- 您现在的位置：买卖IC网 > PDF目录14046 > LT1073CN8-12 (Linear Technology)IC REG BUCK BST INV 12V .4A 8DIP PDF资料下载
参数资料
| 型号： | LT1073CN8-12 |
| 厂商： | Linear Technology |
| 文件页数： | 8/16页 |
| 文件大小： | 0K |
| 描述： | IC REG BUCK BST INV 12V .4A 8DIP |
| 标准包装： | 50 |
| 类型： | 降压（降压），升压（升压），反相 |
| 输出类型： | 固定 |
| 输出数： | 1 |
| 输出电压： | 12V |
| 输入电压： | 1 V ~ 30 V |
| 频率 - 开关： | 19kHz |
| 电流 - 输出： | 400mA |
| 同步整流器： | 无 |
| 工作温度： | 0°C ~ 70°C |
| 安装类型： | 通孔 |
| 封装/外壳： | 8-DIP（0.300"，7.62mm） |
| 包装： | 管件 |
| 供应商设备封装： | 8-PDIP |
LT1073
APPLICATIO S I FOR ATIO
50mV/DIV
20 μ s/DIV
Figure 3. Aluminum
50mV/DIV
20 μ s/DIV
Figure 4. Tantalum
50mV/DIV
20 μ s/DIV
Figure 5. OS-CON
microampere range, a leaky capacitor will noticeably de-
crease efficiency. In this type application tantalum capaci-
tors are the best choice, with typical leakage currents in the
1 μ A to 5 μ A range.
Diode Selection
Speed, forward drop and leakage current are the three
short-circuit protected since there is a DC path from input
to output.
The usual step-up configuration for the LT1073 is shown
in Figure 6. The LT1073 first pulls SW1 low causing V IN -
V CESAT to appear across L1. A current then builds up in L1.
At the end of the switch ON time the current in L1 is 2 :
main considerations in selecting a catch diode for LT1073
converters. “General-purpose” rectifiers such as the
1N4001 are unsuitable for use in any switching regulator
i PEAK =
V IN
L
t ON
application. Although they are rated at 1A, the switching
time of a 1N4001 is in the 10 μ s to 50 μ s range. At best,
efficiency will be severely compromised when these
diodes are used and at worst, the circuit may not work at
NOTE 2: This simple expression neglects the effect of switch and coil resistance. These are taken
into account in the “Inductor Selection” section.
L1 D1
V IN V OUT
R3*
all. Most LT1073 circuits will be well served by a 1N5818
Schottky diode. The combination of 500mV forward drop
at 1A current, fast turn-on and turn-off time and 4 μ A to
10 μ A leakage current fit nicely with LT1073 requirements.
At peak switch currents of 100mA or less, a 1N4148 signal
diode may be used. This diode has leakage current in the
1nA to 5nA range at 25 ° C and lower cost than a 1N5818.
I LIM V IN
SW1
LT1073
FB
GND
SW2
*= OPTIONAL
R2
R1
+
1073 F06
C1
(You can also use them to get your circuit up and running,
but beware of destroying the diode at 1A switch currents.)
In situations where the load is intermittent and the LT1073
is idling most of the time, battery life can sometimes be
extended by using a silicon diode such as the 1N4933,
which can handle 1A but has leakage current of less than
1 μ A. Efficiency will decrease somewhat compared to a
1N5818 while delivering power, but the lower idle current
may be more important.
Step-Up (Boost Mode) Operation
A step-up DC/DC converter delivers an output voltage
higher than the input voltage. Step-up converters are not
8
Figure 6. Step-Up Mode Hookup.
(Refer to Table 1 for Component Values)
Immediately after switch turn-off, the SW1 voltage pin
starts to rise because current cannot instantaneously stop
flowing in L1. When the voltage reaches V OUT + V D , the
inductor current flows through D1 into C1, increasing
V OUT . This action is repeated as needed by the LT1073 to
keep V FB at the internal reference voltage of 212mV. R1
and R2 set the output voltage according to the formula:
相关PDF资料 |
PDF描述 |
|---|---|
| V24B15C150B | CONVERTER MOD DC/DC 15V 150W |
| LT1073CN8 | IC REG BUCK BST INV ADJ .4A 8DIP |
| GBA40DTKS | CONN EDGECARD 80POS DIP .125 SLD |
| LT1073CN8-5 | IC REG BUCK BST INV 5V 0.4A 8DIP |
| LT1110CN8-5 | IC REG BUCK BOOST 5V 0.4A 8DIP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT1073CN8-12#PBF | 功能描述:IC REG BUCK BST INV 12V .4A 8DIP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.2V，1.5V，1.8V，2.5V 输入电压:2.7 V ~ 20 V PWM 型:- 频率 - 开关:- 电流 - 输出:50mA 同步整流器:是 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:10-TFSOP，10-MSOP（0.118"，3.00mm 宽）裸露焊盘 包装:带卷 (TR) 供应商设备封装:10-MSOP 裸露焊盘 |
| LT1073CN8-5 | 功能描述:IC REG BUCK BST INV 5V 0.4A 8DIP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.2V，1.5V，1.8V，2.5V 输入电压:2.7 V ~ 20 V PWM 型:- 频率 - 开关:- 电流 - 输出:50mA 同步整流器:是 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:10-TFSOP，10-MSOP（0.118"，3.00mm 宽）裸露焊盘 包装:带卷 (TR) 供应商设备封装:10-MSOP 裸露焊盘 |
| LT1073CN85#PBF | 制造商:Linear Technology 功能描述:LT1073CN85#PBF |
| LT1073CN8-5#PBF | 功能描述:IC REG BUCK BST INV 5V 0.4A 8DIP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.2V，1.5V，1.8V，2.5V 输入电压:2.7 V ~ 20 V PWM 型:- 频率 - 开关:- 电流 - 输出:50mA 同步整流器:是 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:10-TFSOP，10-MSOP（0.118"，3.00mm 宽）裸露焊盘 包装:带卷 (TR) 供应商设备封装:10-MSOP 裸露焊盘 |
| LT1073CN85PBF | 制造商:Linear Technology 功能描述:LT1073CN85PBF |
发布紧急采购，3分钟左右您将得到回复。