参数资料
| 型号： | KS8999I |
| 厂商： | Micrel Inc |
| 文件页数： | 14/52页 |
| 文件大小： | 0K |
| 描述： | IC SWITCH 9-PORT 10/100 208-PQFP |
| 标准包装： | 100 |
| 系列： | * |
| 类型： | * |
| 应用： | * |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 208-MQFP，208-PQFP |
| 供应商设备封装： | 208-PQFP（28x28） |
| 包装： | 散装 |
| 配用： | 576-1023-ND - BOARD EVAL EXPERIMENT FOR KS8999 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页当前第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页
January 2005
21
KS8999
Micrel
Power Management
Power Save Mode
The KS8999 will turn off everything except for the Energy Detect and PLL circuits when the cable is not installed on an individual
port basis. In other words, the KS8999 will shutdown most of the internal circuits to save power if there is no link.
MDI/MDI-X Auto Crossover
The KS8999 supports MDI/MDI-X auto crossover. This facilitates the use of either a straight connection CAT-5 cable or a
crossover CAT-5 cable. The auto-sense function will detect remote transmit and receive pairs, and correctly assign the transmit
and receive pairs from the Micrel device. This can be highly useful when end users are unaware of cable types and can also
save on an additional uplink configuration connection.
The auto MDI/MDI-X is achieved by the Micrel device listening for the far end transmission channel and assigning transmit/
receive pairs accordingly. Auto MDI/MDI-X can be disabled by pulling the pin 87 (AUTOMDIX) to low.
Auto-Negotiation
The KS8999 conforms to the auto-negotiation protocol as described by the 802.3 committee. Auto-negotiation allows UTP
(Unshielded Twisted Pair) link partners to select the best common mode of operation. In auto-negotiation the link partners
advertise capabilities across the link to each other. If auto-negotiation is not supported or the link partner to the KS8999 is forced
to bypass auto-negotiation , then the mode is set by observing the signal at the receiver. This is known as parallel mode because
while the transmitter is sending auto-negotiation advertisements, the receiver is listening for advertisements or a fixed signal
protocol.
The flow for the link set up is depicted below.
Start Auto Negotiation
Force Link Setting
Listen for 10BaseT
Link Pulses
Listen for 100BaseTX
Idles
Attempt
Auto-Negotiation
Link Mode Set
Bypass
Auto-Negotiation
and Set Link Mode
Link Mode Set ?
Parallel
Operation
Join Flow
No
Yes
No
Figure 2. Auto-Negotiation
相关PDF资料 |
PDF描述 |
|---|---|
| KSZ8001LI TR | IC TXRX PHY 10/100 3.3V 48LQFP |
| KSZ8031RNLI | TXRX PHY 10/100 3.3V 24-QFN |
| KSZ8041MLL TR | TXRX 10/100 3.3V PHY MII 48LQFP |
| KSZ8041NLA3TR | TRANSCEIVER 10/100 32-MLF |
| KSZ8041NLJ TR | TXRX PHY 10/100 3.3V 32MLF |
相关代理商/技术参数 |
参数描述 |
|---|---|
| KS9/KSE9/59/103/115 | 制造商:PEPPERL+FUCHS 功能描述:Through beam cable sensor,PNP o/p 250mm |
| KS9~11 | 制造商:Tohodenzai 功能描述: |
| KS9~12B | 制造商:Tohodenzai 功能描述: |
| KS900A | 制造商:ALC 功能描述:ALCO CLEAR KNOB S9B6B |
| KS900A1/4 | 功能描述:旋钮和转盘 KNOB AL W/SKIRT 1/4 RoHS:否 制造商:Davies Molding 材料:Phenolic 设计:Set Screw 轴尺寸:0.25 in 直径:3/4 in 颜色:Black 指示器型式:Line |
发布紧急采购，3分钟左右您将得到回复。