参数资料
型号: LT3071EUFD#PBF
厂商: Linear Technology
文件页数: 14/28页
文件大小: 0K
描述: IC REG LDO ADJ 5A 28QFN
产品培训模块: LT3071- LDO Regulator for High Performance Digital ICs
标准包装: 73
稳压器拓扑结构: 正,可调式
输出电压: 0.8 V ~ 1.8 V
输入电压: 0.95 V ~ 3 V
电压 - 压降(标准): 0.085V @ 5A
稳压器数量: 1
电流 - 输出: 5A
电流 - 限制(最小): 5.1A
工作温度: -40°C ~ 125°C
安装类型: 表面贴装
封装/外壳: 28-WFQFN 裸露焊盘
供应商设备封装: 28-QFN(4x5)
包装: 管件
LT3071
APPLICATIONS INFORMATION
Introduction
Current generation FPGA and ASIC processors place
stringent demands on the power supplies that power the
core, I/O and transceiver channels. These microprocessors
may cycle load current from near zero to amps in tens of
nanoseconds. Output voltage specifications, especially in
the 1V range, require tight tolerances including transient
response as part of the requirement. Some ASIC processors
require only a single output voltage from which the core
and I/O circuitry operate. Some high performance FPGA
processors require separate power supply voltages for the
processor core, the I/O, and the transceivers. Often, these
supply voltages must be low noise and high bandwidth
to achieve the lowest bit-error rates. These requirements
mandate the need for very accurate, low noise, high cur-
rent, very high speed regulator circuits that operate at low
input and output voltages.
The LT3071 is a low voltage, UltraFast transient response
linear regulator. The device supplies up to 5A of output
current with a typical dropout voltage of 85mV. A 0.01μF
reference bypass capacitor decreases output voltage noise
to 25μV RMS (BW = 10Hz to 100kHz). The LT3071’s high
bandwidth provides UltraFast transient response using low
ESR ceramic output capacitors (15μF minimum), saving
bulk capacitance, PCB area and cost.
The LT3071’s features permit state-of-the-art linear regula-
tor performance. The LT3071 is ideal for high performance
FPGAs, microprocessors, sensitive communication sup-
plies, and high current logic applications that also operate
over low input and output voltages.
Output voltage for the LT3071 is digitally selectable in
50mV increments over a 0.8V to 1.8V range. An analog
margining function allows the user to adjust system output
voltage over a continuous ±10% range.
The LT3071 provides an output current monitor that
typically sources a current of I OUT /2500 or 400μA per
amp of I OUT at its I MON pin. Terminating the I MON pin to
GND with a resistor produces a voltage proportional to
output current. This permits a user to measure system
performance such as output power or if output current
exceeds or falls below some threshold.
The IC incorporates a unique tracking function, which if
enabled by the user, controls an upsteam regulator power-
ing the LT3071’s input (see Figure 8). This tracking function
drives the buck regulator to maintain the LT3071’s input
voltage to V OUT + 300mV. This input-to-output voltage
control allows the user to change the regulator output
voltage, and have the switching regulator powering the
LT3071’s input to track to the optimum input voltage with
no component changes.
This combines the efficiency of a switching regulator
with superior linear regulator response. It also permits
thermal management of the system even with a maximum
5A output load.
LT3071 internal protection includes input undervoltage
lockout (UVLO), reverse-current protection, precision cur-
rent limiting with power foldback and thermal shutdown.
The LT3071 regulator is available in a thermally enhanced
28-lead, 4mm × 5mm QFN package.
The LT3071’s architecture drives an internal N-channel
power MOSFET as a source follower. This configuration
permits a user to obtain an extremely low dropout, Ultra-
Fast transient response regulator with excellent high fre-
quency PSRR performance. The LT3071 achieves superior
regulator bandwidth and transient load performance by
eliminating expensive bulk tantalum or electrolytic capaci-
tors in the most modern and demanding microprocessor
applications. Users realize significant cost savings as all
additional bulk capacitance is removed. The additional
savings of insertion cost, purchasing/inventory cost and
board space are readily apparent. Precision incremental
output voltage control accommodates legacy and future
microprocessor power supply voltages.
Output capacitor networks simplify to direct parallel com-
binations of ceramic capacitors. Often, the high frequency
ceramic decoupling capacitors required by these various
3071fb
14
For more information www.linear.com/3071
相关PDF资料
PDF描述
VI-J2P-EZ-B1 CONVERTER MOD DC/DC 13.8V 25W
VI-J2N-EZ-B1 CONVERTER MOD DC/DC 18.5V 25W
MAX708SESA+ IC SUPERVISOR MPU 8-SOIC
LT3050MPMSE-3.3#PBF IC REG LDO 3.3V .1A 12-MSOP
VI-J2M-EZ-B1 CONVERTER MOD DC/DC 10V 25W
相关代理商/技术参数
参数描述
LT3071EUFD-TR 制造商:LINER 制造商全称:Linear Technology 功能描述:5A, Low Noise, Programmable Output, 85mV Dropout Linear Regulator with Analog Margining
LT3071EUFD-TRPBF 制造商:LINER 制造商全称:Linear Technology 功能描述:5A, Low Noise, Programmable Output, 85mV Dropout Linear Regulator with Analog Margining
LT3071IUFD 制造商:LINER 制造商全称:Linear Technology 功能描述:5A, Low Noise, Programmable Output, 85mV Dropout Linear Regulator with Analog Margining
LT3071IUFD#PBF 功能描述:IC REG LDO ADJ 5A 28QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 线性 系列:- 标准包装:3,000 系列:- 稳压器拓扑结构:正,固定式 输出电压:2.5V 输入电压:2.5 V ~ 5.5 V 电压 - 压降(标准):- 稳压器数量:1 电流 - 输出:300mA(最小值) 电流 - 限制(最小):360mA 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型,TSOT-23-5 供应商设备封装:TSOT-23-5 包装:带卷 (TR)
LT3071IUFD#TRPBF 功能描述:IC REG LDO ADJ 5A 28QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 线性 系列:- 标准包装:3,000 系列:- 稳压器拓扑结构:正,固定式 输出电压:2.5V 输入电压:2.5 V ~ 5.5 V 电压 - 压降(标准):- 稳压器数量:1 电流 - 输出:300mA(最小值) 电流 - 限制(最小):360mA 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型,TSOT-23-5 供应商设备封装:TSOT-23-5 包装:带卷 (TR)