- 您现在的位置：买卖IC网 > PDF目录30743 > LM1269NA/NOPB (NATIONAL SEMICONDUCTOR CORP) 3 CHANNEL, VIDEO PREAMPLIFIER, PDIP24 PDF资料下载
参数资料
| 型号： | LM1269NA/NOPB |
| 厂商： | NATIONAL SEMICONDUCTOR CORP |
| 元件分类： | 音频／视频放大 |
| 英文描述： | 3 CHANNEL, VIDEO PREAMPLIFIER, PDIP24 |
| 封装： | PLASTIC, DIP-24 |
| 文件页数： | 4/20页 |
| 文件大小： | 1676K |
| 代理商： | LM1269NA/NOPB |
Functional Description (Continued)
H Flyback: H Flyback is an analog signal input from the
monitor horizontal scan. The “H Blank” section uses this
signal to add horizontal blanking to the output video signal.
This enables the user to blank at the cathodes during hori-
zontal flyback. An optional capacitor and/or resistor to
ground may be needed if noise interferes with the H Flyback
signal.
This feature gives very accurate timing for the horizontal
blanking; however, the flyback signal must be very clean.
There should be no ringing or other noise on the flyback
signal.
R
LIMIT is used to limit the input current into the IC to a typical
value of+1mA during flyback and 100 A during normal
forward scan. For example if an H flyback with a peak of
100V is used, R
LIMIT = 100 k. The internal input impedance
of pin 24 is low to limit the maximum voltage swing at the
input to within the supply rail and ground. The IC interface
circuit creates a digital signal from this waveform, which is
used as the blanking signal at the “Output Buffer Amp”. This
signal adds blanking to the video output signal.
Figure 5
shows the H flyback waveforms and the location of R
LIMIT.A
56 pF capacitor has been added to the H Flyback pin on the
demo board for filtering noise on the H Flyback signal.
H Blank: Some customers may still prefer to use a standard
logic signal for the horizontal blanking. Pin 24 can be
adapted to accept a logic input. It is necessary for the current
flow into pin 24 to reverse for proper operation. Therefore the
logic signal must be AC coupled into pin 24.
Figure 6 shows
the recommended circuit for a logic signal input. The blank
signal must be a positive pulse.
Power Save Mode: There are two modes of power save:
1.
Blanking the video
2.
Turning off most of the power for maximum power sav-
ings.
In the first mode the video is completely blanked. By setting
bit-0 in register 9 to a 1 the video will be completely blanked.
This gives some power savings since there is no beam
current in the monitor. Maximum power saving is obtained in
the second mode. Bits 0 and 1 in register 9 should be set to
a 1. Bit 1 in register 9 turns off the video output stage of the
DS200099-26
FIGURE 4. ABL
DS200099-27
FIGURE 5. H Flyback Input Pulse
DS200099-28
FIGURE 6. Standard Logic H Blank
LM1269
www.national.com
12
相关PDF资料 |
PDF描述 |
|---|---|
| LM1276AAA/NA | 1 CHANNEL, VIDEO PREAMPLIFIER, PDIP28 |
| LM1279AN/NOPB | 3 CHANNEL, VIDEO AMPLIFIER, PDIP20 |
| LM1279N/NOPB | 1 CHANNEL, VIDEO AMPLIFIER, PDIP20 |
| LM136A-2.5MD8 | 1-OUTPUT TWO TERM VOLTAGE REFERENCE, 5 V, UUC |
| LM136A-5.0MW8 | 1-OUTPUT TWO TERM VOLTAGE REFERENCE, 5 V, UUC |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LM126H | 制造商:NSC 制造商全称:National Semiconductor 功能描述:VOLTAGE REGULATORS |
| LM126H/883B | 制造商:Texas Instruments 功能描述:IC,VOLT REGULATOR,FIXED,+-12V,BIPOLAR,CAN,10PIN,METAL |
| LM126H/883C | 制造商:Texas Instruments 功能描述: |
| LM1270 | 制造商:NSC 制造商全称:National Semiconductor 功能描述:Hi-Brite 200 MHz I2C Compatible RGB Image Enhancer with Video Auto Sizing |
| LM1270N | 制造商:NSC 制造商全称:National Semiconductor 功能描述:Hi-Brite 200 MHz I2C Compatible RGB Image Enhancer with Video Auto Sizing |
发布紧急采购，3分钟左右您将得到回复。