- 您现在的位置：买卖IC网 > PDF目录14028 > LT1578IS8#TR (Linear Technology)IC REG BUCK ADJ 1.5A 8SOIC PDF资料下载
参数资料
| 型号： | LT1578IS8#TR |
| 厂商： | Linear Technology |
| 文件页数： | 13/28页 |
| 文件大小： | 0K |
| 描述： | IC REG BUCK ADJ 1.5A 8SOIC |
| 标准包装： | 2,500 |
| 类型： | 降压（降压） |
| 输出类型： | 可调式 |
| 输出数： | 1 |
| 输出电压： | 可调至 1.21V |
| 输入电压： | 4 V ~ 15 V |
| PWM 型： | 电流模式 |
| 频率 - 开关： | 200kHz |
| 电流 - 输出： | 1.5A |
| 同步整流器： | 无 |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 8-SOIC（0.154"，3.90mm 宽） |
| 包装： | 带卷 (TR) |
| 供应商设备封装： | 8-SOIC |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页当前第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页
LT1578/LT1578-2.5
APPLICATIO N S I N FOR M ATIO N
Peak-to-peak output ripple voltage is the sum of a triwave
created by peak-to-peak ripple current times ESR, and a
square wave created by parasitic inductance (ESL) and
ripple current slew rate. Capacitive reactance is assumed
I D ( AVG ) =
I OUT ( V IN ? V OUT
V IN
)
( )( ) ( )
V RIPPLE = I P-P ESR + ESL Σ
( 5 ) ( 10 ? 5 )
( )
10 30 ? 10 200 ? 10 3 ?
I P-P = = 0 . 42 A
= = 0 . 33 ? 10 6
Σ
30 ? 10 ? 6
V RIPPLE = ( 0 . 42 A )( 0 . 1 ) + ? 10 ? 10 0 . 33 ? 10 6 ?
1 . 8 ( 15 ? 4 ) = 1 . 32 A
( )
to be small compared to ESR or ESL.
dI
dt
Example: with V IN =10V, V OUT = 5V, L = 30 μ H, ESR = 0.1 ? ,
ESL = 10nH:
? ? 6 ? ?
? ? ? ?
dI 10
dt
? 9 ? ?
? ? ? ?
= 0 . 042 + 0 . 003 = 45 mV P-P
This formula will not yield values higher than 1A with
maximum load current of 1.25A unless the ratio of input to
output voltage exceeds 5:1. The only reason to consider a
larger diode is the worst-case condition of a high input
voltage and overloaded (not shorted) output. Under short-
circuit conditions, foldback current limit will reduce diode
current to less than 1A, but if the output is overloaded and
does not fall to less than 1/3 of nominal output voltage,
foldback will not take effect. With the overloaded condi-
tion, output current will increase to a typical value of 1.8A,
determined by peak switch current limit of 2A. With
V IN = 15V, V OUT = 4V (5V overloaded) and I OUT = 1.8A:
I D AVG =
15
This is safe for short periods of time, but it would be
prudent to check with the diode manufacturer if continu-
ous operation under these conditions must be tolerated.
20mV/DIV
V OUT AT
I OUT = 1A
BOOST PIN CONSIDERATIONS
200mA/DIV
20mV/DIV
200mA/DIV
INDUCTOR
CURRENT
AT I OUT = 1A
V OUT AT
I OUT = 50mA
INDUCTOR
CURRENT
For most applications, the boost components are a 0.33 μ F
capacitor and a 1N914 or 1N4148 diode. The anode is
connected to the regulated output voltage and this gener-
ates a voltage across the boost capacitor nearly identical
to the regulated output. In certain applications, the anode
2 μ s/DIV
1578 F03
AT I OUT = 50mA
may instead be connected to the unregulated input volt-
age. This could be necessary if the regulated output
Figure 3. LT1578 Ripple Voltage Waveform
CATCH DIODE
The suggested catch diode (D1) is a 1N5818 Schottky, or
its Motorola equivalent, MBR130. It is rated at 1A average
forward current and 30V reverse voltage. Typical forward
voltage is 0.42V at 1A. The diode conducts current only
during switch off time. Peak reverse voltage is equal to
voltage is very low (< 3V) or if the input voltage is less than
6V. Efficiency is not affected by the capacitor value, but the
capacitor should have an ESR of less than 1 ? to ensure
that it can be recharged fully under the worst-case condi-
tion of minimum input voltage. Almost any type of film or
ceramic capacitor will work fine.
WARNING! Peak voltage on the BOOST pin is the sum of
unregulated input voltage plus the voltage across the
regulator input voltage. Average forward current in normal
operation can be calculated from:
13
相关PDF资料 |
PDF描述 |
|---|---|
| HM79S-125821LFTR13 | SHIELDED DRUM INDUCTORS |
| RCC44DCMD-S288 | CONN EDGECARD 88POS .100 EXTEND |
| HM79S-125681LFTR13 | SHIELDED DRUM INDUCTORS |
| LT1576IS8-5#TRPBF | IC REG BUCK 5V 1.5A 8SOIC |
| EBC60DCMN-S288 | CONN EDGECARD 120POS .100 EXTEND |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT1579 | 制造商:LINER 制造商全称:Linear Technology 功能描述:300mA Dual Input Smart Battery Backup Regulator |
| LT1579-3 | 制造商:LINER 制造商全称:Linear Technology 功能描述:300mA Dual Input Smart Battery Backup Regulator |
| LT1579CGN | 功能描述:IC LDO REG SMART DUAL ADJ 16SSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 电池管理 系列:- 标准包装:2,000 系列:Impedance Track™ 功能:燃料，电量检测计/监控器 电池化学:锂离子（Li-Ion） 电源电压:2.4 V ~ 2.6 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:20-TSSOP（0.173"，4.40mm 宽） 供应商设备封装:20-TSSOP 包装:带卷 (TR) 产品目录页面:1020 (CN2011-ZH PDF) 配用:BQ27350EVM-ND - BQ27350EVM 其它名称:296-21665-2 |
| LT1579CGN#PBF | 功能描述:IC LDO REG SMART DUAL ADJ 16SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 电池管理 系列:- 标准包装:2,000 系列:Impedance Track™ 功能:燃料，电量检测计/监控器 电池化学:锂离子（Li-Ion） 电源电压:2.4 V ~ 2.6 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:20-TSSOP（0.173"，4.40mm 宽） 供应商设备封装:20-TSSOP 包装:带卷 (TR) 产品目录页面:1020 (CN2011-ZH PDF) 配用:BQ27350EVM-ND - BQ27350EVM 其它名称:296-21665-2 |
| LT1579CGN#TR | 功能描述:IC REG LDO SMART DUAL ADJ 16SSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 电池管理 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,500 系列:- 功能:电池监控器 电池化学:碱性，锂离子，镍镉，镍金属氢化物 电源电压:1 V ~ 5.5 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-6 供应商设备封装:SOT-6 包装:带卷 (TR) |
发布紧急采购，3分钟左右您将得到回复。