- 您现在的位置：买卖IC网 > PDF目录30715 > LA1862M FM, AUDIO DEMODULATOR, PDSO36 PDF资料下载
参数资料
| 型号： | LA1862M |
| 元件分类： | 接收器 |
| 英文描述： | FM, AUDIO DEMODULATOR, PDSO36 |
| 封装： | MFP-36 |
| 文件页数： | 5/27页 |
| 文件大小： | 810K |
| 代理商： | LA1862M |
第1页第2页第3页第4页当前第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页
IF Block
Obtaining Stable Characteristics
1.
Pin 36 is the IF input; pin 35, the IF bypass. Connect a
330
Ω resistor between them for ceramic filter matching.
2.
Position the capacitor between thr IF bypass (pin 35) and
the ground pattern so as to maximize AM rejection.
3.
Provide separate ground pattern islands for the IF input
and detection circuits, as sharing the same island reduces
stability.
4.
Position the IF input and detector coil as far apart as
possible, as proximity reduces stability and introduces beat
noise in the output.
S-meter Output VSM
1.
Pin 1 is the field strength indicator (or ‘‘S-meter’’) output. Its current-driven circuit uses an external resistance to adjust the
slopes of the I/O characteristics curves.
2.
The S-meter output is internally connected to the soft muting and IF buffer blocks for use as a control signal for the soft
muting drive and IF count buffer.
3.
The point at which the input produces an S-meter output depends on the front end (FE) and interstage amplifier gains.
4.
Too large a front end gain produces floating S-meter output even when there is no input. Either use a smaller load resistance
on pin 1 or reduce the front end gain so that the output with no load does not exceed 0.5 V.
5.
The S-meter output circuit has a dynamic range of approximately 80 dB, but this is limited by the front end noise component
and broadband AGC circuit.
Soft Muting
1.
The soft muting circuit operates in response to the S-meter output voltage. The amount of muting is related to the pin 5
output voltage.
2.
There are two mechanisms for adjusting the soft muting
I/O characteristic curve:
a. Start point for muting: Resistance attached to pin 4
b. Attenuation for muting: Resistance attached to pin 32
*Note that the resistance attached to pin 1 also affects the
curve.
3.
The soft muting circuit automatically varies the amount of
muting in response to the IF input. In the absence of front
end broadband AGC effects, the time constant of the RC
circuit between pins 1 and 5 determines the response.
Band Muting
1.
Band muting uses the detector’s S-curve. The band-width depends on the resistance between pins 29 and 33. Select this value
to match the needs of the destination market.
2.
Keep in mind that changing the detector coil or tuning capacity Q changes the slope of the S-curve and hence the bandwidth.
3.
The attenuation muting depends on the resistance connected to pin 32.
4.
The muting transient response depends on the resistance between pins 29 and 33, the capacitance at pin 29, and the time
constant for the RC circuit at pin 5.
Unit (resistance:
Ω, capacitance: F)
(Muting drive output)
Charging
current
Time constant for charging
re
× C5 = τ
Time constant for discharging
R5 × C5 = τ
Discharging
current
LA1862M
No. 4092- 13/27
相关PDF资料 |
PDF描述 |
|---|---|
| LA1863M | 1-BAND, AUDIO TUNER, PQFP44 |
| LA1867NM | AM/FM, AUDIO DEMODULATOR, PQFP44 |
| LA1875M | AM/FM, AUDIO SINGLE CHIP RECEIVER, PDSO36 |
| LA1875M | AM/FM, AUDIO SINGLE CHIP RECEIVER, PDSO36 |
| LA1883M | AM/FM, AUDIO SINGLE CHIP RECEIVER, PQFP64 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LA1867NM | 制造商:SANYO 制造商全称:Sanyo Semicon Device 功能描述:Car Radio Single-Chip Tuner System |
| LA1867NM-MPB-E | 制造商:ON Semiconductor 功能描述: |
| LA186B-9SEF9UG-3-PF | 制造商:LIGITEK 制造商全称:LIGITEK electronics co., ltd. 功能描述:LED ARRAY |
| LA186B-9SEF-PF | 制造商:LIGITEK 制造商全称:LIGITEK electronics co., ltd. 功能描述:LED ARRAY |
| LA186B-DBK-2-PF | 制造商:LIGITEK 制造商全称:LIGITEK electronics co., ltd. 功能描述:LED ARRAY |
发布紧急采购，3分钟左右您将得到回复。