- 您现在的位置：买卖IC网 > PDF目录15304 > LT3844EFE#TRPBF (Linear Technology)IC REG CTRLR BST INV PWM 16TSSOP PDF资料下载
参数资料
| 型号： | LT3844EFE#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 18/24页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR BST INV PWM 16TSSOP |
| 标准包装： | 2,500 |
| PWM 型： | 电流模式 |
| 输出数： | 1 |
| 频率 - 最大： | 330kHz |
| 占空比： | 95% |
| 电源电压： | 4 V ~ 60 V |
| 降压： | 是 |
| 升压： | 是 |
| 回扫： | 无 |
| 反相： | 是 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | -40°C ~ 125°C |
| 封装/外壳： | 16-TSSOP（0.173"，4.40mm）裸露焊盘 |
| 包装： | 带卷 (TR) |
LT3844
APPLICATIONS INFORMATION
Minimum On-Time Considerations (Buck Mode)
Minimum on-time, t ON(MIN) , is the smallest amount of time
that the LT3844 is capable of turning the top MOSFET on
Similar to the buck converter, the typical range of values
for Δ I L is (0.2 ? I L(MAX) ) to (0.5 ? I L(MAX) ), where I L(MAX)
is the maximum average inductor current.
and off again. It is determined by internal timing delays
and the amount of gate charge required turning on the
top MOSFET. Low duty cycle applications may approach
I L ( MAX ) = I OUT ( MAX ) ?
V OUT
V IN ( MIN )
t ON =
> t ON ( MIN )
DC MAX =
this minimum on-time limit and care should be taken to
ensure that:
V OUT
V IN ? f SW
where t ON(MIN) is typically 350ns worst case.
If the duty cycle falls below what can be accommodated by
the minimum on-time, the LT3844 will begin to skip cycles.
The output will be regulated, but the ripple current and
ripple voltage will increase. If lower frequency operation
is acceptable, the on-time can be increased above t ON(MIN)
for the same step-down ratio.
Boost Converter Design
The LT3844 can be used to con?gure a boost converter
to step-up voltages to as high as hundreds of volts. An
example of a boost converter circuit schematic is shown
in the Typical Applications section. The following sections
are a guide to designing a boost converter:
The maximum duty cycle of the main switch is:
V OUT ? V IN(MIN)
V OUT
Boost Converter: Inductor Selection
The critical parameters for selection of an inductor are
minimum inductance value and saturation current. The
minimum inductance value is calculated as follows:
Using Δ I L = 0.3 ? I L(MAX) yields a good design compromise
between inductor performance versus inductor size and
cost.
The inductor must not saturate at the peak operating
current, I L(MAX) + Δ I L /2. The inductor saturation current
speci?cation is the current at which the inductance, mea-
sured at zero current, decreases by a speci?ed amount,
typically 30%.
One drawback of boost regulators is that they cannot be
current limited for output shorts because the current steer-
ing diode makes a direct connection between input and
output. Therefore, the inductor current during an output
short circuit is only limited by the available current of the
input supply.
After calculating the minimum inductance value and the
saturation current for your design, select an off-the-shelf
inductor. For more detailed information on selecting an
inductor, please see the “Inductor Selection” section of
Linear Technology Application Note 19.
Boost Converter: MOSFET Selection
The selection criteria of the external N-channel standard
level power MOSFET include on resistance (R DS(ON) ), re-
verse transfer capacitance (C RSS ), maximum drain source
voltage (V DSS ), total gate charge (Q G ) and maximum
continuous drain current.
For maximum ef?ciency, minimize R DS(ON) and C RSS .
Low R DS(ON) minimizes conduction losses while low
L MIN =
V IN ( MIN )
Δ I L ? f SW
? DC MAX
C RSS minimizes transition losses. The problem is that
R DS(ON) is inversely related to C RSS . Balancing the tran-
sition losses with the conduction losses is a good idea
f SW is the switch frequency.
in sizing the MOSFET. Select the MOSFET to balance the
3844fb
18
相关PDF资料 |
PDF描述 |
|---|---|
| IMC1210EBR12J | INDUCTOR WW 120NH 5% 1210 |
| VE-J2X-EY-F3 | CONVERTER MOD DC/DC 5.2V 50W |
| LTC3833IFE#PBF | IC REG CTRLR BUCK PWM CM 20TSSOP |
| GBM43DCCS | CONN EDGECARD 86POS R/A .156 SLD |
| LT3825EFE#TRPBF | IC REG CTRLR FLYBK ISO 16-TSSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT3844IFE | 制造商:Linear Technology 功能描述:DC DC Cntrlr Single-OUT Step Down 4V to 60V Input 16-Pin TSSOP EP |
| LT3844IFE#PBF | 功能描述:IC REG CTRLR BST INV PWM 16TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LT3844IFE#TRPBF | 功能描述:IC REG CTRLR BST INV PWM 16TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LT3844IFEPBF | 制造商:Linear Technology 功能描述:DC-DC Controller Step-Down 4-60V TSSOP16 |
| LT3844IFE-PBF | 制造商:LINER 制造商全称:Linear Technology 功能描述:High Voltage, Current Mode Switching Regulator Controller with Programmable Operating Frequency |
发布紧急采购，3分钟左右您将得到回复。