参数资料
| 型号： | LT1970IFE#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 15/26页 |
| 文件大小： | 0K |
| 描述： | IC OP AMP 500MA ADJ 20-TSSOP |
| 标准包装： | 2,500 |
| 放大器类型： | 通用 |
| 电路数： | 1 |
| 转换速率： | 1.6 V/µs |
| 增益带宽积： | 3.6MHz |
| 电流 - 输入偏压： | 160nA |
| 电压 - 输入偏移： | 200µV |
| 电流 - 电源： | 7mA |
| 电流 - 输出 / 通道： | 800mA |
| 电压 - 电源，单路/双路(±)： | 5 V ~ 36 V，±2.5 V ~ 18 V |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 20-TSSOP（0.173"，4.40mm 宽）裸露焊盘 |
| 供应商设备封装： | 20-TSSOP-EP |
| 包装： | 带卷 (TR) |
LT1970
22
1970fc
APPLICATIONS INFORMATION
For motor speed control without using a tachometer, the
circuit in Figure 14 shows an approach. Using the en-
able feature of the LT1970, the drive to the motor can be
removed periodically. With no drive applied, the spinning
motor presents a back EMF voltage proportional to its
rotational speed. The LT1782 is a tiny rail-to-rail amplier
with a shutdown pin. The amplier is enabled during this
interval to sample the back EMF voltage across the motor.
This voltage is then buffered by one-half of an LT1638 dual
op amp and used to provide the feedback to the LT1970
integrator. When re-enabled the LT1970 will adjust the drive
to the motor until the speed feedback voltage, compared
to the speed-set input voltage, settles the output to a xed
value. A 0V to 5V signal for the motor speed input controls
both rotational speed and direction.
The other half of the LT1638 is used as a simple pulse
oscillator to control the periodic sampling of the motor
back EMF.
Figure 15 shows how easy it is to boost the output current
of the LT1970. This ±5A power stage uses complementary
external N- and P-channel MOSFETs to provide the ad-
ditional current. The output stage power supply inputs,
V+ and V–, are used to provide gate drive as needed. With
higher output currents, the sense resistor RCS, is reduced
in value to maintain the same easy current limit control.
This Class B power stage is intended for DC and low
frequency, <1kHz, applications as crossover distortion
becomes evident at higher frequencies.
Figure 15 shows some optional resistor dividers between
the output connections and the current sense inputs. They
are required only if the load of this power stage is removed
or at a very low current level. Large power devices with
no load on them can saturate and pull the output voltage
very close to the power supply rails. The current sense
ampliers operate properly with input voltages at least
1V away from the VCC and VEE supply rails. In boosted
current applications, it may be necessary to attenuate the
maximum output voltage levels by 1V before connecting
to the sense input pins. This only slightly deceases the
current limit thresholds.
相关PDF资料 |
PDF描述 |
|---|---|
| LT1990AHS8#TRPBF | IC AMP DIFF +/-250V MCRPWR 8SOIC |
| LT1993CUD-10#TRPBF | IC DIFF AMP/ADC DRVR 16-QFN |
| LT1993CUD-2#PBF | IC DIFF AMP/ADC DRVR 16-QFN |
| LT1993CUD-4#TRPBF | IC DIFF AMP/ADC DRVR 16-QFN |
| LT1994MPDD#TRPBF | IC DIFF AMP/DRIVER LN 8-MSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT1976 | 制造商:LINER 制造商全称:Linear Technology 功能描述:Monolithic Dual Tracking 3A Step-Down Switching |
| LT1976B | 制造商:LINER 制造商全称:Linear Technology 功能描述:High Voltage 1.5A, 200kHz Step-Down Switching Regulator with 100μA Quiescent Current |
| LT1976BEFE | 制造商:Linear Technology 功能描述:Conv DC-DC Single Step Down 2.4V to 60V 16-Pin TSSOP EP |
| LT1976BEFE#PBF | 功能描述:IC REG BUCK ADJ 1.5A 16TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.2V，1.5V，1.8V，2.5V 输入电压:2.7 V ~ 20 V PWM 型:- 频率 - 开关:- 电流 - 输出:50mA 同步整流器:是 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:10-TFSOP，10-MSOP（0.118"，3.00mm 宽）裸露焊盘 包装:带卷 (TR) 供应商设备封装:10-MSOP 裸露焊盘 |
| LT1976BEFE#TRPBF | 功能描述:IC REG BUCK ADJ 1.5A 16TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.2V，1.5V，1.8V，2.5V 输入电压:2.7 V ~ 20 V PWM 型:- 频率 - 开关:- 电流 - 输出:50mA 同步整流器:是 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:10-TFSOP，10-MSOP（0.118"，3.00mm 宽）裸露焊盘 包装:带卷 (TR) 供应商设备封装:10-MSOP 裸露焊盘 |
发布紧急采购，3分钟左右您将得到回复。