- 您现在的位置：买卖IC网 > PDF目录1820 > LM3495MTCX/NOPB (National Semiconductor)IC REG BUCK SYNC ADJ 10A 16TSSOP PDF资料下载
参数资料
| 型号： | LM3495MTCX/NOPB |
| 厂商： | National Semiconductor |
| 文件页数： | 17/36页 |
| 文件大小： | 0K |
| 描述： | IC REG BUCK SYNC ADJ 10A 16TSSOP |
| 标准包装： | 1 |
| 系列： | PowerWise® |
| 类型： | 降压（降压） |
| 输出类型： | 可调式 |
| 输出数： | 1 |
| 输出电压： | 0.6 V ~ 5.5 V |
| 输入电压： | 2.9 V ~ 18 V |
| PWM 型： | 电流模式，混合 |
| 频率 - 开关： | 200kHz ~ 1.5MHz |
| 电流 - 输出： | 10A |
| 同步整流器： | 是 |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 16-TSSOP（0.173"，4.40mm 宽） |
| 包装： | 标准包装 |
| 供应商设备封装： | 16-TSSOP |
| 产品目录页面： | 1300 (CN2011-ZH PDF) |
| 配用： | LM3495EVAL-ND - BOARD EVALUATION LM3495 |
| 其它名称： | LM3495MTCXDKR |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页当前第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页
SNVS410F – FEBRUARY 2006 – REVISED APRIL 2013
UNDER VOLTAGE LOCK-OUT
The 2.6V turn-on threshold on the voltage at VIN has a built in hysteresis of 300 mV. If input voltage drops below
2.3V the chip enters under voltage lock-out (UVLO) mode. UVLO consists of turning off both the top and bottom
FETs and remaining in that condition until input voltage rises above 2.6V.
BOOTSTRAP DIODE SELECTION
Schottky diodes are the preferred choice for the bootstrap circuit because of their low forward voltage drop. For
circuits that will operate at high ambient temperature the Schottky diode datasheet must be read carefully to
ensure that the reverse leakage current at high temperature does not increase enough to deplete the charge on
the bootstrap capacitor while the high-side FET is off. Some Schottky diodes increase their reverse leakage by
as much as 1000x at their upper temperature limit. Fast recovery and PN junction diodes maintain low reverse
leakage even at high ambient temperature. For high ambient temperature operation Schottky diodes with low
leakage across temperature or fast recovery type diodes should be used.
OVER VOLTAGE PROTECTION
The LM3495 will shut down if the output voltage exceeds 125% of the steady state target voltage for longer than
4 μs. The high-side FET is turned off and the low-side FET is turned on. The LM3495 will remain in this condition
until either the VIN pin voltage is cycled to ground, or the COMP/SD pin voltage is pulled to below 0.3V and then
released. Either of these reset mechanisms will cause the device to perform a soft-start.
LOW-SIDE CURRENT LIMIT
The current limit of the LM3495 operates by sensing the current in the low-side FET while the load current, I O ,
circulates through it. The low-side FET drain-to-source voltage, V DS , is compared against the voltage of a fixed,
internal 20 μA current source and a user-selected resistor, R ILIM . The value of R ILIM for a desired current limit
threshold, I CL , can be selected with the following equation:
R ILIM =
I CL x R DSON-LO
20 P A
(5)
R ILIM is connected between the switch node and the ILIM pin. A current limit event is sensed when V DS exceeds
V ILIM . (V ILIM = 20 μA x R ILIM ) . The high-side switch is disabled for the following cycle and the low-side FET is kept
on during this time.
During long duration current limit conditions or a short circuit the output voltage droops. This in turn causes the
COMP/SD pin voltage to rise. If the COMP/SD pin voltage exceeds 2V and a high-side FET on-pulse is skipped,
the LM3495 increments a 4 bit counter. If 16 high-gate pulses are skipped consecutively while COMP/SD stays
above 2V, the LM3495 will enter hiccup mode. The counter is reset when the COMP/SD pin goes below 2V.
During soft-start the cycle skipping function of the low-side current limit is active, but the ability to enter hiccup
mode is disabled.
CURRENT LIMIT SENSE RESISTOR
For applications that require a higher degree of accuracy for the low-side current limit, a dedicated current sense
resistor can be added between ground and the source of the low-side FET. Figure 35 shows the circuit
connection when using a dedicated current limit sensing resistor, R SNS .
Copyright ? 2006–2013, Texas Instruments Incorporated
Product Folder Links: LM3495
17
相关PDF资料 |
PDF描述 |
|---|---|
| LM350T | IC REG LDO ADJ 3A TO220AB |
| LM350T | IC REG LDO ADJ 3A TO220-3 |
| LM3686TLE-AAED/NOPB | IC REG BUCK SYNC .9A TRPL 12USMD |
| LM399AH | IC VREF SHUNT PREC 6.95V TO-46-4 |
| LM4040A25IDBZT | IC VREF SHUNT PREC 2.5V SOT23-3 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LM3497M/NOPB | 制造商:Texas Instruments 功能描述:IC LED DRIVER 制造商:Texas Instruments 功能描述:POWER REGULATOR/CONTROLLER IC |
| LM3497MM/NOPB | 功能描述:板上安装温度传感器 RoHS:否 制造商:Omron Electronics 输出类型:Digital 配置: 准确性:+/- 1.5 C, +/- 3 C 温度阈值: 数字输出 - 总线接口:2-Wire, I2C, SMBus 电源电压-最大:5.5 V 电源电压-最小:4.5 V 最大工作温度:+ 50 C 最小工作温度:0 C 关闭: 安装风格: 封装 / 箱体: 设备功能:Temperature and Humidity Sensor |
| LM3497MMX/NOPB | 功能描述:板上安装温度传感器 RoHS:否 制造商:Omron Electronics 输出类型:Digital 配置: 准确性:+/- 1.5 C, +/- 3 C 温度阈值: 数字输出 - 总线接口:2-Wire, I2C, SMBus 电源电压-最大:5.5 V 电源电压-最小:4.5 V 最大工作温度:+ 50 C 最小工作温度:0 C 关闭: 安装风格: 封装 / 箱体: 设备功能:Temperature and Humidity Sensor |
| LM3497MX/NOPB | 制造商:Texas Instruments 功能描述:IC LED DRIVER 制造商:Texas Instruments 功能描述:POWER REGULATOR/CONTROLLER IC |
| LM349J | 制造商:未知厂家 制造商全称:未知厂家 功能描述:Voltage-Feedback Operational Amplifier |
发布紧急采购，3分钟左右您将得到回复。