参数资料
| 型号： | LT3693IMSE#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 10/24页 |
| 文件大小： | 0K |
| 描述： | IC REG BUCK ADJ 3.5A 10MSOP |
| 标准包装： | 2,500 |
| 类型： | 降压（降压） |
| 输出类型： | 可调式 |
| 输出数： | 1 |
| 输出电压： | 0.79 V ~ 30 V |
| 输入电压： | 3.6 V ~ 36 V |
| PWM 型： | 电流模式 |
| 频率 - 开关： | 200kHz ~ 2.45MHz |
| 电流 - 输出： | 3.5A |
| 同步整流器： | 无 |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 10-TFSOP，10-MSOP（0.118"，3.00mm 宽）裸露焊盘 |
| 包装： | 带卷 (TR) |
| 供应商设备封装： | 10-MSOP 裸露焊盘 |
LT3693
APPLICATIONS INFORMATION
L = ? OUT D ? ? 1– OUT D ?
operating input voltage. Conversely, a lower switching
frequency will be necessary to achieve safe operation at
high input voltages.
If the output is in regulation and no short-circuit, start-
up, or overload events are expected, then input voltage
transients of up to 36V are acceptable regardless of the
switching frequency. In this mode, the LT3693 may enter
pulse skipping operation where some switching pulses
are skipped to maintain output regulation. In this mode
the output voltage ripple and inductor current ripple will
be higher than in normal operation.
The minimum input voltage is determined by either the
LT3693’s minimum operating voltage of ~3.6V or by its
maximum duty cycle (see equation in previous section).
The minimum input voltage due to duty cycle is:
ripple current. The LT3693’s switch current limit (I LIM ) is
5.5A at low duty cycles and decreases linearly to 4.5A at
DC = 0.8. The maximum output current is a function of
the inductor ripple current:
I OUT(MAX) = I LIM – Δ I L /2
Be sure to pick an inductor ripple current that provides
suf?cient maximum output current (I OUT(MAX) ).
The largest inductor ripple current occurs at the highest
V IN . To guarantee that the ripple current stays below the
speci?ed maximum, the inductor value should be chosen
according to the following equation:
? V + V ? ? V + V ?
? f SW Δ I L ? ? V IN ( MAX ) ?
V IN ( MIN ) =
V OUT + V D
1– f SW t OFF ( MIN )
– V D + V SW
where V D is the voltage drop of the catch diode (~0.4V),
V IN(MAX) is the maximum input voltage, V OUT is the output
voltage, f SW is the switching frequency (set by RT), and
where V IN(MIN) is the minimum input voltage, and t OFF(MIN)
is the minimum switch off time (150ns). Note that higher
switching frequency will increase the minimum input
voltage. If a lower dropout voltage is desired, a lower
switching frequency should be used.
Inductor Selection
For a given input and output voltage, the inductor value
and switching frequency will determine the ripple current.
The ripple current Δ I L increases with higher V IN or V OUT
and decreases with higher inductance and faster switch-
L is in the inductor value.
The inductor’s RMS current rating must be greater than
the maximum load current and its saturation current
should be about 30% higher. For robust operation in fault
conditions (start-up or short circuit) and high input volt-
age (>30V), the saturation current should be above 5A.
To keep the ef?ciency high, the series resistance (DCR)
should be less than 0.05 , and the core material should
be intended for high frequency applications. Table 1 lists
several vendors and suitable types.
Table 1. Inductor Vendors
ing frequency. A reasonable starting point for selecting
the ripple current is:
Δ I L = 0.4(I OUT(MAX) )
where I OUT(MAX) is the maximum output load current. To
guarantee suf?cient output current, peak inductor current
must be lower than the LT3693’s switch current limit (I LIM ).
The peak inductor current is:
I L(PEAK) = I OUT(MAX) + Δ I L /2
VENDOR
Murata
TDK
Toko
Sumida
NEC
URL
www.murata.com
www.componenttdk.com
www.toko.com
www.sumida.com
www.nec.com
PART SERIES
LQH55D
SLF10145
D75C
D75F
CDRH74
CR75
CDRH8D43
MPLC073
MPBI0755
TYPE
Open
Shielded
Shielded
Open
Shielded
Open
Shielded
Shielded
Shielded
where I L(PEAK) is the peak inductor current, I OUT(MAX) is
the maximum output load current, and Δ I L is the inductor
3693f
10
相关PDF资料 |
PDF描述 |
|---|---|
| LT3695HMSE-5#TRPBF | IC REG BUCK 5V 1A 16MSOP |
| LT3710EFE#TRPBF | IC REG CTRLR BUCK PWM 16-TSSOP |
| LT3724EFE#PBF | IC REG CTRLR BST INV PWM 16TSSOP |
| LT3740EDHC#PBF | IC REG CTRLR BUCK PWM CM 16-DFN |
| LT3741EFE#PBF | IC REG CTRLR BUCK PWM CM 20TSSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT3694 | 制造商:LINER 制造商全称:Linear Technology 功能描述:36V, 2.6A Monolithic Buck |
| LT3694_12 | 制造商:LINER 制造商全称:Linear Technology 功能描述:36V, 2.6A Monolithic Buck |
| LT3694-1 | 制造商:LINER 制造商全称:Linear Technology 功能描述:36V, 2.6A Monolithic Buck |
| LT3694-1EFEPBF | 制造商:LINER 制造商全称:Linear Technology 功能描述:36V, 2.6A Monolithic Buck Regulator With Dual LDO |
| LT3694-1EUFDPBF | 制造商:LINER 制造商全称:Linear Technology 功能描述:36V, 2.6A Monolithic Buck Regulator With Dual LDO |
发布紧急采购，3分钟左右您将得到回复。