- 您现在的位置：买卖IC网 > PDF目录1825 > LT3574IMS#TRPBF (Linear Technology)IC REG FLYBK ISO ADJ .65A 16MSOP PDF资料下载
参数资料
| 型号： | LT3574IMS#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 5/24页 |
| 文件大小： | 0K |
| 描述： | IC REG FLYBK ISO ADJ .65A 16MSOP |
| 标准包装： | 2,500 |
| 类型： | 回扫，隔离 |
| 输出类型： | 可调式 |
| 输出数： | 1 |
| 输出电压： | 可调至 60V |
| 输入电压： | 3 V ~ 40 V |
| PWM 型： | 电流模式，混合 |
| 频率 - 开关： | 40kHz ~ 1MHz |
| 电流 - 输出： | 650mA |
| 同步整流器： | 无 |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 16-TFSOP（0.118"，3.00mm 宽） |
| 包装： | 带卷 (TR) |
| 供应商设备封装： | 16-MSOP |
| 相关产品： | 732-2669-2-ND - TRANS FLYBACK LT3748 20UH SMD 732-2669-6-ND - TRANS FLYBACK LT3748 20UH SMD 732-2668-6-ND - TRANS FLYBACK LT3748 14UH SMD 732-2667-6-ND - TRANS FLYBACK LT3748 500UH SMD 732-2666-6-ND - TRANS FLYBACK LT3748 12UH SMD 732-2665-6-ND - TRANS FLYBACK LT3748 12UH SMD 732-2664-6-ND - TRANS FLYBACK LT3748 15UH SMD 732-2663-6-ND - TRANS FLYBACK LT3748 15UH SMD 732-2662-6-ND - TRANS FLYBACK LT3748 8UH SMD 732-2661-6-ND - TRANS FLYBACK LT3748 8UH SMD 更多... |
LT3574
PIN FUNCTIONS
BIAS : Bias Voltage. This pin supplies current to the switch
driver and internal circuitry of the LT3574. This pin must
be locally bypassed with a capacitor. This pin may also be
connected to V IN if a third winding is not used and if V IN
≤ 15V. If a third winding is used, the BIAS voltage should
be lower than the input voltage for proper operation.
GND: Ground.
R FB : Input Pin for External Feedback Resistor. This pin is
connected to the transformer primary (V SW ). The ratio
of this resistor to the R REF resistor, times the internal
bandgap reference, determines the output voltage (plus
the effect of any non-unity transformer turns ratio). The
average current through this resistor during the flyback
period should be approximately 200μA. For nonisolated
applications, this pin should be connected to V IN .
R ILIM : Maximum Current Limit Adjust Pin. A resistor
should be tied to this pin to ground to set the current
limit. Use a 10k resistor for the full current capabilities
of the switch.
R REF : Input Pin for External Ground-Referred Reference
Resistor. This resistor should be in the range of 6k, but
for convenience, need not be precisely this value. For
nonisolated applications, a traditional resistor voltage
divider may be connected to this pin.
SS : Soft-Start Pin. Place a soft-start capacitor here to
limit start-up inrush current and output voltage ramp
rate. Switching starts when the voltage at this pin reaches
~0.7V.
SW : Collector Node of the Output Switch. This pin has
large currents flowing through it. Keep the traces to the
switching components as short as possible to minimize
electromagnetic radiation and voltage spikes.
T C : Output Voltage Temperature Compensation. Connect
a resistor to ground to produce a current proportional to
absolute temperature to be sourced into the R REF node.
I TC = 0.55V/R TC .
TEST: This pin is used for testing purposes only and must
be connected to ground for the part to operate properly.
VC : Compensation Pin for Internal Error Amplifier. Connect
a series RC from this pin to ground to compensate the
switching regulator. A 100pF capacitor in parallel helps
eliminate noise.
V IN : Input Voltage. This pin supplies current to the internal
start-up circuitry and as a reference voltage for the DCM
comparator and feedback circuitry. This pin must be locally
bypassed with a capacitor.
SHDN /UVLO : Shutdown/Undervoltage Lockout. A resistor
divider connected to V IN is tied to this pin to program the
minimum input voltage at which the LT3574 will operate.
At a voltage below ~0.7V, the part draws no quiescent
current. When below 1.22V and above ~0.7V, the part will
draw 10μA of current, but internal circuitry will remain
off. Above 1.22V, the internal circuitry will start and a 7μA
current will be fed into the SS pin. When this pin falls
below 1.22V, 2.5μA will be pulled from the pin to provide
programmable hysteresis for UVLO.
3574f
相关PDF资料 |
PDF描述 |
|---|---|
| LT3575IFE#TRPBF | IC REG FLYBACK ISO ADJ 16TSSOP |
| LT3579EUFD-1#TRPBF | IC REG MULTI CONFIG SYNC 20QFN |
| LT3580MPMS8E#TRPBF | IC REG BOOST INV SEPIC 2A 8MSOP |
| LT3581IMSE#TRPBF | IC REG MULTI CONFIG ADJ 16MSOP |
| LT3582EUD-5#TRPBF | IC REG BOOST INV +/-5V DL 16QFN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT3575 | 制造商:LINER 制造商全称:Linear Technology 功能描述:Monolithic High Voltage Isolated Flyback Converter No External Start-Up Resistor |
| LT3575EFE#PBF | 功能描述:IC REG FLYBACK ISO ADJ 16TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:250 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.2V 输入电压:2.05 V ~ 6 V PWM 型:电压模式 频率 - 开关:2MHz 电流 - 输出:500mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:6-UFDFN 包装:带卷 (TR) 供应商设备封装:6-SON（1.45x1） 产品目录页面:1032 (CN2011-ZH PDF) 其它名称:296-25628-2 |
| LT3575EFE#TRPBF | 功能描述:IC REG FLYBACK ISO ADJ 16TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 设计资源:Design Support Tool 标准包装:1 系列:- 类型:升压（升压） 输出类型:固定 输出数:1 输出电压:3V 输入电压:0.75 V ~ 2 V PWM 型:- 频率 - 开关:- 电流 - 输出:100mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 包装:剪切带 (CT) 供应商设备封装:TSOT-23-5 其它名称:AS1323-BTTT-30CT |
| LT3575EFEPBF | 制造商:Linear Technology 功能描述:DC-DC Converter Step-Up/Down 40V TSSOP16 |
| LT3575IFE#PBF | 功能描述:IC REG FLYBACK ISO ADJ 16TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:250 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.2V 输入电压:2.05 V ~ 6 V PWM 型:电压模式 频率 - 开关:2MHz 电流 - 输出:500mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:6-UFDFN 包装:带卷 (TR) 供应商设备封装:6-SON（1.45x1） 产品目录页面:1032 (CN2011-ZH PDF) 其它名称:296-25628-2 |
发布紧急采购，3分钟左右您将得到回复。