- 您现在的位置：买卖IC网 > PDF目录4634 > LT1175MPQ#TRPBF (Linear Technology)IC REG LDO NEG ADJ .5A DDPAK-5 PDF资料下载
参数资料
| 型号： | LT1175MPQ#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 13/20页 |
| 文件大小： | 0K |
| 描述： | IC REG LDO NEG ADJ .5A DDPAK-5 |
| 标准包装： | 750 |
| 稳压器拓扑结构： | 负，可调式 |
| 输出电压： | -3.8 V ~ -19.9 V |
| 输入电压： | -4.3 V ~ -20 V |
| 电压 - 压降（标准）： | 0.5V @ 500mA |
| 稳压器数量： | 1 |
| 电流 - 输出： | 500mA |
| 电流 - 限制（最小）： | 可调式 |
| 工作温度： | -55°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | TO-263-6，D²Pak（5 引线+接片），TO-263BA |
| 供应商设备封装： | D2PAK-5 |
| 包装： | 带卷 (TR) |
LT1175
APPLICATIONS INFORMATION
T A
= Maximum ambient temperature
between the input and output of the regulator . Reverse
T MAX = Maximum LT1175 die temperature (125°C for
commercial and industrial grades)
θ JA = LT1175 thermal resistance, junction to ambient
voltages between input and output above 1V will damage
the regulator if large currents are allowed to ?ow. Simply
disconnecting the input source with the output held up
will not cause damage even though the input-to-output
V IN
= Maximum continuous input voltage at maximum
voltage will become slightly reversed.
load current
I LOAD = Maximum load current
Example: LT1175S8 with I LOAD = 200mA, V OUT = 5V,
V IN = 7V, T A = 60°C. Maximum die temperature for the
LT1175S8 is 125°C. Thermal resistance from Table 2 is
found to be 80°C/W.
Die Temperature = 60 + 80 (0.2A)(8 – 5) = 108°C
High Frequency Ripple Rejection
The LT1175 will sometimes be powered from switching
regulators that generate the unregulated or quasi-regulated
input voltage. This voltage will contain high frequency ripple
that must be rejected by the linear regulator. Special care
was taken with the LT1175 to maximize high frequency
ripple rejection, but as with any micropower design,
rejection is strongly affected by ripple frequency. The
( )
Maximum Power Dissipation =
Maximum Continuous
Input Voltage =
(for Thermal Considerations)
125 – 60
80
125 – 60
80 0 . 2
= 0 . 81 W
+ 5 = 9 V
graph in the Typical Performance Characteristics section
shows 60dB rejection at 1kHz, but only 15dB rejection at
100kHz for the 5V part. Photographs in Figures 4a and 4b
show actual output ripple waveforms with square wave
and triwave input ripple.
Output Voltage Reversal
The LT1175 is designed to tolerate an output voltage
C OUT = 4.7μF TANT
reversal of up to 2V. Reversal might occur, for instance,
if the output was shorted to a positive 5V supply. This
would almost surely destroy IC devices connected to the
negative output. Reversal could also occur during start-
up if the positive supply came up ?rst and loads were
connected between the positive and negative supplies.
For these reasons, it is always good design practice to
add a reverse biased diode from each regulator output to
ground to limit output voltage reversal . The diode should
be rated to handle full negative load current for start-up
situations, or the short-circuit current of the positive supply
if supply-to-supply shorts must be tolerated.
Input Voltage Lower Than Output
Linear Technology’s positive low dropout regulators
LT1121 and LT1129, will not draw large currents if the
input voltage is less than the output. These devices use a
lateral PNP power transistor structure that has 40V emitter
base breakdown voltage. The LT1175, however, uses an
NPN power transistor structure that has a parasitic diode
OUTPUT
20mV/DIV
INPUT
RIPPLE
100mV/DIV
OUTPUT
100mV/DIV
INPUT
RIPPLE
100mV/DIV
5μs/DIV
Figure 4a.
2μs/DIV
1175 F04a
1175 F04b
C OUT = 1μF TANT
f = 50kHz
C OUT = 4.7μF TANT
C OUT = 1μF TANT
f = 100kHz
Figure 4b.
1175ff
13
相关PDF资料 |
PDF描述 |
|---|---|
| LT1175MPS8-5#TRPBF | IC REG LDO -5V .5A 8SOIC |
| MIC5305-1.8YD5 TR | IC REG LDO 1.8V .15A TSOT23-5 |
| FMC07DREI-S13 | CONN EDGECARD 14POS .100 EXTEND |
| HBC40DRXI | CONN EDGECARD 80POS DIP .100 SLD |
| RBB95DHRT | CONN CARD EXTEND 190POS .050" |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT1175MPS8#PBF | 功能描述:IC REG LDO NEG ADJ .5A 8SOIC RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 线性 系列:- 标准包装:1 系列:- 稳压器拓扑结构:正，固定式 输出电压:8V 输入电压:10.5 V ~ 23 V 电压 - 压降（标准）:1.7V @ 40mA 稳压器数量:1 电流 - 输出:100mA（最小值） 电流 - 限制（最小）:- 工作温度:0°C ~ 125°C 安装类型:表面贴装 封装/外壳:8-SOIC（0.154"，3.90mm 宽） 供应商设备封装:8-SOIC 包装:剪切带 (CT) 产品目录页面:1075 (CN2011-ZH PDF) 其它名称:296-24390-1 |
| LT1175MPS8#TRPBF | 功能描述:IC REG LDO NEG ADJ .5A 8SOIC RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 线性 系列:- 标准包装:3,000 系列:- 稳压器拓扑结构:正，固定式 输出电压:2.5V 输入电压:2.5 V ~ 5.5 V 电压 - 压降（标准）:- 稳压器数量:1 电流 - 输出:300mA（最小值） 电流 - 限制（最小）:360mA 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 供应商设备封装:TSOT-23-5 包装:带卷 (TR) |
| LT1175MPS8-5#PBF | 功能描述:IC REG LDO -5V .5A 8SOIC RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 线性 系列:- 标准包装:3,000 系列:- 稳压器拓扑结构:正，固定式 输出电压:3V 输入电压:最高 5.5V 电压 - 压降（标准）:0.12V @ 150mA 稳压器数量:1 电流 - 输出:150mA（最小值） 电流 - 限制（最小）:220mA 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 供应商设备封装:TSOT-23-5 包装:带卷 (TR) 其它名称:ADP160AUJZ-3.0-R7TR |
| LT1175MPS8-5#TRPBF | 功能描述:IC REG LDO -5V .5A 8SOIC RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 线性 系列:- 标准包装:3,000 系列:- 稳压器拓扑结构:正，固定式 输出电压:2.5V 输入电压:2.5 V ~ 5.5 V 电压 - 压降（标准）:- 稳压器数量:1 电流 - 输出:300mA（最小值） 电流 - 限制（最小）:360mA 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 供应商设备封装:TSOT-23-5 包装:带卷 (TR) |
| LT1176 | 制造商:LINER 制造商全称:Linear Technology 功能描述:Step-Down Switching Regulator |
发布紧急采购，3分钟左右您将得到回复。