- 您现在的位置：买卖IC网 > PDF目录15500 > LTC1142CG (Linear Technology)IC REG CTRLR BUCK PWM CM 28-SSOP PDF资料下载
参数资料
| 型号： | LTC1142CG |
| 厂商： | Linear Technology |
| 文件页数： | 13/20页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR BUCK PWM CM 28-SSOP |
| 标准包装： | 47 |
| PWM 型： | 电流模式 |
| 输出数： | 2 |
| 频率 - 最大： | 250kHz |
| 占空比： | 100% |
| 电源电压： | 3.5 V ~ 18 V |
| 降压： | 是 |
| 升压： | 无 |
| 回扫： | 无 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 28-SSOP（0.209"，5.30mm 宽） |
| 包装： | 管件 |
| 产品目录页面： | 1332 (CN2011-ZH PDF) |
LTC1142/LTC1142L/LTC1142HV
APPLICATIO S I FOR ATIO
current. When a load step occurs, V OUT shifts by an
amount equal to ? I LOAD ? ESR, where ESR is the effective
series resistance of C OUT . ? I LOAD also begins to charge
or discharge C OUT until the regulator loop adapts to the
current change and returns V OUT to its steady- state
value. During this recovery time V OUT can be monitored
for overshoot or ringing which would indicate a stability
problem. The Pin 27 (13) external components shown in
the Figure 1 circuit will prove adequate compensation for
most applications.
A second, more severe transient is caused by switching in
loads with large (>1 μ F) supply bypass capacitors. The
discharged bypass capacitors are effectively put in parallel
with C OUT , causing a rapid drop in V OUT . No regulator can
deliver enough current to prevent this problem if the load
switch resistance is low and it is driven quickly. The only
solution is to limit the rise time of the switch drive so that
the load rise time is limited to approximately 25 ? C LOAD .
Thus a 10 μ F capacitor would require a 250 μ s rise time,
limiting the charging current to about 200mA.
Efficiency Considerations
The percent efficiency of a switching regulator is equal to
the output power divided by the input power times 100%.
It is often useful to analyze individual losses to determine
what is limiting the efficiency and which change would
produce the most improvement. Percent efficiency can be
expressed as:
%Efficiency = 100% – (L1 + L2 + L3 + ...)
where L1, L2, etc., are the individual losses as a percent-
age of input power. (For high efficiency circuits only small
errors are incurred by expressing losses as a percentage
of output power.)
Although all dissipative elements in the circuit produce
losses, three main sources usually account for most of the
losses in LTC1142 circuits:
1. LTC1142 DC bias current
2. MOSFET gate charge current
3. I 2 R losses
1. The DC supply current is the current which flows into
V IN (pin 24 for the 3.3V section, Pin 10 for the 5V
section) less the gate charge current. For V IN = 10V the
LTC1142 DC supply current for each section is 160 μ A
with no load, and increases proportionally with load up
to a constant 1.6mA after the LTC1142 has entered
continuous mode. Because the DC bias current is
drawn from V IN , the resulting loss increases with input
voltage. For V IN = 10V the DC bias losses are generally
less than 1% for load currents over 30mA. However, at
very low load currents the DC bias current accounts for
nearly all of the loss.
2. MOSFET gate charge current results from switching
the gate capacitance of the power MOSFETs. Each time
a MOSFET gate is switched from low to high to low
again, a packet of charge dQ moves from V IN to ground.
The resulting dQ/dt is a current out of V IN which is
typically much larger than the DC supply current. In
continuous mode, I GATE(CHG) = f (Q N + Q P ). The typical
gate charge for a 0.1 ? N-channel power MOSFET is
25nC, and for a P-channel about twice that value. This
results in I GATE(CHG) = 7.5mA in 100kHz continuous
operation, for a 2% to 3% typical mid-current loss with
V IN = 10V.
Note that the gate charge loss increases directly with
both input voltage and operating frequency. This is the
principal reason why the highest efficiency circuits
operate at moderate frequencies. Furthermore, it ar-
gues against using larger MOSFETs than necessary to
control I 2 R losses, since overkill can cost efficiency as
well as money!
3. I 2 R losses are easily predicted from the DC resistances
of the MOSFET, inductor, and current shunt. In continu-
ous mode the average output current flows through L
and R SENSE , but is “chopped” between the P-channel
and N-channel MOSFETs. If the two MOSFETs have
approximately the same R DS(ON) , then the resistance of
one MOSFET can simply be summed with the resis-
tances of L and R SENSE to obtain I 2 R losses. For
example, if each R DS(ON) = 0.1 ? , R L = 0.15 ? , and
R SENSE = 0.05 ? , then the total resistance is 0.3 ? . This
results in losses ranging from 3% to 12% as the output
current increases from 0.5A to 2A. I 2 R losses cause the
efficiency to roll off at high output currents.
13
相关PDF资料 |
PDF描述 |
|---|---|
| VI-JTM-EY-B1 | CONVERTER MOD DC/DC 10V 50W |
| SPD62-823M | INDUCTOR PWR SHIELDED 82.0UH SMD |
| VI-JT1-EY-B1 | CONVERTER MOD DC/DC 12V 50W |
| VI-J5N-EY-B1 | CONVERTER MOD DC/DC 18.5V 50W |
| VI-J5L-EY-B1 | CONVERTER MOD DC/DC 28V 50W |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC1142CG#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 28-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,000 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:1MHz 占空比:50% 电源电压:9 V ~ 10 V 降压:无 升压:是 回扫:是 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 85°C 封装/外壳:8-TSSOP（0.173"，4.40mm 宽） 包装:带卷 (TR) |
| LTC1142CG#TR | 功能描述:IC REG CTRLR BUCK PWM CM 28-SSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LTC1142CG#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 28-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,000 系列:- PWM 型:电压模式 输出数:1 频率 - 最大:1.5MHz 占空比:66.7% 电源电压:4.75 V ~ 5.25 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 85°C 封装/外壳:40-VFQFN 裸露焊盘 包装:带卷 (TR) |
| LTC1142HV | 制造商:LINER 制造商全称:Linear Technology 功能描述:Dual High Efficiency Synchronous Step-Down Switching Regulators |
| LTC1142HV-ADJ | 制造商:LINER 制造商全称:Linear Technology 功能描述:Dual High Efficiency Synchronous Step-Down Switching Regulators |
发布紧急采购，3分钟左右您将得到回复。