参数资料
型号: LT3800EFE#TRPBF
厂商: Linear Technology
文件页数: 10/24页
文件大小: 0K
描述: IC REG CTRLR INV PWM CM 16-TSSOP
标准包装: 2,500
PWM 型: 电流模式
输出数: 1
频率 - 最大: 220kHz
占空比: 95%
电源电压: 4 V ~ 60 V
降压:
升压:
回扫:
反相:
倍增器:
除法器:
Cuk:
隔离:
工作温度: -40°C ~ 125°C
封装/外壳: 16-TSSOP(0.173",4.40mm)裸露焊盘
包装: 带卷 (TR)
LT3800
APPLICATIONS INFORMATION
Burst Mode
The LT3800 employs low current Burst Mode functional-
ity to maximize ef?ciency during no load and low load
conditions. Burst Mode operation is enabled by shorting
the BURST_EN pin to SGND. Burst Mode operation can
be disabled by shorting BURST_EN to either V FB or V CC .
When the required switch current, sensed via the V C
pin voltage, is below 15% of maximum, the Burst Mode
operation is employed and that level of sense current is
latched onto the IC control path. If the output load requires
less than this latched current level, the converter will
overdrive the output slightly during each switch cycle.
This overdrive condition is sensed internally and forces
the voltage on the V C pin to continue to drop. When the
voltage on V C drops 150mV below the 15% load level,
switching is disabled and the LT3800 shuts down most
of its internal circuitry, reducing total quiescent current
to 100μA. When the converter output begins to fall, the
V C pin voltage begins to climb. When the voltage on the
V C pin climbs back to the 15% load level, the IC returns
to normal operation and switching resumes. An internal
clamp on the V C pin is set at 100mV below the switch
disable threshold, which limits the negative excursion of
the pin voltage, minimizing the converter output ripple
during Burst Mode operation.
During Burst Mode operation, V IN pin current is 20μA
and V CC current is reduced to 80μA. If no external drive is
provided for V CC , all V CC bias currents originate from the
V IN pin, giving a total V IN current of 100μA. Burst current
can be reduced further when V CC is driven using an output
derived source, as the V CC component of V IN current is
then reduced by the converter buck ratio.
Reverse-Current Inhibit
The LT3800 contains a reverse-current inhibit feature to
maximize ef?ciency during light load conditions. This
mode of operation allows discontinuous operation, and
is sometimes referred to as “pulse-skipping” mode. Refer
to Figure 2.
This feature is enabled with Burst Mode operation, and can
also be enabled while Burst Mode operation is disabled
by shorting the BURST_EN pin to V FB .
When reverse-current inhibit is enabled, the LT3800 sense
ampli?er detects inductor currents approaching zero and
disables the synchronous switch for the remainder of
the switch cycle. If the inductor current is allowed to go
negative before the synchronous switch is disabled, the
switch node could inductively kick positive with a high
dv/dt. The LT3800 prevents this by incorporating a 10mV
positive offset at the sense inputs.
I L
PULSE SKIP MODE
I L
FORCED CONTINUOUS
DECREASING
LOAD
CURRENT
3800 F02
Figure 2. Inductor Current vs Mode
3800fc
10
相关PDF资料
PDF描述
VI-2WD-EW-F1 CONVERTER MOD DC/DC 85V 100W
UVK1A472MHD CAP ALUM 4700UF 10V 20% RADIAL
VI-2WB-EY-B1 CONVERTER MOD DC/DC 95V 50W
PCF1E470MCL1GS CAP ALUM 47UF 25V 20% SMD
ECA43DCBI CONN EDGECARD 86POS R/A .125 SLD
相关代理商/技术参数
参数描述
LT3800IFE 制造商:Linear Technology 功能描述:Conv DC-DC Single Step Down 4V to 60V 16-Pin TSSOP EP
LT3800IFE#PBF 功能描述:IC REG CTRLR INV PWM CM 16-TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 特色产品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 标准包装:1 系列:PowerWise® PWM 型:电压模式 输出数:1 频率 - 最大:1MHz 占空比:81% 电源电压:4.5 V ~ 18 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-5°C ~ 125°C 封装/外壳:32-WFQFN 裸露焊盘 包装:Digi-Reel® 产品目录页面:1303 (CN2011-ZH PDF) 其它名称:LM3754SQDKR
LT3800IFE#PBF 制造商:Linear Technology 功能描述:IC SYNC STEP-DOWN REGULATOR CTRL 16-TSSO
LT3800IFE#TR 制造商:Linear Technology 功能描述:Conv DC-DC Single Step Down 4V to 60V 16-Pin TSSOP EP T/R
LT3800IFE#TRPBF 功能描述:IC REG CTRLR INV PWM CM 16-TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX