参数资料
| 型号： | LT3510IFE#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 18/30页 |
| 文件大小： | 0K |
| 描述： | IC REG BUCK ADJ 2A DL 20TSSOP |
| 标准包装： | 2,500 |
| 类型： | 降压（降压） |
| 输出类型： | 可调式 |
| 输出数： | 2 |
| 输出电压： | 0.8 V ~ 23.8 V |
| 输入电压： | 3.1 V ~ 25 V |
| PWM 型： | 电流模式 |
| 频率 - 开关： | 250kHz ~ 1.5MHz |
| 电流 - 输出： | 2A |
| 同步整流器： | 无 |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 20-TSSOP（0.173"，4.40mm 宽）裸露焊盘 |
| 包装： | 带卷 (TR) |
| 供应商设备封装： | 20-TSSOP-EP |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页当前第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页
LT3510
APPLICATIONS INFORMATION
D2
V IN
V IN
BST
SW
C3
D2
V IN
V IN
BST
SW
C3
LT3510
IND
LT3510
IND
V OUT
V OUT
V OUT
V OUT < 3V
V BST – V SW = V OUT
GND
V BST – V SW = V IN
GND
V BST(MAX) = V IN + V OUT
D2
(5a)
V BST(MAX) = 2 ??V IN
D2
(5b)
V X = LOWEST V IN
OR V OUT > 3V
BST
C3
V X > V IN + 3V
BST
V IN
V IN
SW
V IN
V IN
SW
LT3510
IND
LT3510
IND
V OUT
V OUT < 3V
V OUT
V OUT < 3V
V BST – V SW = V X
V BST(MAX) = V IN + V X
GND
V BST – V SW = V X
V BST(MAX) = V X
GND
3510 F05
V X(MIN) = 3V
(5c)
V X(MIN) = V IN + 3V
Figure 5. BST Pin Considerations
(5d)
input and output voltages, and on the arrangement of the
boost circuit. The Typical Performance Characteristics
section shows plots of the minimum load current to start
and to run as a function of input voltage for 3.3V and 5V
outputs. In many cases the discharged output capacitor
will present a load to the switcher which will allow it to
start. The plots show the worst-case situation where V IN is
ramping very slowly. Use a Schottky diode for the lowest
start-up voltage.
Frequency Compensation
The LT3510 uses current mode control to regulate the
output. This simpli?es loop compensation. In particular, the
LT3510 does not require the ESR of the output capacitor
for stability so you are free to use ceramic capacitors to
achieve low output ripple and small circuit size.
Frequency compensation is provided by the components
tied to the V C pin. Generally a capacitor and a resistor in
series to ground determine loop gain. In addition, there
is a lower value capacitor in parallel. This capacitor is not
part of the loop compensation but is used to ?lter noise
at the switching frequency.
Loop compensation determines the stability and transient
performance. Designing the compensation network is a bit
complicated and the best values depend on the application
and in particular the type of output capacitor. A practical
approach is to start with one of the circuits in this data
sheet that is similar to your application and tune the com-
pensation network to optimize the performance. Stability
should then be checked across all operating conditions,
including load current, input voltage and temperature.
The LT1375 data sheet contains a more thorough discus-
sion of loop compensation and describes how to test the
stability using a transient load.
Figure 6 shows an equivalent circuit for the LT3510 control
loop. The error amp is a transconductance ampli?er with
?nite output impedance. The power section, consisting of
the modulator, power switch and inductor, is modeled as
a transconductance ampli?er generating an output cur-
rent proportional to the voltage at the V C pin. Note that
3510fe
18
相关PDF资料 |
PDF描述 |
|---|---|
| LT3511MPMS#PBF | IC REG FLYBK ISO ADJ .24A 16MSOP |
| LT3512MPMS#TRPBF | IC REG FLYBK ISO ADJ .42A 16MSOP |
| LT3513IUHF#PBF | IC REG 5-OUT FOR TFT-LCD 38QFN |
| LT3571IUD#TRPBF | IC REG BOOST ADJ 0.47A 16QFN |
| LT3573IMSE#TRPBF | IC REG FLYBACK ISO ADJ 16MSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT3511 | 制造商:LINER 制造商全称:Linear Technology 功能描述:Monolithic High Voltage Isolated Flyback Converter No External Start-Up Resistor |
| LT3511EMS#PBF | 功能描述:IC REG FLYBACK ISOLATD 16-MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:250 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.2V 输入电压:2.05 V ~ 6 V PWM 型:电压模式 频率 - 开关:2MHz 电流 - 输出:500mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:6-UFDFN 包装:带卷 (TR) 供应商设备封装:6-SON（1.45x1） 产品目录页面:1032 (CN2011-ZH PDF) 其它名称:296-25628-2 |
| LT3511EMS#TRPBF | 功能描述:IC REG FLYBK ISO ADJ .24A 16MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.2V，1.5V，1.8V，2.5V 输入电压:2.7 V ~ 20 V PWM 型:- 频率 - 开关:- 电流 - 输出:50mA 同步整流器:是 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:10-TFSOP，10-MSOP（0.118"，3.00mm 宽）裸露焊盘 包装:带卷 (TR) 供应商设备封装:10-MSOP 裸露焊盘 |
| LT3511HMS#PBF | 功能描述:IC REG FLYBK ISO ADJ .24A 16MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 设计资源:Design Support Tool 标准包装:1 系列:- 类型:升压（升压） 输出类型:固定 输出数:1 输出电压:3V 输入电压:0.75 V ~ 2 V PWM 型:- 频率 - 开关:- 电流 - 输出:100mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 包装:剪切带 (CT) 供应商设备封装:TSOT-23-5 其它名称:AS1323-BTTT-30CT |
| LT3511HMS#TRPBF | 功能描述:IC REG FLYBK ISO ADJ .24A 16MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 设计资源:Design Support Tool 标准包装:1 系列:- 类型:升压（升压） 输出类型:固定 输出数:1 输出电压:3V 输入电压:0.75 V ~ 2 V PWM 型:- 频率 - 开关:- 电流 - 输出:100mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 包装:剪切带 (CT) 供应商设备封装:TSOT-23-5 其它名称:AS1323-BTTT-30CT |
发布紧急采购，3分钟左右您将得到回复。