- 您现在的位置：买卖IC网 > PDF目录15242 > LT3748EMS#PBF (Linear Technology)IC REG CTRLR FLYBK ISO CM 16MSOP PDF资料下载
参数资料
| 型号： | LT3748EMS#PBF |
| 厂商： | Linear Technology |
| 文件页数： | 23/30页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR FLYBK ISO CM 16MSOP |
| 产品培训模块： | LT3748 100V Flyback Controller |
| 特色产品： | LT3748 Isolated Flyback Controller |
| 标准包装： | 37 |
| PWM 型： | 电流模式 |
| 输出数： | 1 |
| 电源电压： | 5 V ~ 100 V |
| 降压： | 无 |
| 升压： | 无 |
| 回扫： | 是 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 是 |
| 工作温度： | -40°C ~ 125°C |
| 封装/外壳： | 16-TFSOP（0.118"，3.00mm），12 引线 |
| 包装： | 管件 |
| 配用： | 732-3308-ND - BOARD EVAL FOR LT3748 732-3305-ND - BOARD EVAL FOR LT3748 |
| 相关产品： | 732-2669-2-ND - TRANS FLYBACK LT3748 20UH SMD 732-2669-6-ND - TRANS FLYBACK LT3748 20UH SMD 732-2668-6-ND - TRANS FLYBACK LT3748 14UH SMD 732-2667-6-ND - TRANS FLYBACK LT3748 500UH SMD 732-2666-6-ND - TRANS FLYBACK LT3748 12UH SMD 732-2665-6-ND - TRANS FLYBACK LT3748 12UH SMD 732-2664-6-ND - TRANS FLYBACK LT3748 15UH SMD 732-2663-6-ND - TRANS FLYBACK LT3748 15UH SMD 732-2662-6-ND - TRANS FLYBACK LT3748 8UH SMD 732-2661-6-ND - TRANS FLYBACK LT3748 8UH SMD 更多... |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页当前第23页第24页第25页第26页第27页第28页第29页第30页
LT3748
APPLICATIONS INFORMATION
DESIGN EXAMPLE: 48V IN TO 12V, 2A OUT
The second example is a telecom application shown on the
front page of the datasheet. The focus of this application
is a cheap, small and simple solution. Table 3 shows the
results of the initial step for selecting the turns ratio.
In this example, the output diode is a much smaller ef-
ficiency loss due to the smaller voltage drop across it in
ratio to V OUT so minimizing output diode current is not
as important. Of greater importance is minimizing the
stresses on the MOSFET and output diode and the 4:1
case seems to be the best compromise for that to avoid
using a snubber on either device.
20μH of primary inductance is required for minimum
off-time while selecting the transformer, but in order to
minimize output ripple at maximum load a 60.8μH trans-
former is selected. To meet the saturation current (12A,
peak, on the secondary windings), a Versa-Pak VP4-0047-R
provides a compact and efficient solution.
For the MOSFET switch, since the input voltage is so high,
resistive losses on the primary side will be very low so
minimizing R DS(ON) is of minimum benefit. However, since
the current for the gate drive is pulled from a high V IN ,
minimizing both Q G and operating frequency is essential
unless a third winding is added. The Vishay Si7464DP, with
a 200V V DS(MAX) and low gate charge, keeps the INTV CC
The output diode only nominally has 30V of reverse bias
but a B360 diode is selected to ensure enough margin that
a snubber will not be required. A more expensive diode
with lower forward drop might recover several percent
efficiency and if high temperature operation is required a
diode rated for more average current at temperature might
be needed, but the B360 is small and inexpensive.
The rest of the design and component selection is straight-
forward.
Suggested Layout
See Figures 13 and 14 for the DC1557A demo board layout.
Note the proximity of the R REF and R FB resistors (R9, R5)
to the LT3748 for optimal regulation. The location of these
two resistors as close to the physical pins of the LT3748
is critical for accurate regulation. In addition, the high
frequency current path from the V IN bypass capacitor (C2)
through the primary-side winding, the MOSFET switch and
sense resistor (R10) is a very tight loop. Similarly, the high
frequency current path for the MOSFET gate switching from
the INTV CC capacitor through the source of the MOSFET
and sense resistor is similarly small in area. For improved
regulation it is recommended that the user ensure that the
high current ground is kept separate or at least physically
isolated from the small-signal ground used by the other
ground-referenced pins.
current to just over 3mA, worst-case, which when added
to quiescent current will keep power dissipation in the
LT3748 to just over 1/4W at 72V V IN .
Table 3. Voltage Stresses, Output Capability and Diode Current vs Turns Ratio in 48V IN to 12V, 2A Application
N PS
1
2
4
6
V DS(MAX)
84
96
120
144
V R(DIODE)
84
48
30
24
D (V IN = 48V)
0.21
0.34
0.51
0.61
D (V IN = 36V)
0.26
0.41
0.58
0.68
I LIM (2A OUT AT V IN = 36V)
6
4
3
2
I DIODE(RMS) (V IN = 48V)
3.3
3.7
4.6
5.2
3748fa
23
相关PDF资料 |
PDF描述 |
|---|---|
| H2AAT-10104-R4-ND | JUMPER-H1502TR/A2015R/H1502TR 4" |
| H2AAT-10104-N4-ND | JUMPER-H1502TR/A2015N/H1502TR 4" |
| H2AAT-10104-L4-ND | JUMPER-H1502TR/A2015L/H1502TR 4" |
| VE-J7J-EY-F4 | CONVERTER MOD DC/DC 36V 50W |
| LTC1436AIGN-PLL#PBF | IC REG CTRLR BUCK PWM CM 24-SSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT3748EMSTRPBF | 制造商:LINER 制造商全称:Linear Technology 功能描述:100V Isolated Flyback Controller |
| LT3748HMS#PBF | 功能描述:IC REG CTRLR FLYBK ISO CM 16MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 特色产品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 标准包装:1 系列:PowerWise® PWM 型:电压模式 输出数:1 频率 - 最大:1MHz 占空比:81% 电源电压:4.5 V ~ 18 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-5°C ~ 125°C 封装/外壳:32-WFQFN 裸露焊盘 包装:Digi-Reel® 产品目录页面:1303 (CN2011-ZH PDF) 其它名称:LM3754SQDKR |
| LT3748HMS#TRPBF | 功能描述:IC REG CTRLR FLYBK ISO CM 16MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LT3748HMSPBF | 制造商:LINER 制造商全称:Linear Technology 功能描述:100V Isolated Flyback Controller |
| LT3748HMSTRPBF | 制造商:LINER 制造商全称:Linear Technology 功能描述:100V Isolated Flyback Controller |
发布紧急采购，3分钟左右您将得到回复。