参数资料
| 型号： | LT1970IFE#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 14/26页 |
| 文件大小： | 0K |
| 描述： | IC OP AMP 500MA ADJ 20-TSSOP |
| 标准包装： | 2,500 |
| 放大器类型： | 通用 |
| 电路数： | 1 |
| 转换速率： | 1.6 V/µs |
| 增益带宽积： | 3.6MHz |
| 电流 - 输入偏压： | 160nA |
| 电压 - 输入偏移： | 200µV |
| 电流 - 电源： | 7mA |
| 电流 - 输出 / 通道： | 800mA |
| 电压 - 电源，单路/双路(±)： | 5 V ~ 36 V，±2.5 V ~ 18 V |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 20-TSSOP（0.173"，4.40mm 宽）裸露焊盘 |
| 供应商设备封装： | 20-TSSOP-EP |
| 包装： | 带卷 (TR) |
LT1970
21
1970fc
APPLICATIONS INFORMATION
range all the way to 0V, an LTC1046 charge pump inverter
is used to develop a –5V supply. This produces a negative
rail for the LT1970 which has to sink only the quiescent
current of the amplier, typically 7mA.
Using a second LT1970, a 0V to ±12V dual tracking power
supply is shown in Figure 12. The midpoint of two 10k
resistors connected between the + and – outputs is held
at 0V by the LT1881 dual op amp servo feedback loop. To
maintain 0V, both outputs must be equal and opposite in
polarity, thus they track each other. If one output reaches
current limit and drops in voltage, the other output fol-
lows to maintain a symmetrical + and – voltage across a
common load. Again, the output current limit is less than
the full capability of the LT1970 due to thermal reasons.
Separate current limit indicators are used on each LT1970
because one output only sources current and the other
only sinks current. Both devices can share the same
thermal shutdown indicator, as the output ags can be
OR’ed together.
Another simple linear power amplier circuit is shown in
Figure 13. This uses the LT1970 as a linear driver of a DC
motor with speed control. The ability to source and sink
the same amount of output current provides for bidirec-
tional rotation of the motor. Speed control is managed by
sensing the output of a tachometer built on to the motor.
A typical feedback signal of 3V/1000rpm is compared
with the desired speed-set input voltage. Because the
LT1970 is unity-gain stable, it can be congured as an
integrator to force whatever voltage across the motor as
necessary to match the feedback speed signal with the
set input signal.
Additionally, the current limit of the amplier can be ad-
justed to control the torque and stall current of the motor.
For reliability, a feedback scheme similar to that shown in
Figure 4 can be used. Assuming that a stalled rotor will
generate a current limit condition, the stall current limit
can be signicantly reduced to prevent excessive power
dissipation in the motor windings.
Figure 13. Simple Bidirectional DC Motor Speed Controller
VCSRC
COMMON
R4
49.9k
15V
–15V
REVERSE
FORWARD
R2
10k
VEE
VCSNK
V–
FILTER
V+
15V
EN
VCC
ISNK
ISRC
SENSE–
SENSE+
TSD
OUT
+IN
LT1970
–15V
–IN
RS
1Ω
12V DC
MOTOR
TACH
FEEDBACK
3V/1000rpm
GND
1970 F13
C1
1μF
R5
49.9k
R3
1.2k
R1
1.2k
OV TO 5V
TORQUE/STALL
CURRENT CONTROL
相关PDF资料 |
PDF描述 |
|---|---|
| LT1990AHS8#TRPBF | IC AMP DIFF +/-250V MCRPWR 8SOIC |
| LT1993CUD-10#TRPBF | IC DIFF AMP/ADC DRVR 16-QFN |
| LT1993CUD-2#PBF | IC DIFF AMP/ADC DRVR 16-QFN |
| LT1993CUD-4#TRPBF | IC DIFF AMP/ADC DRVR 16-QFN |
| LT1994MPDD#TRPBF | IC DIFF AMP/DRIVER LN 8-MSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT1976 | 制造商:LINER 制造商全称:Linear Technology 功能描述:Monolithic Dual Tracking 3A Step-Down Switching |
| LT1976B | 制造商:LINER 制造商全称:Linear Technology 功能描述:High Voltage 1.5A, 200kHz Step-Down Switching Regulator with 100μA Quiescent Current |
| LT1976BEFE | 制造商:Linear Technology 功能描述:Conv DC-DC Single Step Down 2.4V to 60V 16-Pin TSSOP EP |
| LT1976BEFE#PBF | 功能描述:IC REG BUCK ADJ 1.5A 16TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.2V，1.5V，1.8V，2.5V 输入电压:2.7 V ~ 20 V PWM 型:- 频率 - 开关:- 电流 - 输出:50mA 同步整流器:是 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:10-TFSOP，10-MSOP（0.118"，3.00mm 宽）裸露焊盘 包装:带卷 (TR) 供应商设备封装:10-MSOP 裸露焊盘 |
| LT1976BEFE#TRPBF | 功能描述:IC REG BUCK ADJ 1.5A 16TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.2V，1.5V，1.8V，2.5V 输入电压:2.7 V ~ 20 V PWM 型:- 频率 - 开关:- 电流 - 输出:50mA 同步整流器:是 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:10-TFSOP，10-MSOP（0.118"，3.00mm 宽）裸露焊盘 包装:带卷 (TR) 供应商设备封装:10-MSOP 裸露焊盘 |
发布紧急采购，3分钟左右您将得到回复。