- 您现在的位置：买卖IC网 > PDF目录97995 > L5994A (STMICROELECTRONICS) 1 A DUAL SWITCHING CONTROLLER, 345 kHz SWITCHING FREQ-MAX, PQFP32 PDF资料下载
参数资料
| 型号： | L5994A |
| 厂商： | STMICROELECTRONICS |
| 元件分类： | 稳压器 |
| 英文描述： | 1 A DUAL SWITCHING CONTROLLER, 345 kHz SWITCHING FREQ-MAX, PQFP32 |
| 封装： | TQFP-32 |
| 文件页数： | 10/26页 |
| 文件大小： | 322K |
| 代理商： | L5994A |
Obsolete
Product(s)
- Obsolete
Product(s)
L5994 - L5994A
18/26
thus both should be considered:
If specification on the output ripple under pulse-skipping condition is also given, COUTX and ESRX must comply
with it as well.
Further constraints on the minimum output capacitance can arise from specifications regarding the maximum
undershoot,
V-OUT, or overshoot, V+OUT, due to a step-load change IOUT:
whichever is greater, and where Dmax is the maximum duty cycle and the quantities are relevant either to the
+3.3V or +5.1V section. High performance capacitors should be employed to reduce the capacitance needed
for a given ESR, to avoid paralleling several parts with a considerable waste of space. Although excellent elec-
trolytic capacitors are available, OS-CON or tantalums may be preferred especially if very compact design is
required, or in case of surface mount assemblies. Multilayer ceramic capacitors with extremely low ESR are now
available, but they have a large spread of the capacitance value, so they should be paralleled with another more
stable, high-ESR capacitor.
Miscellaneous Components
The feedback loop has virtually unlimited bandwidth, thus a filter is necessary to make the system insensitive
to the switching frequency ripple and, in general, to prevent noise from disturbing the correct operation of the
error summing comparator. Anyway, the cut-off frequency of this filter can be very high, so that line and load
transient response is extremely fast. This filter is a simple R-C type where resistance and capacitance can be
chosen for a typical 3dB cut-off frequency of 60kHz.
As to the bootstrap diodes, even though small signal diodes might be effectively used, it is preferable to employ
low-power Schottky rectifiers, since that increase slightly the gate drive voltage, in favour of efficiency. The boot-
strap capacitor can be a 100nF film capacitor.
The soft-start capacitors determine the time during which the current limitation circuit moves gradually the set-
point from zero up to 50mV in order to limit the current inflow at start-up. This ramp lasts approximately 1 ms
per nF of soft-start capacitance (10 to 100 nF typical values), but the actual time necessary to the output voltage
to reach the steady-state value depends on the load current and the output filter capacitance.
There are some critical points of the IC that may require by-pass capacitors to prevent noise from disturbing the
circuit. These points are the reference voltage VREF, the IC supply pin VIN, the PREG5 line and the alternative
supply pin V5SW. Use film capacitors suitable for AC decoupling.
External PNP bipolar transistor
As the output of the auxiliary winding on the 5.1V section is dimensioned for 13V, considering an output voltage
of 12V the power loss across the external PNP transistor is of:
PLOSS = (VIN - VOUT) IOUT
The collector-emitter breakdown voltage must be greater than the one delivered by the transformer on the 5.1V
section and this is true also for the collector-base junction. A small signal trnsistor is enough for the considered
application.
V
RPP X
R
()
0.011
ESR
X
R
SENS EX
--------------------------
=
V
RPP X
R
()
3.1 10
6
–
L
X
C
OUTX
-------------------
1
R
SENS EX
2
--------------------------
1
V
IN M IN
V
OUT
–
----------------------------------------
1
V
OUT
---------------
–
=
C
OU T
LI
OUT
2
V
OUT
-
V
IN M IN
D
MAX
V
OUT
–
()
-----------------------------------------------------------------------------------------
>
C
OU T
LI
OUT
2
V
OUT
+
V
OU T
--------------------------------------
>
相关PDF资料 |
PDF描述 |
|---|---|
| L5994 | 1 A DUAL SWITCHING CONTROLLER, 345 kHz SWITCHING FREQ-MAX, PQFP32 |
| L6206PD013TR | STEPPER MOTOR CONTROLLER, 5.6 A, PDSO36 |
| L6207PD013TR | STEPPER MOTOR CONTROLLER, 5.6 A, PDSO36 |
| L6219DSA | STEPPER MOTOR CONTROLLER, 1 A, PDSO24 |
| L6228PDTR | STEPPER MOTOR CONTROLLER, 2.8 A, PDSO36 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| L5995 | 制造商:未知厂家 制造商全称:未知厂家 功能描述:Current-Mode SMPS Controller |
| L5996 | 制造商:STMICROELECTRONICS 制造商全称:STMicroelectronics 功能描述:5 BIT DYNAMIC DAC CONTROLLER FOR MOBILE CPU |
| L-59BL/1EGW | 制造商:Kingbright Corporation 功能描述: 制造商:Kingbright Corporation 功能描述:LED 5MM RED/GREEN 40MCD/60MCD 制造商:Kingbright Corporation 功能描述:LED, 5MM, RED/GREEN, 40MCD/60MCD 制造商:Kingbright Corporation 功能描述:LED, 5MM, RED/GREEN, 40MCD/60MCD, LED Colour:Red, Green, Height:7.24mm, Width:7. 制造商:Kingbright Corporation 功能描述:Red/grn r/a cbi,5mm,L-59BL/1EGW |
| L-59BL/1EYW | 制造商:Kingbright Corporation 功能描述: 制造商:Kingbright Corporation 功能描述:LED 5MM RED/YELLOW 40MCD/40MCD 制造商:Kingbright Corporation 功能描述:LED, 5MM, RED/YELLOW, 40MCD/40MCD 制造商:Kingbright Corporation 功能描述:LED, 5MM, RED/YELLOW, 40MCD/40MCD, LED Colour:Red, Yellow, Height:7.24mm, Width: |
| L-59BL/1GEW | 制造商:Kingbright Corporation 功能描述: |
发布紧急采购，3分钟左右您将得到回复。