- 您现在的位置：买卖IC网 > PDF目录14807 > LT3575EFE#PBF (Linear Technology)IC REG FLYBACK ISO ADJ 16TSSOP PDF资料下载
参数资料
| 型号： | LT3575EFE#PBF |
| 厂商： | Linear Technology |
| 文件页数： | 16/24页 |
| 文件大小： | 0K |
| 描述： | IC REG FLYBACK ISO ADJ 16TSSOP |
| 标准包装： | 95 |
| 类型： | 回扫，隔离 |
| 输出类型： | 可调式 |
| 输出数： | 1 |
| 输出电压： | 可调至 60V |
| 输入电压： | 3 V ~ 40 V |
| PWM 型： | 电流模式，混合 |
| 频率 - 开关： | 1MHz |
| 电流 - 输出： | 2.5A |
| 同步整流器： | 无 |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 16-TSSOP（0.173"，4.40mm）裸露焊盘 |
| 包装： | 管件 |
| 供应商设备封装： | 16-TSSOP-EP |
| 配用： | 732-3306-ND - BOARD EVAL FOR LT3575 |
| 相关产品： | 732-2669-2-ND - TRANS FLYBACK LT3748 20UH SMD 732-2669-6-ND - TRANS FLYBACK LT3748 20UH SMD 732-2668-6-ND - TRANS FLYBACK LT3748 14UH SMD 732-2667-6-ND - TRANS FLYBACK LT3748 500UH SMD 732-2666-6-ND - TRANS FLYBACK LT3748 12UH SMD 732-2665-6-ND - TRANS FLYBACK LT3748 12UH SMD 732-2664-6-ND - TRANS FLYBACK LT3748 15UH SMD 732-2663-6-ND - TRANS FLYBACK LT3748 15UH SMD 732-2662-6-ND - TRANS FLYBACK LT3748 8UH SMD 732-2661-6-ND - TRANS FLYBACK LT3748 8UH SMD 更多... |
LT3575
APPLICATIONS INFORMATION
The transformer turns ratio is selected such that the
converter has adequate current capability and a switch
Table 7.Switching Frequency at Different Primary
Inductance at I PK
stress below 50V. Table 6 shows the switch voltage stress
and output current capability at different transformer
turns ratio.
Table 6. Switch Voltage Stress and Output Current Capability vs
L (μH)
15
30
60
f SW AT V IN(MIN)
(kHz)
174
87
44
f SW AT V IN(MAX)
(kHz)
205
103
51
Turns-Ratio
Note: The switching frequency is calculated at maximum output.
V SW(MAX) AT V IN(MAX)
I OUT(MAX) AT V IN(MIN)
DUTY CYCLE
N
1:1
2:1
3:1
4:1
(V)
33.5
39
44.5
50
(A)
1.26
2.07
2.63
3.05
(%)
16~22
28~35
37~45
44~52
In this design example, the minimum primary inductance is
used to achieve a nominal switching frequency of 200kHz at
full load. The 750311458 from Würth Elektronik is chosen
as the ?yback transformer.
Given the turns ratio and primary inductance, a custom-
BIAS winding turns ratio is selected to program the BIAS
voltage to 3V~5V. The BIAS voltage shall not exceed the
input voltage.
The turns ratio is then selected as primary: secondary:
BIAS = 3:1:1.
2. Select the transformer primary inductance for target
switching frequency.
The LT3575 requires a minimum amount of time to sample
ized transformer can be designed by magnetic component
manufacturer or a multi-winding transformer such as a
Coiltronics Versa-Pac may be used.
3. Select the output diodes and output capacitor.
The output diode voltage stress V D is the summation of
the output voltage and re?ection of input voltage to the
secondary side. The average diode current is the load
current.
the output voltage during the off-time. This off-time,
t OFF(MIN) , shall be greater than 350ns over all operating
V D = V OUT +
V IN
N
L MIN =
Δ V MAX
LI 2 PK
conditions.Theconverteralsohasaminimumcurrentlimit,
I MIN , of 400mA to help create this off-time. This de?nes
the minimum required inductance as de?ned as:
N( V OUT + V F )
? t OFF ( MIN )
I MIN
The transformer primary inductance also affects the
switching frequency which is related to the output ripple. If
above the minimum inductance, the transformer’s primary
inductance may be selected for a target switching frequency
range in order to minimize the output ripple.
The following equation estimates the switching frequency.
The output capacitor should be chosen to minimize the
output voltage ripple while considering the increase in
size and cost of a larger capacitor. The following equation
calculates the output voltage ripple.
=
2 CV OUT
4. Select the snubber circuit to clamp the switch
voltage spike.
A ?yback converter generates a voltage spike during switch
turn-off due to the leakage inductance of the transformer.
=
+
f SW =
1 1
t ON + t OFF I PK I PK
L
V IN N PS ( V OUT + V F )
L
In order to clamp the voltage spike below the maximum
rating of the switch, a snubber circuit is used. There are
many types of snubber circuits, for example R-C, R-C-D and
3575f
16
相关PDF资料 |
PDF描述 |
|---|---|
| LTC3521EFE#PBF | IC REG BUCK BST SYNC ADJ 20TSSOP |
| LLS1C273MELA | CAP ALUM 27000UF 16V 20% SNAP |
| RCM31DCBH-S189 | CONN EDGECARD 62POS R/A .156 SLD |
| LT3579EFE-1#PBF | IC REG MULTI CONFIG SYNC 20TSSOP |
| RCM31DCBD-S189 | CONN EDGECARD 62POS R/A .156 SLD |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT3575IFE#PBF | 功能描述:IC REG FLYBACK ISO ADJ 16TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:250 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.2V 输入电压:2.05 V ~ 6 V PWM 型:电压模式 频率 - 开关:2MHz 电流 - 输出:500mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:6-UFDFN 包装:带卷 (TR) 供应商设备封装:6-SON（1.45x1） 产品目录页面:1032 (CN2011-ZH PDF) 其它名称:296-25628-2 |
| LT3575IFE#TRPBF | 功能描述:IC REG FLYBACK ISO ADJ 16TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 设计资源:Design Support Tool 标准包装:1 系列:- 类型:升压（升压） 输出类型:固定 输出数:1 输出电压:3V 输入电压:0.75 V ~ 2 V PWM 型:- 频率 - 开关:- 电流 - 输出:100mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 包装:剪切带 (CT) 供应商设备封装:TSOT-23-5 其它名称:AS1323-BTTT-30CT |
| LT3579 | 制造商:LINER 制造商全称:Linear Technology 功能描述:6A Boost/Inverting DC/DC Converter with Fault Protection |
| LT3579-1 | 制造商:LINER 制造商全称:Linear Technology 功能描述:6A Boost/Inverting DC/DC Converter with Fault Protection |
| LT3579EFE#PBF | 功能描述:IC REG MULTI CONFIG SYNC 20TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:250 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.2V 输入电压:2.05 V ~ 6 V PWM 型:电压模式 频率 - 开关:2MHz 电流 - 输出:500mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:6-UFDFN 包装:带卷 (TR) 供应商设备封装:6-SON（1.45x1） 产品目录页面:1032 (CN2011-ZH PDF) 其它名称:296-25628-2 |
发布紧急采购，3分钟左右您将得到回复。