PDF描述 |
|---|---|
| ISL6753AAZA | IC REG CTRLR PWM CM/VM 16-QSOP |
| ISL6754AAZA | IC REG CTRLR PWM CM/VM 20-QSOP |
| ISL6755AAZA | IC REG CTRLR PWM CM/VM 20-QSOP |
| ISL6845IU-T | IC REG CTRLR BST FLYBK ISO 8MSOP |
| ISL6884IAZ | IC CTRLR CCFL BRIGHTNESS 20-SSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ISL6752AAZA-TR5325 | 制造商:Intersil Corporation 功能描述:ZVS Full-Bridge Current-Mode PWM with Adjustable Synchronous Rectifier Control |
| ISL6752DBEVAL1Z | 功能描述:BOARD DEMO FOR ISL6752 RoHS:是 类别:编程器，开发系统 >> 评估板 - DC/DC 与 AC/DC（离线）SMPS 系列:* 标准包装:1 系列:- 主要目的:DC/DC，步降 输出及类型:1，非隔离 功率 - 输出:- 输出电压:3.3V 电流 - 输出:3A 输入电压:4.5 V ~ 28 V 稳压器拓扑结构:降压 频率 - 开关:250kHz 板类型:完全填充 已供物品:板 已用 IC / 零件:L7981 其它名称:497-12113STEVAL-ISA094V1-ND |
| ISL6752EVAL1Z | 功能描述:EVALUATION BOARD FOR ISL6752 RoHS:是 类别:编程器，开发系统 >> 过时/停产零件编号 系列:- 标准包装:1 系列:- 传感器类型:CMOS 成像，彩色（RGB） 传感范围:WVGA 接口:I²C 灵敏度:60 fps 电源电压:5.7 V ~ 6.3 V 嵌入式:否 已供物品:成像器板 已用 IC / 零件:KAC-00401 相关产品:4H2099-ND - SENSOR IMAGE WVGA COLOR 48-PQFP4H2094-ND - SENSOR IMAGE WVGA MONO 48-PQFP |
| ISL6753AAZA | 功能描述:IC REG CTRLR PWM CM/VM 16-QSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:275kHz 占空比:50% 电源电压:18 V ~ 110 V 降压:无 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:是 工作温度:-40°C ~ 85°C 封装/外壳:8-SOIC（0.154"，3.90mm 宽） 包装:带卷 (TR) |
| ISL6753AAZA-T | 功能描述:IC REG CTRLR PWM CM/VM 16-QSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:275kHz 占空比:50% 电源电压:18 V ~ 110 V 降压:无 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:是 工作温度:-40°C ~ 85°C 封装/外壳:8-SOIC（0.154"，3.90mm 宽） 包装:带卷 (TR) |
发布紧急采购，3分钟左右您将得到回复。