- 您现在的位置：买卖IC网 > PDF目录13983 > LT1956EGN-5#TRPBF (Linear Technology)IC REG BUCK 5V 1.5A 16SSOP PDF资料下载
参数资料
| 型号： | LT1956EGN-5#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 22/28页 |
| 文件大小： | 0K |
| 描述： | IC REG BUCK 5V 1.5A 16SSOP |
| 标准包装： | 2,500 |
| 类型： | 降压（降压） |
| 输出类型： | 固定 |
| 输出数： | 1 |
| 输出电压： | 5V |
| 输入电压： | 5.5 V ~ 60 V |
| PWM 型： | 电流模式 |
| 频率 - 开关： | 500kHz |
| 电流 - 输出： | 1.5A |
| 同步整流器： | 无 |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 16-SSOP（0.154"，3.90mm 宽） |
| 包装： | 带卷 (TR) |
| 供应商设备封装： | 16-SSOP |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页当前第22页第23页第24页第25页第26页第27页第28页
LT1956/LT1956-5
APPLICATIO S I FOR ATIO
LT1956
80
180
CURRENT MODE
POWER STAGE
SW
OUTPUT
60
GAIN
150
g m = 2mho
ERROR
AMPLIFIER
C FB
R1
40
120
R O
200k
g m =
2000 μ mho
FB
1.22V
R LOAD
+
TANTALUM
ESR
CERAMIC
ESL
20
0
PHASE
90
60
C1
C1
GND
V C
–20
30
R2
R C
C C
C F
–40
10 100
V IN = 12V
1k 10k 100k
FREQUENCY (Hz)
R C = 2.2k
0
1M
1956 F11
1956 F10
V OUT = 5V
I LOAD = 500mA
C OUT = 100 μ F, 10V, 0.1 ?
C C = 22nF
C F = 220pF
Figure 10. Model for Loop Response
oscillations. If needed, an additional capacitor (C F ) can be
added across the R C /C C network from the V C pin to ground
to further suppress V C ripple voltage.
With a tantalum output capacitor, the LT1956 already
includes a resistor (R C ) and filter capacitor (C F ) at the V C
pin (see Figures 10 and 11) to compensate the loop over
the entire V IN range (to allow for stable pulse skipping for
high V IN -to-V OUT ratios ≥ 4). A ceramic output capacitor
can still be used with a simple adjustment to the resistor
R C for stable operation (see Ceramic Capacitors section
for stabilizing LT1956). If additional phase margin is
required, a capacitor (C FB ) can be inserted between the
output and FB pin but care must be taken for high output
voltage applications. Sudden shorts to the output can
create unacceptably large negative transients on the FB
pin.
For V IN -to-V OUT ratios < 4, higher loop bandwidths are
possible by readjusting the frequency compensation com-
ponents at the V C pin.
When checking loop stability, the circuit should be oper-
ated over the application’s full voltage, current and tem-
perature range. Proper loop compensation may be obtained
by empirical methods as described in Application Notes 19
and 76.
Figure 11. Overall Loop Response
CONVERTER WITH BACKUP OUTPUT REGULATOR
In systems with a primary and backup supply, for ex-
ample, a battery powered device with a wall adapter input,
the output of the LT1956 can be held up by the backup
supply with the LT1956 input disconnected. In this condi-
tion, the SW pin will source current into the V IN pin. If the
SHDN pin is held at ground, only the shut down current of
25 μ A will be pulled via the SW pin from the second supply.
With the SHDN pin floating, the LT1956 will consume its
quiescent operating current of 1.5mA. The V IN pin will also
source current to any other components connected to the
input line. If this load is greater than 10mA or the input
could be shorted to ground, a series Schottky diode must
be added, as shown in Figure 12. With these safeguards,
the output can be held at voltages up to the V IN absolute
maximum rating.
BUCK CONVERTER WITH ADJUSTABLE SOFT-START
Large capacitive loads or high input voltages can cause
high input currents at start-up. Figure 13 shows a circuit
that limits the dv/dt of the output at start-up, controlling
the capacitor charge rate. The buck converter is a typical
configuration with the addition of R3, R4, C SS and Q1.
As the output starts to rise, Q1 turns on, regulating switch
1956f
22
相关PDF资料 |
PDF描述 |
|---|---|
| 50MS510MEFCTZ6.3X5 | CAP ALUM 10UF 50V 20% RADIAL |
| LT1956EGN#TRPBF | IC REG BUCK ADJ 1.5A 16SSOP |
| 25MS522MEFCT56.3X5 | CAP ALUM 22UF 25V 20% RADIAL |
| MAX6718AUKWGD3+T | IC SUPERVISOR MPU SOT23-5 |
| LT3493IDCB#TRPBF | IC REG BUCK ADJ 1.2A 6DFN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT1956EGNPBF | 制造商:Linear Technology 功能描述:DC-DC Converter Step-Down 5.5-60V SSOP16 |
| LT1956IFE | 功能描述:IC REG BUCK ADJ 1.5A 16TSSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 设计资源:Design Support Tool 标准包装:1 系列:- 类型:升压（升压） 输出类型:固定 输出数:1 输出电压:3V 输入电压:0.75 V ~ 2 V PWM 型:- 频率 - 开关:- 电流 - 输出:100mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 包装:剪切带 (CT) 供应商设备封装:TSOT-23-5 其它名称:AS1323-BTTT-30CT |
| LT1956IFE#PBF | 功能描述:IC REG BUCK ADJ 1.5A 16TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 设计资源:Design Support Tool 标准包装:1 系列:- 类型:升压（升压） 输出类型:固定 输出数:1 输出电压:3V 输入电压:0.75 V ~ 2 V PWM 型:- 频率 - 开关:- 电流 - 输出:100mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 包装:剪切带 (CT) 供应商设备封装:TSOT-23-5 其它名称:AS1323-BTTT-30CT |
| LT1956IFE#TR | 功能描述:IC REG BUCK ADJ 1.5A 16TSSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 设计资源:Design Support Tool 标准包装:1 系列:- 类型:升压（升压） 输出类型:固定 输出数:1 输出电压:3V 输入电压:0.75 V ~ 2 V PWM 型:- 频率 - 开关:- 电流 - 输出:100mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 包装:剪切带 (CT) 供应商设备封装:TSOT-23-5 其它名称:AS1323-BTTT-30CT |
| LT1956IFE#TRPBF | 功能描述:IC REG BUCK ADJ 1.5A 16TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 设计资源:Design Support Tool 标准包装:1 系列:- 类型:升压（升压） 输出类型:固定 输出数:1 输出电压:3V 输入电压:0.75 V ~ 2 V PWM 型:- 频率 - 开关:- 电流 - 输出:100mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 包装:剪切带 (CT) 供应商设备封装:TSOT-23-5 其它名称:AS1323-BTTT-30CT |
发布紧急采购，3分钟左右您将得到回复。