参数资料
| 型号： | LPC11U13FBD48/201, |
| 厂商： | NXP Semiconductors |
| 文件页数： | 11/72页 |
| 文件大小： | 0K |
| 描述： | IC MCU 32BIT 24K 48LQFP |
| 产品培训模块： | Code Density for LPC11xx |
| 标准包装： | 250 |
| 系列： | LPC11Uxx |
| 核心处理器： | ARM? Cortex?-M0 |
| 芯体尺寸： | 32-位 |
| 速度： | 50MHz |
| 连通性： | I²C，Microwire，智能卡，SPI，SSP，UART/USART，USB |
| 外围设备： | 欠压检测/复位，POR，WDT |
| 输入/输出数： | 40 |
| 程序存储器容量： | 24KB（24K x 8） |
| 程序存储器类型： | 闪存 |
| RAM 容量： | 6K x 8 |
| 电压 - 电源 (Vcc/Vdd)： | 1.8 V ~ 3.6 V |
| 数据转换器： | A/D 8x10b |
| 振荡器型： | 内部 |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 48-LQFP |
| 包装： | 托盘 |
| 其它名称： | 568-8563 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页当前第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页
LPC11U1X
All information provided in this document is subject to legal disclaimers.
NXP Semiconductors N.V. 2014. All rights reserved.
Product data sheet
Rev. 2.2 — 11 March 2014
19 of 72
NXP Semiconductors
LPC11U1x
32-bit ARM Cortex-M0 microcontroller
7.7.1 Features
GPIO pins can be configured as input or output by software.
All GPIO pins default to inputs with interrupt disabled at reset.
Pin registers allow pins to be sensed and set individually.
Up to eight GPIO pins can be selected from all GPIO pins to create an edge- or
level-sensitive GPIO interrupt request.
Port interrupts can be triggered by any pin or pins in each port.
7.8 USB interface
The Universal Serial Bus (USB) is a 4-wire bus that supports communication between a
host and one or more (up to 127) peripherals. The host controller allocates the USB
bandwidth to attached devices through a token-based protocol. The bus supports
hot-plugging and dynamic configuration of the devices. All transactions are initiated by the
host controller.
The LPC11U1x USB interface consists of a full-speed device controller with on-chip PHY
for device functions.
Remark: Configure the LPC11U1x in default power mode with the power profiles before
using the USB (see Section 7.16.5.1). Do not use the USB with the part in performance,
efficiency, or low-power mode.
7.8.1 Full-speed USB device controller
The device controller enables 12 Mbit/s data exchange with a USB Host controller. It
consists of a register interface, serial interface engine, and endpoint buffer memory. The
serial interface engine decodes the USB data stream and writes data to the appropriate
endpoint buffer. The status of a completed USB transfer or error condition is indicated via
status registers. An interrupt is also generated if enabled.
7.8.1.1
Features
Dedicated USB PLL available.
Fully compliant with USB 2.0 specification (full speed).
Supports 10 physical (5 logical) endpoints including one control endpoint.
Single and double buffering supported.
Each non-control endpoint supports bulk, interrupt, or isochronous endpoint types.
Supports wake-up from Deep-sleep mode and Power-down mode on USB activity
and remote wake-up.
Supports SoftConnect.
7.9 USART
The LPC11U1x contains one USART.
The USART includes full modem control, support for synchronous mode, and a smart
card interface. The RS-485/9-bit mode allows both software address detection and
automatic address detection using 9-bit mode.
相关PDF资料 |
PDF描述 |
|---|---|
| LPC11C12FBD48/301, | IC MCU 32BIT 16KB FLASH 48LQFP |
| LPC11E14FBD48/401, | IC MCU 32BIT 32K 48LQFP |
| LPC1226FBD64/301,1 | MCU 32BIT 96K FLASH 8K 64-LQFP |
| P87LPC767BD,512 | IC 80C51 MCU 4K OTP 20-SOIC |
| LPC11U14FHN33/201, | IC MCU 32BIT 32K 33HVQFN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LPC11U14FBD201 | 制造商:PHILIPS 制造商全称:NXP Semiconductors 功能描述:32-bit ARM Cortex-M0 microcontroller; up to 32 kB flash; 6 kB SRAM; USB device; USART |
| LPC11U14FBD48 | 制造商:PHILIPS 制造商全称:NXP Semiconductors 功能描述:Low-cost Cortex-M0 USB solutions with Smart Card interface |
| LPC11U14FBD48.201 | 制造商:PHILIPS 制造商全称:NXP Semiconductors 功能描述:32-bit ARM Cortex-M0 microcontroller; up to 32 kB flash; 6 kB SRAM; USB device; USART |
| LPC11U14FBD48/201 | 制造商:NXP Semiconductors 功能描述:MCU 32BIT 32K FLASH 48LQFP |
| LPC11U14FBD48/201, | 功能描述:ARM微控制器 - MCU 32-bit ARM Cortex-M0 MCU RoHS:否 制造商:STMicroelectronics 核心:ARM Cortex M4F 处理器系列:STM32F373xx 数据总线宽度:32 bit 最大时钟频率:72 MHz 程序存储器大小:256 KB 数据 RAM 大小:32 KB 片上 ADC:Yes 工作电源电压:1.65 V to 3.6 V, 2 V to 3.6 V, 2.2 V to 3.6 V 工作温度范围:- 40 C to + 85 C 封装 / 箱体:LQFP-48 安装风格:SMD/SMT |
发布紧急采购，3分钟左右您将得到回复。