- 您现在的位置：买卖IC网 > PDF目录11594 > KSZ8842-PMBL AM (Micrel Inc)IC ETHERNET SW 2PORT 100-LFBGA PDF资料下载
参数资料
| 型号： | KSZ8842-PMBL AM |
| 厂商： | Micrel Inc |
| 文件页数： | 42/119页 |
| 文件大小： | 0K |
| 描述： | IC ETHERNET SW 2PORT 100-LFBGA |
| 标准包装： | 260 |
| 控制器类型： | 以太网开关控制器 |
| 接口： | PCI |
| 电源电压： | 3.1 V ~ 3.5 V |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 100-LFBGA |
| 供应商设备封装： | 100-LFBGA |
| 包装： | 托盘 |
| 产品目录页面： | 1081 (CN2011-ZH PDF) |
| 配用： | 576-1636-ND - BOARD EVALUATION KSZ8842-PMQL |
| 其它名称： | 576-3348 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页当前第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页第78页第79页第80页第81页第82页第83页第84页第85页第86页第87页第88页第89页第90页第91页第92页第93页第94页第95页第96页第97页第98页第99页第100页第101页第102页第103页第104页第105页第106页第107页第108页第109页第110页第111页第112页第113页第114页第115页第116页第117页第118页第119页
Micrel, Inc.
KSZ8842-PMQL/PMBL
October 2007
29
M9999-100207-1.5
Broadcast Storm Protection
The KSZ8842-PMQL/PMBL has an intelligent option to protect the switch system from receiving too many broadcast
packets. As the broadcast packets are forwarded to all ports except the source port, an excessive number of switch
resources (bandwidth and available space in transmit queues) may be utilized. The KSZ8842-PMQL/PMBL has the
option to include “multicast packets” for storm control. The broadcast storm rate parameters are programmed globally,
and can be enabled or disabled on a per port basis in P1CR1[7] and P2CR1[7]. The rate is based on a 67ms interval
for 100Base-T and a 670ms interval for 10Base-T. At the beginning of each interval, the counter is cleared to zero and
the rate limit mechanism starts to count the number of bytes during the interval. The rate definition is described in
SGCR3[15:18]. The default setting is 0x63 (99 decimal). This is equal to a rate of 1% minimum size packets, calculated
as follows:
148,800 frames/sec X 67 ms/interval X 1% = 99 frames/interval (approx.) = 0x63
Where 148,800 frames/sec is based on 64-byte blocks of 100Base-T packets with 12 bytes of IPG and 8 bytes of
preamble between packets.
Repeater Mode
When KSZ8842-PMQL/PMBL is set to repeater mode (SGCR3[7] = 1), it only works on 100BT half-duplex mode. In
repeater enabled mode, all ingress packets will broadcast to other two ports without MAC check and learning. Before
setting the device to repeater mode, the user has to set bit 13 (100Mbps), bit 12 (auto-negotiation disabled) and bit 8
(half duplex) in both P1MBCR and P2MBCR registers as well as to set bit 6 (host half duplex) in SGCR3 register for
repeater mode.
The latency in repeater mode is defined from the 1st bit of DA into the ingress port 1 to the 1st bit of DA out of the
egress port 2. The minimum is 270 ns and the maximum is 310 ns (one clock skew of 25 MHz between TX and RX).
Clock Generator
The X1 and X2 pin/balls are connected to a 25MHz crystal. X1 can also serve as the connector to a 3.3V, 25MHz
oscillator (as described in the pin/ball description). The PCI Bus Interface supports a maximum speed of 33MHz PCLK
(PCI Bus Clock).
Advanced Switch Functions
Spanning Tree Support
To support spanning tree, the host port is the designated port for the processor.
The other ports can be configured in one of the five spanning tree states via “transmit enable”, “receive enable” and
“learning disable” register settings in registers P1CR2 and P2CR2 for ports 1 and 2, respectively. Table 4 shows the
port setting and software actions taken for each of the five spanning tree states.
