- 您现在的位置：买卖IC网 > PDF目录17367 > ISL85033EVAL2Z (Intersil)EVAL BOARD2 FOR ISL85033 PDF资料下载
参数资料
| 型号： | ISL85033EVAL2Z |
| 厂商： | Intersil |
| 文件页数： | 17/26页 |
| 文件大小： | 0K |
| 描述： | EVAL BOARD2 FOR ISL85033 |
| 标准包装： | 1 |
| 系列： | * |
ISL85033
shorted to GND with VOUT1 in regulation, it will enter overcurrent
hiccup mode with a very short hiccup waiting time. The reason is
that VOUT1 is still in regulation and can pull-up SS2 very quickly
via the resistor added between VOUT1 and SS2.
C 1
0.22μF
SS1
V OUT1
C 3
5.0V
Figure 42 illustrates output sequencing. When EN1 is high and
SS2
EN2 is floating, OUT1 comes up first and OUT2 won't start until
OUT1 > 90% of its regulation point. If EN1 is floating and EN2 is
high, OUT2 comes up first and OUT1 won't start until OUT2 > 90%
of its regulation point. If EN1 = EN2 = high, OUT1 and OUT2 come
ISL85033
V OUT2
C 4
3.3V
up at the same time. Please refer to Table 1 for conditions
related to Figure 42 (Output Sequencing).
EN1
High
EN2
Floating
TABLE 1. OUTPUT SEQUENCING
V OUT1 V OUT2
First
After V OUT1 > 90%
NOTE
R 2
8.06k
R 1
25.5k
Floating
High
High
High
After V OUT2 > 90%
Same time
First
Same time
FIGURE 41. ABSOLUTE START-UP
Floating Floating
as V OUT2
as V OUT1
Not
Allowed
SS1
V OUT1
5.0V
C1
0.1μF
SS1
SS2
V OUT1
C 3
5.0V
C 1
0.1μF
C 2
0.1μF
SS2
EN1
EN2
ISL85033
V OUT2
C 3
C 4
3.3V
C2
0.22μF
ISL85033
V OUT2
C 4
3.3V
FIGURE 42. OUTPUT SEQUENCING
FIGURE 39. INDEPENDENT START-UP
Protection Features
The ISL85033 limits the current in all on-chip power devices.
Overcurrent protection limits the current on the two buck
C 1
0.1μF
C 2
0.1μF
SS1
SS2
V OUT1
ISL85033
V OUT2
C 3
C 4
5.0V
3.3V
regulators and internal LDO for V CC .
Buck Regulator Overcurrent Protection
During the PWM on-time, the current through the internal
switching MOSFET is sampled and scaled through an internal
pilot device. The sampled current is compared to a nominal 5A
overcurrent limit. If the sampled current exceeds the overcurrent
limit reference level, an internal overcurrent fault counter is set
to 1 and an internal flag is set. The internal power MOSFET is
immediately turned off and will not be turned on again until the
next switching cycle.
The protection circuitry continues to monitor the current and
FIGURE 40. RATIOMETRIC START-UP
17
turns off the internal MOSFET as described. If the overcurrent
condition persists for 17 sequential clock cycles, the overcurrent
fault counter overflows indicating an overcurrent fault condition
exists. The regulator is shut down and power-good goes low.
The buck controller attempts to recover from the overcurrent
condition after waiting 8 soft-start cycles. The internal
overcurrent flag and counter are reset. A normal soft-start cycle
is attempted and normal operation continues if the fault
FN6676.6
February 23, 2012
相关PDF资料 |
PDF描述 |
|---|---|
| MIC5891BWM | IC DRVR LATCH 8BIT SER IN 16SOIC |
| MIC5891BN | IC DRVR LATCH 8BIT SER IN 16DIP |
| TAAB336K010G | CAP TANT 33UF 10V 10% AXIAL |
| SPX385AS-L-1-2 | IC VREF SHUNT PREC 1.235V 8SOICN |
| A9AAT-1105F | FLEX CABLE - AFE11T/AF11/AFE11T |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ISL85033IRTZ | 功能描述:IC REG BUCK SYNC ADJ 3A 28TQFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,500 系列:- 类型:降压（降压） 输出类型:两者兼有 输出数:1 输出电压:5V，1 V ~ 10 V 输入电压:3.5 V ~ 28 V PWM 型:电流模式 频率 - 开关:220kHz ~ 1MHz 电流 - 输出:600mA 同步整流器:无 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:16-SSOP（0.154"，3.90mm 宽） 包装:带卷 (TR) 供应商设备封装:16-QSOP |
| ISL85033IRTZ-T | 功能描述:IC REG BUCK SYNC ADJ 3A 28TQFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,500 系列:- 类型:降压（降压） 输出类型:两者兼有 输出数:1 输出电压:5V，1 V ~ 10 V 输入电压:3.5 V ~ 28 V PWM 型:电流模式 频率 - 开关:220kHz ~ 1MHz 电流 - 输出:600mA 同步整流器:无 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:16-SSOP（0.154"，3.90mm 宽） 包装:带卷 (TR) 供应商设备封装:16-QSOP |
| ISL85033IRTZ-T7A | 功能描述:直流/直流开关调节器 3A STD BUCK REG - 4X 4 TQFN 250 PC REEL RoHS:否 制造商:International Rectifier 最大输入电压:21 V 开关频率:1.5 MHz 输出电压:0.5 V to 0.86 V 输出电流:4 A 输出端数量: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:PQFN 4 x 5 |
| ISL8505IRZ | 制造商:Intersil Corporation 功能描述:PB-FREE DC TO DC POWER SWITCHING, 38LD QFN 5X7 - Rail/Tube |
| ISL8510EVAL1Z | 功能描述:EVALUATION BOARD FOR ISL8510 RoHS:是 类别:编程器，开发系统 >> 评估板 - DC/DC 与 AC/DC（离线）SMPS 系列:- 产品培训模块:Obsolescence Mitigation Program 标准包装:1 系列:True Shutdown™ 主要目的:DC/DC，步升 输出及类型:1，非隔离 功率 - 输出:- 输出电压:- 电流 - 输出:1A 输入电压:2.5 V ~ 5.5 V 稳压器拓扑结构:升压 频率 - 开关:3MHz 板类型:完全填充 已供物品:板 已用 IC / 零件:MAX8969 |
发布紧急采购，3分钟左右您将得到回复。