参数资料
型号: LM1269NA/NOPB
厂商: NATIONAL SEMICONDUCTOR CORP
元件分类: 音频/视频放大
英文描述: 3 CHANNEL, VIDEO PREAMPLIFIER, PDIP24
封装: PLASTIC, DIP-24
文件页数: 16/20页
文件大小: 1676K
代理商: LM1269NA/NOPB
External Interface Signals Electrical Characteristics (Continued)
Note 3: All voltages are measured with respect to GND, unless otherwise specified.
Note 4: Human body model, 100 pF discharged through a 1.5 k
resistor.
Note 5: Machine Model ESD test is covered by specification EIAJ IC-121-1981. A 200 pF cap is charged to the specified voltage, then discharged directly into the
IC with no external series resistor (resistance of discharge path must be under 50
).
Note 6: Typical specifications are specified at +25C and represent the most likely parametric norm.
Note 7: Tested limits are guaranteed to National’s AOQL (Average Outgoing Quality Level).
Note 8: The supply current specified is the quiescent current for VCC with RL = . Load resistors are not required and are not used in the test circuit, therefore all
the supply current is used by the pre-amp.
Note 9: Linearity Error is the variation in step height of a 16 step staircase input signal waveform with 0.7 VP-P level at the input, subdivided into 16 equal steps,
with each step approximately 100 ns in width.
Note 10: Input from signal generator: tr,tf < 1 ns. Scope and generator response used for testing: tr = 1.1 ns, tf = 0.9 ns. Using the RSS technique the scope and
generator response have been removed from the output rise and fall times.
Note 11:
AV track is a measure of the ability of any two amplifiers to track each other and quantifies the matching of the three gain stages. It is the difference in
gain change between any two amplifiers with the contrast set to AV 12 and measured relative to the AV max condition. For example, at AV max the three amplifiers’
gains might be 12.1 dB, 11.9 dB, and 11.8 dB and change to 2.2 dB, 1.9 dB and 1.7 dB respectively for contrast set to AV 12. This yields a typical gain change of
10.0 dB with a tracking change of ±0.2 dB.
Note 12: ABL should provide smooth decrease in gain over the operational range of 0 dB to –6 dB
A
ABL = A(VABL =VABL Max Gain) A(VABL =VABL Min Gain)
Beyond –6 dB the gain characteristics, linearity, pulse response, and/or behavior may depart from normal values.
Note 13: Adjust input frequency from 10 MHz (AV max reference level) to the 3 dB corner frequency (f3 dB).
Note 14: Measure output levels of the other two undriven amplifiers relative to the driven amplifier to determine channel separation. Terminate the undriven amplifier
inputs to simulate generator loading. Repeat test at fIN = 10 MHz for Vsep 10 MHz.
Note 15: A minimum pulse width of 200 ns is guaranteed for a horizontal line of 15 kHz. This limit is guaranteed by design. If a lower line rate is used then a longer
clamp pulse may be required.
Note 16: The video black level is used for this test. OSD amplitude is measured from the video black level to the OSD white level.
Note 17: Limits met by matching the external resistor going to pin 24 to the H Flyback voltage.
LM1269
www.national.com
5
相关PDF资料
PDF描述
LM1276AAA/NA 1 CHANNEL, VIDEO PREAMPLIFIER, PDIP28
LM1279AN/NOPB 3 CHANNEL, VIDEO AMPLIFIER, PDIP20
LM1279N/NOPB 1 CHANNEL, VIDEO AMPLIFIER, PDIP20
LM136A-2.5MD8 1-OUTPUT TWO TERM VOLTAGE REFERENCE, 5 V, UUC
LM136A-5.0MW8 1-OUTPUT TWO TERM VOLTAGE REFERENCE, 5 V, UUC
相关代理商/技术参数
参数描述
LM126H 制造商:NSC 制造商全称:National Semiconductor 功能描述:VOLTAGE REGULATORS
LM126H/883B 制造商:Texas Instruments 功能描述:IC,VOLT REGULATOR,FIXED,+-12V,BIPOLAR,CAN,10PIN,METAL
LM126H/883C 制造商:Texas Instruments 功能描述:
LM1270 制造商:NSC 制造商全称:National Semiconductor 功能描述:Hi-Brite 200 MHz I2C Compatible RGB Image Enhancer with Video Auto Sizing
LM1270N 制造商:NSC 制造商全称:National Semiconductor 功能描述:Hi-Brite 200 MHz I2C Compatible RGB Image Enhancer with Video Auto Sizing