- 您现在的位置：买卖IC网 > PDF目录15310 > LT1725CGN#TR (Linear Technology)IC REG CTRLR FLYBK ISO CM 16SSOP PDF资料下载
参数资料
| 型号： | LT1725CGN#TR |
| 厂商： | Linear Technology |
| 文件页数： | 6/28页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR FLYBK ISO CM 16SSOP |
| 标准包装： | 2,500 |
| PWM 型： | 电流模式 |
| 输出数： | 1 |
| 频率 - 最大： | 125kHz |
| 占空比： | 90% |
| 电源电压： | 最高 22V |
| 降压： | 无 |
| 升压： | 无 |
| 回扫： | 是 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 是 |
| 工作温度： | 0°C ~ 100°C |
| 封装/外壳： | 16-SSOP（0.154"，3.90mm 宽） |
| 包装： | 带卷 (TR) |
| 相关产品： | 732-2262-6-ND - TRANS FLYBACK LT1725 20.4UH 732-2262-1-ND - TRANS FLYBACK LT1725 20.4UH 732-2262-2-ND - TRANS FLYBACK LT1725 20.4UH |
第1页第2页第3页第4页第5页当前第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页
LT1725
PI FU CTIO S
PGND (Pin 1): The power ground pin carries the GATE
node discharge current. This is typically a current spike of
several hundred mA with a duration of tens of nanosec-
onds. It should be connected directly to a good quality
ground plane.
I SENSE (Pin 2): Pin to measure switch current with exter-
nal sense resistor. The sense resistor should be of a
noninductive construction as high speed performance is
essential. Proper grounding technique is also required to
avoid distortion of the high speed current waveform. A
preset internal limit of nominally 250mV at this pin effects
a switch current limit.
SFST (Pin 3): Pin for optional external capacitor to effect
soft-start function. See Applications Information for details.
R OCMP (Pin 4): Input pin for optional external load compen-
sation resistor. Use of this pin allows nominal compensa-
tion for nonzero output impedance in the power transformer
secondary circuit, including secondary winding impedance,
output Schottky diode impedance and output capacitor
ESR. In less demanding applications, this resistor is not
needed. See Applications Information for more details.
R CMPC (Pin 5): Pin for external filter capacitor for optional
load compensation function. A common 0.1 μ F ceramic
capacitor will suffice for most applications. See Applica-
tions Information for further details.
OSCAP (Pin 6): Pin for external timing capacitor to set
oscillator switching frequency. See Applications Informa-
tion for details.
V C (pin 7): This is the control voltage pin which is the
output of the feedback amplifier and the input of the
current comparator. Frequency compensation of the
overall loop is effected in most cases by placing a capaci-
tor between this node and ground.
FB (Pin 8): Input pin for external “feedback” resistor
divider. The ratio of this divider, times the internal
third winding transformer turns ratio is the primary deter-
minant of the output voltage. The Thevenin equivalent
resistance of the feedback divider should be roughly 3k.
See Applications Information for more details.
3V OUT (Pin 9): Output pin for nominal 3V reference. This
facilitates various user applications. This node is internally
current limited for protection and is intended to drive
either moderate capacitive loads of several hundred pF or
less, or, very large capacitive loads of 0.1 μ F or more. See
Applications Information for more details.
UVLO (Pin 10): This pin allows the use of an optional
external resistor divider to set an undervoltage lockout
based upon V IN (not V CC ) level. (Note: If the V CC voltage is
sufficient to allow the part to start up, but the UVLO pin is
held below its threshold, output switching action will be
disabled, but the part will draw its normal quiescent
current from V CC . This typically causes a benign relaxation
oscillation action on the V CC pin in the conventional
“trickle-charge” bootstrapped configuration.)
The bias current on this pin is a function of the state of the
UVLO comparator; as the threshold is exceeded, the bias
current increases. This creates a hysteresis band equal to
the change in bias current times the Thevenin impedance
of the user’s resistive divider. The user may thereby adjust
the impedance of the UVLO divider to achieve a desired
degree of hysteresis. A 100pF capacitor to ground is
recommended on this pin. See Applications Information
for details.
SGND (Pin 11): The signal ground pin is a clean ground.
The internal reference, oscillator and feedback amplifier
are referred to it. Keep the ground path connection to the
FB pin, OSCAP capacitor and the V C compensation capaci-
tor free of large ground currents.
MINENAB (Pin 12): Pin for external programming resistor
to set minimum enable time. See Applications Information
for details.
bandgap (V BG ) reference, times the effective output-to-
1725fa
6
相关PDF资料 |
PDF描述 |
|---|---|
| UCA2V330MHD1TN | CAP ALUM 33UF 350V 20% RADIAL |
| B41042A3827M | 820UF 10V 10X20 SINGLE END |
| LT3757HMSE#TRPBF | IC REG CTRLR PWM CM 10-MSOP |
| LTC3830-1ES8#TRPBF | IC REG CTRLR BUCK PWM VM 8-SOIC |
| ADM690SQ | IC SUPERVISOR MPU 4.65V WD 8CDIP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT1725CS | 功能描述:IC REG CTRLR FLYBK ISO CM 16SOIC RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LT1725CS#PBF | 功能描述:IC REG CTRLR FLYBK ISO CM 16SOIC RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LT1725CS#TR | 功能描述:IC REG CTRLR FLYBK ISO CM 16SOIC RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LT1725CS#TRPBF | 功能描述:IC REG CTRLR FLYBK ISO CM 16SOIC RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LT1725IGN | 功能描述:IC REG CTRLR FLYBK ISO CM 16SSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
发布紧急采购，3分钟左右您将得到回复。