Disable State
Port Setting
Software Action
The port should
not forward or
receive any
packets. Learning
is disabled.
“transmit enable = 0,
receive enable = 0,
learning disable = 1”
The processor should not send any packets to the port. The switch
may still send specific packets to the processor (packets that
match some entries in the “static MAC table” with “overriding bit”
set) and the processor should discard those packets. Address
learning is disabled on the port in this state.
Blocking State
Port Setting
Software Action
Only packets to
the processor are
forwarded.
“transmit enable = 0,
receive enable = 0,
learning disable = 1”
The processor should not send any packets to the port(s) in this
state. The processor should program the “Static MAC table” with
the entries that it needs to receive (for example, BPDU packets).
The “overriding” bit should also be set so that the switch will
forward those specific packets to the processor. Address learning
is disabled on the port in this state.
Listening State
Port Setting
Software Action
Only packets to
and from the
processor are
“transmit enable = 0,
receive enable = 0,
learning disable = 1”
The processor should program the “Static MAC table” with the
entries that it needs to receive (for example, BPDU packets). The
“overriding” bit should be set so that the switch will forward those
相关PDF资料 |
PDF描述 |
|---|---|
| V72A28C400BL3 | CONVERTER MOD DC/DC 28V 400W |
| V72A28C400BL2 | CONVERTER MOD DC/DC 28V 400W |
| V72A28C400BL | CONVERTER MOD DC/DC 28V 400W |
| V72A28C400B3 | CONVERTER MOD DC/DC 28V 400W |
| V72A15C400BG3 | CONVERTER MOD DC/DC 15V 400W |
相关代理商/技术参数 |
参数描述 |
|---|---|
| KSZ8842-PMBL-EVAL | 功能描述:以太网开发工具 2+1 Port 10/100 Ethernet Switch with 32b/33MHz PCI Interface (BGA Version) Eval Board RoHS:否 制造商:Micrel 产品:Evaluation Boards 类型:Ethernet Transceivers 工具用于评估:KSZ8873RLL 接口类型:RMII 工作电源电压: |
| KSZ8842-PMBL-TR | 功能描述:Ethernet Switch 10/100 Base-T/TX PHY PCI Interface 100-LFBGA (9x9) 制造商:microchip technology 系列:- 包装:剪切带（CT） 零件状态:停产 协议:以太网 功能:开关 接口:PCI 标准:10/100 Base-T/TX PHY 电压 - 电源:3.1 V ~ 3.5 V 电流 - 电源:122mA 工作温度:-40°C ~ 85°C 封装/外壳:100-LFBGA 供应商器件封装:100-LFBGA（9x9） 标准包装:1 |
| KSZ8842-PMQL | 功能描述:以太网 IC 2-Port Ethernet Switch/Repeater + 32-bit/33MHz PCI bus interface(Lead Free) RoHS:否 制造商:Micrel 产品:Ethernet Switches 收发器数量:2 数据速率:10 Mb/s, 100 Mb/s 电源电压-最大:1.25 V, 3.45 V 电源电压-最小:1.15 V, 3.15 V 最大工作温度:+ 85 C 封装 / 箱体:QFN-64 封装:Tray |
| KSZ8842-PMQL-EVAL | 功能描述:以太网开发工具 KSZ8842-PMQL Evaluation Board RoHS:否 制造商:Micrel 产品:Evaluation Boards 类型:Ethernet Transceivers 工具用于评估:KSZ8873RLL 接口类型:RMII 工作电源电压: |
| KSZ8842-PMQLI | 功能描述:以太网 IC 2-Port Ethernet Switch/Repeater + 32-bit/33MHz PCI bus interface, Ind Temp (Lead Free) RoHS:否 制造商:Micrel 产品:Ethernet Switches 收发器数量:2 数据速率:10 Mb/s, 100 Mb/s 电源电压-最大:1.25 V, 3.45 V 电源电压-最小:1.15 V, 3.15 V 最大工作温度:+ 85 C 封装 / 箱体:QFN-64 封装:Tray |
发布紧急采购，3分钟左右您将得到回复。