参数资料
型号: LT3757IMSE#PBF
厂商: Linear Technology
文件页数: 20/36页
文件大小: 0K
描述: IC REG CTRLR PWM CM 10-MSOP
产品培训模块: LT3757 and LT3758 - Boost, Flyback, SEPIC and Inverting Controllers
标准包装: 50
PWM 型: 电流模式
输出数: 1
频率 - 最大: 1MHz
电源电压: 2.9 V ~ 40 V
降压:
升压:
回扫:
反相:
倍增器:
除法器:
Cuk:
隔离:
工作温度: -40°C ~ 125°C
封装/外壳: 10-TFSOP,10-MSOP(0.118",3.00mm 宽)裸露焊盘
包装: 管件
LT3757/LT3757A
APPLICATIONS INFORMATION
C CN =
R SENSE =
where V SN is the snubber capacitor voltage. A smaller
V SN results in a larger snubber loss. A reasonable V SN is
2 to 2.5 times of:
V OUT ? N P
N S
L LK is the leakage inductance of the primary winding, which
is usually specified in the transformer characteristics. L LK
can be obtained by measuring the primary inductance with
the secondary windings shorted. The snubber capacitor
value (C CN ) can be determined using the following equation:
V SN
? V SN ? R CN ? f
where ?V SN is the voltage ripple across C CN . A reasonable
?V SN is 5% to 10% of V SN . The reverse voltage rating of
D SN should be higher than the sum of V SN and V IN(MAX) .
Flyback Converter: Sense Resistor Selection
In a flyback converter, when the power switch is turned
on, the current flowing through the sense resistor
(I SENSE ) is:
I SENSE = I LP
Set the sense voltage at I LP(PEAK) to be the minimum of
the SENSE current limit threshold with a 20% margin. The
sense resistor value can then be calculated to be:
80mV
I LP(PEAK)
Flyback Converter: Power MOSFET Selection
For the flyback configuration, the MOSFET is selected with
a V DC rating high enough to handle the maximum V IN , the
reflected secondary voltage and the voltage spike due to
the leakage inductance. Approximate the required MOSFET
V DC rating using:
BV DSS > V DS(PEAK)
where:
V DS(PEAK) = V IN(MAX) + V SN
The power dissipated by the MOSFET in a flyback con-
verter is:
P FET = I 2M(RMS) ? R DS(ON) + 2 ? V 2DS(PEAK) ? I L(MAX) ?
C RSS ? f /1A
The first term in this equation represents the conduction
losses in the device, and the second term, the switching
loss. C RSS is the reverse transfer capacitance, which is
usually specified in the MOSFET characteristics.
From a known power dissipated in the power MOSFET, its
junction temperature can be obtained using the following
equation:
T J = T A + P FET ? θ JA = T A + P FET ? ( θ JC + θ CA )
T J must not exceed the MOSFET maximum junction
temperature rating. It is recommended to measure the
MOSFET temperature in steady state to ensure that absolute
maximum ratings are not exceeded.
3757afd
20
相关PDF资料
PDF描述
RGM18DTKH CONN EDGECARD 36POS DIP .156 SLD
IDCS2512ER102M INDUCTOR POWER 1000UH 0.15A SMD
LTC1147CN8-5 IC REG CTRLR BUCK PWM CM 8-DIP
ADM805LAN IC SUPERVISOR 4.65V WD 8DIP
RYM18DTKD CONN EDGECARD 36POS DIP .156 SLD
相关代理商/技术参数
参数描述
LT3757IMSE-TRPBF 制造商:LINER 制造商全称:Linear Technology 功能描述:Boost, Flyback, SEPIC and Inverting Controller
LT3757MPMSE 制造商:LINER 制造商全称:Linear Technology 功能描述:Boost, Flyback, SEPIC and Inverting Controller
LT3757MPMSE#PBF 功能描述:IC REG CTRLR PWM CM 10-MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX
LT3757MPMSE#TRPBF 功能描述:IC REG CTRLR PWM CM 10-MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX
LT3757MPMSE-PBF 制造商:LINER 制造商全称:Linear Technology 功能描述:Boost, Flyback, SEPIC and Inverting Controller