- 您现在的位置：买卖IC网 > Datasheet目录988 > LM89EVAL (National Semiconductor)BOARD EVALUATION LM89 Datasheet资料下载
参数资料
| 型号： | LM89EVAL |
| 厂商： | National Semiconductor |
| 文件页数： | 15/32页 |
| 文件大小： | 0K |
| 描述： | BOARD EVALUATION LM89 |
| 标准包装： | 1 |
| 传感器类型： | 温度 |
| 传感范围： | 0°C ~ 125°C |
| 接口： | SMBus（2 线/I²C） |
| 灵敏度： | ±1°C |
| 电源电压： | 3 V ~ 3.6 V |
| 嵌入式： | 否 |
| 已供物品： | 板，CD |
| 已用 IC / 零件： | LM89 |
| 相关产品： | LM89CIM-ND - IC TEMP SENSOR DGTL 8-SOIC LM89CIMX-ND - IC TEMP SENSOR DGTL 8-SOIC LM89CIMM-ND - IC TEMP SENSOR DGTL 8-MSOP LM89CIMMX-ND - IC TEMP SENSOR DGTL 8-MSOP |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页当前第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页
SNIS128C – AUGUST 2002 – REVISED MARCH 2013
SERIAL INTERFACE RESET
In the event that the SMBus Master is RESET while the LM89 is transmitting on the SMBData line, the LM89
must be returned to a known state in the communication protocol. This may be done in one of two ways:
1. When SMBData is LOW, the LM89 SMBus state machine resets to the SMBus idle state if either SMBData
or SMBCLK are held low for more than 35ms (t TIMEOUT ). Note that according to SMBus specification 2.0 all
devices are to timeout when either the SMBCLK or SMBData lines are held low for 25-35ms. Therefore, to
insure a timeout of all devices on the bus the SMBCLK or SMBData lines must be held low for at least 35ms.
2. When SMBData is HIGH, have the master initiate an SMBus start. The LM89 will respond properly to an
SMBus start condition at any point during the communication. After the start the LM89 will expect an SMBus
address byte.
DIGITAL FILTER
In order to suppress erroneous remote temperature readings due to noise, the LM89 incorporates a user-
configured digital filter. The filter is accessed in the FILTER and ALERT CONFIGURE REGISTER at BFh. The
filter can be set according to the following table.
D2
0
0
1
1
D1
0
1
0
1
Filter
No Filter
Level 1
Level 1
Level 2
Level 2 sets maximum filtering.
Figure 12 depicts the filter output in response to a step input and an impulse input. Figure 13 depicts the digital
filter in use in a Pentium 4 processor system. Note that the two curves, with filter and without, have been
purposely offset so that both responses can be clearly seen. Inserting the filter does not induce an offset as
shown.
Figure 11. Filter Output Response to a Step Input
a) Step Response
Figure 12. Filter Output Response to a Step Input
b) Impulse Response
Copyright ? 2002–2013, Texas Instruments Incorporated
Product Folder Links: LM89
15
相关PDF资料 |
PDF描述 |
|---|---|
| LM95241EB | BOARD EVALUATION LM95241 |
| LOB3R005FLFLT | RES METAL .005 OHM 3W 1% AXIAL |
| LP05-1A66-80V | RELAY REED SPST 500MA 5V |
| LP5521TMEV | EVAL BOARD FOR LP5521 |
| LPS0300H1000JB | RESISTOR HEAT SINK 100 OHM 300W |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LM8M.5M.5 | 制造商:Banner Engineering 功能描述:LM8M.5M.5 LOGIC MODULE |
| LM8M64 | 制造商:SHARP 制造商全称:Sharp Electrionic Components 功能描述:Color STN LCD Module |
| LM8M64_07 | 制造商:SHARP 制造商全称:Sharp Electrionic Components 功能描述:Color STN LCD Module |
| LM8V30 | 制造商:SHARP 制造商全称:Sharp Electrionic Components 功能描述:Color STN-LCD Module(Handheld PC) |
| LM8V302 | 制造商:SHARP 制造商全称:Sharp Electrionic Components 功能描述:Color STN-LCD Module(Handheld PC) |
发布紧急采购，3分钟左右您将得到回复。