- 您现在的位置：买卖IC网 > PDF目录13908 > LT3640IUFD#PBF (Linear Technology)IC REG BUCK FIX/ADJ DL 28QFN PDF资料下载
参数资料
| 型号： | LT3640IUFD#PBF |
| 厂商： | Linear Technology |
| 文件页数： | 11/24页 |
| 文件大小： | 0K |
| 描述： | IC REG BUCK FIX/ADJ DL 28QFN |
| 标准包装： | 73 |
| 类型： | 降压（降压） |
| 输出类型： | 两者兼有 |
| 输出数： | 2 |
| 输出电压： | 1.8V，3.3V，可调 |
| 输入电压： | 2.5 V ~ 35 V |
| PWM 型： | 电流模式，混合 |
| 频率 - 开关： | 500kHz ~ 2MHz |
| 电流 - 输出： | 1.1A，1.3A |
| 同步整流器： | 无 |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 28-WFQFN 裸露焊盘 |
| 包装： | 管件 |
| 供应商设备封装： | 28-QFN（4x5） |
LT3640
OPERATION
when the V IN2 pin voltage is above 2.3V, the EN2 pin is
pulled high and the FB1 pin voltage is above 1.165V. The
internal top power MOSFET is turned on each cycle at the
beginning of each oscillator cycle, and turned off when
the current flowing through the top MOSFET reaches a
level determined by the voltage at the VC2 node. An error
amplifier measures the output voltage through an external
resistor divider tied to the FB2 pin and servos the VC2
node. The reference of the error amplifier is determined by
the lower of the internal 600mV reference and the voltage
at the SS2 pin.
While the top MOSFET is off, the bottom MOSFET is turned
on in an oscillator cycle until the inductor current starts
to reverse. If the inductor current is higher than the valley
current limit at the beginning of an oscillator cycle, the top
MOSFET will not turn on in this cycle, limiting inductor
current in shorted output fault.
An internal regulator provides power to the control circuitry.
The regulator draws most power from the V IN2 pin and a
small portion of power from the V IN pin when the V IN2 pin
voltage is higher than 3V. If the voltage at V IN2 pin is lower
than 3V, the regulator draws all power from the V IN pin.
The EN/UVLO pin is used to put the LT3640 in shutdown,
reducing the input current to less than 1μA. The accurate
1.26V threshold of the EN/UVLO pin provides a program-
mable V IN undervoltage lockout through an external resistor
divider tied to the EN/UVLO pin. A 2μA hysteresis current
on the EN/UVLO pin prevents switching noise from shut-
ting down the LT3640.
The LT3640 has an overvoltage protection feature which
disables switching action in both channels when the V IN
pin voltage goes above 36V. When switching is disabled,
the LT3640 can sustain V IN voltages up to 55V for one
second.
Internal 2μA current sources charge the SS1 pin and
the SS2 pin up to about 2V. Soft-start or output voltage
tracking of the two channels can be independently imple-
mented with capacitors from the SS1 pin and the SS2 pin
to ground. Any overvoltage or undervoltage condition on
the V IN pin triggers an internal latch that discharges the
SS1 pin to below 100mV before it is released. If the EN2
pin goes low, the V IN2 voltage falls below 2.2V or the FB1
pin goes below 1.165V, the SS2 pin will be discharged to
below 100mV before it is released.
To optimize efficiency, the LT3640 switches to low ripple
Burst Mode operation in light load situations. Between
switching pulses, control-circuitry current is minimized.
A power good comparator with 40mV of hysteresis trips
when the low voltage channel is enabled and the FB2 pin is
above 550mV. The PGOOD pin is an open-drain output that
is pulled low when both the outputs are in regulation.
Power-On Reset and Watchdog Timer
The LT3640 includes one power-on reset timer for each
buck regulator and one common watchdog timer. Power-
on reset and watchdog timers are both adjustable using
external capacitors. Operation can be best understood by
referring to the Timing Diagram.
The RST1 , RST2 and WDO pins are all open-drain outputs
with weak internal pull-ups to about 2V. The RST1 and RST2
pins are pulled low when the LT3640 is enabled and V IN is
above 3.6V. Once the FB1 pin rises above 1.165V, the high
voltage channel reset timer is started and RST1 is released
after the reset timeout period. The low voltage channel reset
timer is started once the FB2 pin rises above 550mV, and
releases RST2 after the reset timeout period.
The watchdog circuit monitors a μP’s activity. As soon
as both RST1 and RST2 are released, a delay timer is
started. The watchdog timer is started after the delay timer
times out. The LT3640 implements windowed watchdog
function for higher system reliability. The watchdog timer
detects falling edges on the WDI pin. If the falling edges
are grouped too close together or too far apart, the WDO
pin is pulled down and the reset timer is started. When the
reset timer times out, WDO is released and the watchdog
timer is again started after the delay period.
3640f
相关PDF资料 |
PDF描述 |
|---|---|
| MAX6720AUTVHD2+T | IC SUPERVISOR MPU SOT23-6 |
| LTC3413EFE#TRPBF | IC REG BUCK SYNC ADJ 3A 16TSSOP |
| LTC3413EFE#TR | IC REG BUCK SYNC ADJ 3A 16TSSOP |
| LT1374CS8-5SYNC#PBF | IC REG BUCK 5V 4.5A 8SOIC |
| EBM18DRMN-S273 | CONN EDGECARD 36POS .156 WW |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT3640IUFDTRPBF | 制造商:LINER 制造商全称:Linear Technology 功能描述:Dual Monolithic Buck Regulator with Power-On Reset and Watchdog Timer |
| LT3641EFE#PBF | 功能描述:IC REG BUCK SYNC ADJ DL 28-TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:250 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.2V 输入电压:2.05 V ~ 6 V PWM 型:电压模式 频率 - 开关:2MHz 电流 - 输出:500mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:6-UFDFN 包装:带卷 (TR) 供应商设备封装:6-SON（1.45x1） 产品目录页面:1032 (CN2011-ZH PDF) 其它名称:296-25628-2 |
| LT3641EFE#TRPBF | 功能描述:IC REG BUCK SYNC ADJ DL 28TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 设计资源:Design Support Tool 标准包装:1 系列:- 类型:升压（升压） 输出类型:固定 输出数:1 输出电压:3V 输入电压:0.75 V ~ 2 V PWM 型:- 频率 - 开关:- 电流 - 输出:100mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 包装:剪切带 (CT) 供应商设备封装:TSOT-23-5 其它名称:AS1323-BTTT-30CT |
| LT3641EUFD#PBF | 功能描述:IC REG BUCK SYNC ADJ DL 28QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 设计资源:Design Support Tool 标准包装:1 系列:- 类型:升压（升压） 输出类型:固定 输出数:1 输出电压:3V 输入电压:0.75 V ~ 2 V PWM 型:- 频率 - 开关:- 电流 - 输出:100mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 包装:剪切带 (CT) 供应商设备封装:TSOT-23-5 其它名称:AS1323-BTTT-30CT |
| LT3641EUFD#TRPBF | 功能描述:IC REG BUCK SYNC ADJ DL 28QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 设计资源:Design Support Tool 标准包装:1 系列:- 类型:升压（升压） 输出类型:固定 输出数:1 输出电压:3V 输入电压:0.75 V ~ 2 V PWM 型:- 频率 - 开关:- 电流 - 输出:100mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 包装:剪切带 (CT) 供应商设备封装:TSOT-23-5 其它名称:AS1323-BTTT-30CT |
发布紧急采购，3分钟左右您将得到回复。