- 您现在的位置：买卖IC网 > PDF目录15242 > LT3748EMS#PBF (Linear Technology)IC REG CTRLR FLYBK ISO CM 16MSOP PDF资料下载
参数资料
| 型号： | LT3748EMS#PBF |
| 厂商： | Linear Technology |
| 文件页数： | 6/30页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR FLYBK ISO CM 16MSOP |
| 产品培训模块： | LT3748 100V Flyback Controller |
| 特色产品： | LT3748 Isolated Flyback Controller |
| 标准包装： | 37 |
| PWM 型： | 电流模式 |
| 输出数： | 1 |
| 电源电压： | 5 V ~ 100 V |
| 降压： | 无 |
| 升压： | 无 |
| 回扫： | 是 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 是 |
| 工作温度： | -40°C ~ 125°C |
| 封装/外壳： | 16-TFSOP（0.118"，3.00mm），12 引线 |
| 包装： | 管件 |
| 配用： | 732-3308-ND - BOARD EVAL FOR LT3748 732-3305-ND - BOARD EVAL FOR LT3748 |
| 相关产品： | 732-2669-2-ND - TRANS FLYBACK LT3748 20UH SMD 732-2669-6-ND - TRANS FLYBACK LT3748 20UH SMD 732-2668-6-ND - TRANS FLYBACK LT3748 14UH SMD 732-2667-6-ND - TRANS FLYBACK LT3748 500UH SMD 732-2666-6-ND - TRANS FLYBACK LT3748 12UH SMD 732-2665-6-ND - TRANS FLYBACK LT3748 12UH SMD 732-2664-6-ND - TRANS FLYBACK LT3748 15UH SMD 732-2663-6-ND - TRANS FLYBACK LT3748 15UH SMD 732-2662-6-ND - TRANS FLYBACK LT3748 8UH SMD 732-2661-6-ND - TRANS FLYBACK LT3748 8UH SMD 更多... |
第1页第2页第3页第4页第5页当前第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页
LT3748
PIN FUNCTIONS
V IN (Pin 1) Input Voltage. This pin supplies current to the
internal start-up circuitry and is the reference voltage for
the feedback circuitry connected to the R FB pin. This pin
must be locally bypassed with a capacitor.
EN/UVLO (Pin 3): Enable/Undervoltage Lockout. A resistor
divider connected to V IN is tied to this pin to program the
minimum input voltage at which the LT3748 will operate.
At a voltage below ~0.5V, the part draws less than 1μA
quiescent current. When below 1.223V but above ~0.5V,
the part will draw quiescent current but will not regulate
the INTV CC supply or power the gate drive circuitry. Above
1.223V, all internal circuitry will start and the SS pin will
source 5μA. When EN/UVLO falls below 1.223V, 2.4μA is
sunk from the pin to provide programmable hysteresis
for undervoltage lockout.
INTV CC (Pin 5): Gate Driver Bias Voltage. This pin supplies
current to the internal gate driver circuitry of the LT3748.
The INTV CC pin must be locally bypassed with a capacitor.
This pin may also be connected to V IN if a third winding
is not used and if V IN ≤ 20V. If a third winding is used, the
INTV CC voltage should be lower than the input voltage for
proper operation.
GATE (Pin 6): N-Channel MOSFET Gate Driver Output.
Switches between INTV CC and GND.
SENSE (Pin 7): The Current Sense Input for the Control
Loop. Kelvin connect this pin to the positive terminal of
the switch current sense resistor, R SENSE , in the source
of the N-channel MOSFET. The negative terminal of the
GND (Pins 8, 9): Ground.
SS (Pin 10): Soft-Start Pin. This pin delays start-up and
clamps V C pin voltage. Soft-start timing is set by the size
of the external capacitor at the pin. Switching starts when
V SS reaches ~0.65V.
V C (Pin 11): Compensation Pin for the Internal Error
Amplifier. Connect a series RC from this pin to ground to
compensate the switching regulator. A 100pF capacitor in
parallel helps eliminate noise.
TC (Pin 12): Output Voltage Temperature Compensation.
Connect a resistor to ground to produce a current pro-
portional to absolute temperature to be sourced into the
RREF node. I TC = 0.55V/R TC .
R REF (Pin 14): Input Pin for the External Ground-Referred
Reference Resistor. The resistor at this pin should be 6.04k,
but for convenience in selecting a resistor divider ratio,
the value may range from 5.76k to 6.34k. The resistor
should be as close to the LT3748 as possible .
R FB (Pin 16): Input Pin for the External Feedback Resistor.
This pin is connected to the transformer primary at the
external MOSFET power switch. The ratio of this resistor
to the R REF resistor, times the internal bandgap reference,
determines the output voltage (plus the effect of any
non-unity transformer turns ratio). The average current
through this resistor during the flyback period should be
approximately 200μA. The resistor should be as close
to the LT3748 as possible .
current sense resistor should be connected to the GND
plane close to the IC.
3748fa
6
相关PDF资料 |
PDF描述 |
|---|---|
| H2AAT-10104-R4-ND | JUMPER-H1502TR/A2015R/H1502TR 4" |
| H2AAT-10104-N4-ND | JUMPER-H1502TR/A2015N/H1502TR 4" |
| H2AAT-10104-L4-ND | JUMPER-H1502TR/A2015L/H1502TR 4" |
| VE-J7J-EY-F4 | CONVERTER MOD DC/DC 36V 50W |
| LTC1436AIGN-PLL#PBF | IC REG CTRLR BUCK PWM CM 24-SSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT3748EMSTRPBF | 制造商:LINER 制造商全称:Linear Technology 功能描述:100V Isolated Flyback Controller |
| LT3748HMS#PBF | 功能描述:IC REG CTRLR FLYBK ISO CM 16MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 特色产品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 标准包装:1 系列:PowerWise® PWM 型:电压模式 输出数:1 频率 - 最大:1MHz 占空比:81% 电源电压:4.5 V ~ 18 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-5°C ~ 125°C 封装/外壳:32-WFQFN 裸露焊盘 包装:Digi-Reel® 产品目录页面:1303 (CN2011-ZH PDF) 其它名称:LM3754SQDKR |
| LT3748HMS#TRPBF | 功能描述:IC REG CTRLR FLYBK ISO CM 16MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LT3748HMSPBF | 制造商:LINER 制造商全称:Linear Technology 功能描述:100V Isolated Flyback Controller |
| LT3748HMSTRPBF | 制造商:LINER 制造商全称:Linear Technology 功能描述:100V Isolated Flyback Controller |
发布紧急采购，3分钟左右您将得到回复。