参数资料
| 型号： | ISL97652IRZ |
| 厂商： | Intersil |
| 文件页数： | 22/25页 |
| 文件大小： | 0K |
| 描述： | IC LCD SUPPLY HP 4CHN 48-QFN |
| 标准包装： | 43 |
| 应用： | LCD 电视机/监控器 |
| 电流 - 电源： | 500µA |
| 电源电压： | 8 V ~ 15 V |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 48-VFQFN 裸露焊盘 |
| 供应商设备封装： | 48-QFN（7x7） |
| 包装： | 管件 |
ISL97652
EN2
DLY2
VDPM
V IN - DIODE
V MAIN
V IN - DIODE OR
V MAIN DIODE
V ON
A VDD
VFLK
VGHM
FIGURE 24. TIMING DIAGRAM 3
Switching Frequency Control
The ISL97652 can operate at either 650kHz or 1.3MHz
depending on the state of the FREQ pin. When connected to
GND, 650kHz is selected. When connected to V IN , 1.3MHz
is selected. Higher frequencies enable the selection of
smaller inductors and capacitors. Lower frequencies allow
closer input/output ratios to be supported. The charge pump
circuits switch at half the frequency selected.
Undervoltage Lockout
The integrated undervoltage lockout circuit is designed to
power down the TFT-LCD if the input voltage falls below a
preset threshold. The ISL97652 will not start if the input
voltage is below the UVLO threshold.
Over-Temperature Protection
An internal temperature sensor continuously monitors the
die temperature. In the event that the die temperature
exceeds the thermal trip point of +150°C, the device will shut
down. Operation with die temperatures between +125°C and
150°C can be tolerated for short periods of time, however, in
order to maximize the operating life of the IC, it is
recommended that the effective continuous operating
junction temperature of the die should not exceed +125°C.
22
Fault Detection
The ISL97652 includes extensive fault handling circuitry,
which interacts with the start-up sequence circuitry if a fault
is detected.
During normal operation, if EN1 goes L, all major functions
are disabled immediately, including the 5V regulator. If EN2
goes L, but EN1 remains H, boost, V ON and GPM are
disabled immediately. When EN1 and/or EN2 return H, the
start-up sequence restarts from the appropriate point.
If the over-temperature threshold (+150°C nominal) is
exceeded, or if V IN drops below the specified lower UVLO
limit, all major functions are disabled immediately, excluding
the 5.3V regulator. If/when the temperature drops below
+100°C, or V IN returns to a level above the upper UVLO
threshold the start-up sequence will re-commence by
enabling REF.
Timed “Faults”
The four ramp voltages, SSB, SS, DEL1 and DEL2 all ramp
linearly from 0V to approximately 2.7V, where they are
soft-clamped. The 2V thresholds of each are used to enable
timed fault checking on related blocks. Therefore, external
capacitor values should be chosen such that all major
FN9287.1
November 2, 2007
相关PDF资料 |
PDF描述 |
|---|---|
| ISL97653AIRZ | IC LCD SUPPLY 5CHN 40-QFN |
| ISL97656IRTZ | IC REG BOOST ADJ 4A 10TDFN |
| ISL97701IRZ | IC REG BOOST ADJ 0.1A 10DFN |
| ISL97702IRZ-T7 | IC REG BOOST ADJ 0.13A DL 10DFN |
| ISL98012IUZ | IC REG BOOST ADJ 0.6A 10MSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ISL97652IRZ-T | 功能描述:IC LCD SUPPLY 4CH DUAL AMP 48QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 电源管理 - 专用 系列:- 应用说明:Ultrasound Imaging Systems Application Note 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:37 系列:- 应用:医疗用超声波成像，声纳 电流 - 电源:- 电源电压:2.37 V ~ 6 V 工作温度:0°C ~ 70°C 安装类型:表面贴装 封装/外壳:56-WFQFN 裸露焊盘 供应商设备封装:56-TQFN-EP（8x8） 包装:管件 |
| ISL97652IRZ-TK | 功能描述:IC LCD SUPPLY 4CH DUAL AMP 48QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 电源管理 - 专用 系列:- 应用说明:Ultrasound Imaging Systems Application Note 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:37 系列:- 应用:医疗用超声波成像，声纳 电流 - 电源:- 电源电压:2.37 V ~ 6 V 工作温度:0°C ~ 70°C 安装类型:表面贴装 封装/外壳:56-WFQFN 裸露焊盘 供应商设备封装:56-TQFN-EP（8x8） 包装:管件 |
| ISL97653AIRZ | 功能描述:电流型 PWM 控制器 5-CH INTEGRTD LCD SUPPLY W/TEMP SENSOR RoHS:否 制造商:Texas Instruments 开关频率:27 KHz 上升时间: 下降时间: 工作电源电压:6 V to 15 V 工作电源电流:1.5 mA 输出端数量:1 最大工作温度:+ 105 C 安装风格:SMD/SMT 封装 / 箱体:TSSOP-14 |
| ISL97653AIRZ-T | 功能描述:电流型 PWM 控制器 5-CH INTEGRTD LCD SUPPLY W/TEMP SENSOR RoHS:否 制造商:Texas Instruments 开关频率:27 KHz 上升时间: 下降时间: 工作电源电压:6 V to 15 V 工作电源电流:1.5 mA 输出端数量:1 最大工作温度:+ 105 C 安装风格:SMD/SMT 封装 / 箱体:TSSOP-14 |
| ISL97653AIRZ-TK | 功能描述:电流型 PWM 控制器 5-CH INTEGRTD LCD SUPPLY W/TEMP SENSOR RoHS:否 制造商:Texas Instruments 开关频率:27 KHz 上升时间: 下降时间: 工作电源电压:6 V to 15 V 工作电源电流:1.5 mA 输出端数量:1 最大工作温度:+ 105 C 安装风格:SMD/SMT 封装 / 箱体:TSSOP-14 |
发布紧急采购，3分钟左右您将得到回复。