- 您现在的位置：买卖IC网 > PDF目录39185 > L6997STR (STMICROELECTRONICS) SWITCHING CONTROLLER, PDSO20 PDF资料下载
参数资料
| 型号： | L6997STR |
| 厂商： | STMICROELECTRONICS |
| 元件分类： | 稳压器 |
| 英文描述： | SWITCHING CONTROLLER, PDSO20 |
| 封装： | MO-153-AC, TSSOP-20 |
| 文件页数： | 4/30页 |
| 文件大小： | 546K |
| 代理商： | L6997STR |
第1页第2页第3页当前第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页
L6997S
12/30
5
APPLICATION INFORMATION
5.1 5A Demo board description
The demo board shows the device operation in this condition: VIN from 3.3V to 5V, IOUT=5A VOUT=1.25V. The
evaluation board let use the system with 2 different voltages (VCC the supply for the IC and VIN the power input
for the conversion) so replacing the input capacitors the power input voltage could be also 35V. When instead
the input voltage (VIN) is equal to the VCC it should be better joining them with a 10
resistor in order to filter the
device input voltage. On the topside demo there are two different jumpers: one jumper, near the OVP and POW-
ER GOOD test points, is used to shut down the device; when the jumper is present the device is in SHUTDOWN
mode, to run the device remove the jumper. The other jumper, near the VREF test point, is used to set the PFM/
PSK mode. When the jumper is present, at light load, the system will go in PFM mode; if there is not the jumper,
at light load, the system will remain in PWM mode. In the demo bottom side there are two others different jump-
ers. They are used to set or remove the INTEGRATOR configuration. When the jumpers named with INT label
are closed AND the jumpers named with the NOINT label are open the integrator configuration is set. Some-
times the integrator configuration needs a low frequency filter the to reduce the noise interaction. In this case
instead close the INT jumpers put there a resistor and after a capacitor to ground (as in the schematic diagram);
the pole value is around 500Khz but it should be higher enough than the switching frequency (ten times). On
the opposite when the jumpers named with the NOINT are closed and the jumpers named with INT are open
the NON INTEGRATOR configuration is selected. Refer to the Table 1 and 2 for the jumpers connection.
Figure 10. Demoboard Schematic Diagram
C14,C15
R3
R10
TP1
TP2
C10
R6
Q1
D2
TP3
C2
C6
R8
C12
C9
R9
R1
D1
R2
R5
SD
NS
L1
R7
C7,C13
C11
C4
R4
Rn
C3
C1
Q2
Cn
INT
NOINT
C5
C8
Vcc
SHDN
VREF
OSC
NOSKIP
VDR
INT
VFB
GNDSENSE
SS
BOOT
ILIM
HGATE
PHASE
LGATE
PGND
GND
VSENSE
OVP
PGOOD
VCC
VOUT
GNDOUT
GNDin
VIin
L6997S
J1
相关PDF资料 |
PDF描述 |
|---|---|
| L8020G-S08-R | SPECIALTY ANALOG CIRCUIT, PDSO8 |
| L8115G-R16-R | SPECIALTY ANALOG CIRCUIT, PDSO16 |
| L8115-R20-R | SPECIALTY ANALOG CIRCUIT, PDSO20 |
| L8115G-R20-R | SPECIALTY ANALOG CIRCUIT, PDSO20 |
| L8115L-R16-R | SPECIALTY ANALOG CIRCUIT, PDSO16 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| L6998-0 | 制造商:Johanson Manufacturing 功能描述:TUNING ELEMENT |
| L6998-1 | 制造商:Johanson Manufacturing 功能描述:TUNING ELEMENT |
| L6998-5 | 制造商:Johanson Manufacturing 功能描述:TUNING ELEMENT |
| L6998-6 | 制造商:Johanson Manufacturing 功能描述:TUNING ELEMENT |
| L6999 | 制造商:HAMAMATSU 制造商全称:Hamamatsu Corporation 功能描述:The best light source is supported by the best electrode technology |
发布紧急采购，3分钟左右您将得到回复。