- 您现在的位置：买卖IC网 > PDF目录15234 > LTC1438XCG#TR (Linear Technology)IC REG CTRLR BUCK PWM CM 28-SSOP PDF资料下载
参数资料
| 型号： | LTC1438XCG#TR |
| 厂商： | Linear Technology |
| 文件页数： | 12/32页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR BUCK PWM CM 28-SSOP |
| 标准包装： | 2,000 |
| PWM 型： | 电流模式 |
| 输出数： | 2 |
| 频率 - 最大： | 138kHz |
| 占空比： | 99% |
| 电源电压： | 3.5 V ~ 30 V |
| 降压： | 是 |
| 升压： | 无 |
| 回扫： | 无 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | 0°C ~ 70°C |
| 封装/外壳： | 28-SSOP（0.209"，5.30mm 宽） |
| 包装： | 带卷 (TR) |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页当前第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页
LTC1438/LTC1439
APPLICATIO N S I N FOR M ATIO N
The basic LTC1439 application circuit is shown in Fig-
ure 1. External component selection is driven by the load
requirement and begins with the selection of R SENSE . Once
R SENSE is known, C OSC and L can be chosen. Next, the
power MOSFETs and D1 are selected. Finally, C IN and C OUT
are selected. The circuit shown in Figure 1 can be config-
ured for operation up to an input voltage of 28V (limited by
the external MOSFETs).
A graph for selecting C OSC vs frequency is given in Figure
2. As the operating frequency is increased the gate charge
losses will be higher, reducing efficiency (see Efficiency
Considerations). The maximum recommended switching
frequency is 400kHz. When using Figure 2 for
synchronizable applications, choose C OSC corresponding
to a frequency approximately 30% below your center
frequency. (See Phase-Locked Loop and Frequency
Sychronization).
R SENSE Selection for Output Current
R SENSE is chosen based on the required output current.
The LTC1438/LTC1439 current comparator has a maxi-
mum threshold of 150mV/R SENSE and an input common
mode range of SGND to INTV CC . The current comparator
threshold sets the peak of the inductor current, yielding a
maximum average output current I MAX equal to the peak
value less half the peak-to-peak ripple current, ? I L .
Allowing some margin for variations in the LTC1438/
LTC1439 and external component values yield:
300
250
200
150
100
50
V PLLLPF = 0V
R SENSE =
100mV
I MAX
0
0
100 200 300 400 500
OPERATING FREQUENCY (kHz)
LTC1435 ? F02
The LTC1438/LTC1439 work well with values of R SENSE
from 0.005 ? to 0.2 ? .
C OSC Selection for Operating Frequency
The LTC1438/LTC1439 use a constant frequency architec-
ture with the frequency determined by an external oscilla-
tor capacitor on C OSC . Each time the topside MOSFET
turns on, the voltage on C OSC is reset to ground. During the
on-time, C OSC is charged by a fixed current plus an
additional current which is proportional to the output
voltage of the phase detector (V PLLLPF )(LTC1439 only).
When the voltage on the capacitor reaches 1.19V, C OSC is
reset to ground. The process then repeats.
The value of C OSC is calculated from the desired operating
frequency. Assuming the phase-locked loop has no exter-
Figure 2. Timing Capacitor Value
Inductor Value Calculation
The operating frequency and inductor selection are inter-
related in that higher operating frequencies allow the use
of smaller inductor and capacitor values. So why would
anyone ever choose to operate at lower frequencies with
larger components? The answer is efficiency. A higher
frequency generally results in lower efficiency because of
MOSFET gate charge losses. In addition to this basic trade
off, the effect of inductor value on ripple current and low
current operation must also be considered.
The inductor value has a direct effect on ripple current. The
inductor ripple current ? I L decreases with higher induc-
tance or frequency and increases with higher V IN or V OUT :
1 . 37 ( 10 4 )
? Frequency (kHz) ?
V OUT ? 1 – OUT ?
nal oscillator input (V PLLLPF = 0V):
? ?
C OSC ( pF ) = ? ? ? 11
? ?
? I L =
1
( f )( L )
? V ?
? V IN ?
14389fb
12
相关PDF资料 |
PDF描述 |
|---|---|
| VE-J7N-EY-F4 | CONVERTER MOD DC/DC 18.5V 50W |
| LTC1438XCG#PBF | IC REG CTRLR BUCK PWM CM 28-SSOP |
| VI-2TN-EW-F2 | CONVERTER MOD DC/DC 18.5V 100W |
| H2ABT-10106-B8-ND | JUMPER-H1502TR/A3048B/H1500TR 6" |
| SLPX392M050C3P3 | CAP ALUM 3900UF 50V 20% SNAP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC1439CG | 功能描述:IC REG CTRLR BUCK PWM CM 36-SSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,000 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:1MHz 占空比:50% 电源电压:9 V ~ 10 V 降压:无 升压:是 回扫:是 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 85°C 封装/外壳:8-TSSOP（0.173"，4.40mm 宽） 包装:带卷 (TR) |
| LTC1439CG#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 36-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,000 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:1MHz 占空比:50% 电源电压:9 V ~ 10 V 降压:无 升压:是 回扫:是 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 85°C 封装/外壳:8-TSSOP（0.173"，4.40mm 宽） 包装:带卷 (TR) |
| LTC1439CG#TR | 功能描述:IC REG CTRLR BUCK PWM CM 36-SSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LTC1439CG#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 36-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,000 系列:- PWM 型:电压模式 输出数:1 频率 - 最大:1.5MHz 占空比:66.7% 电源电压:4.75 V ~ 5.25 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 85°C 封装/外壳:40-VFQFN 裸露焊盘 包装:带卷 (TR) |
| LTC1439CGW | 功能描述:IC REG CTRLR BUCK PWM CM 36-SSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
发布紧急采购，3分钟左右您将得到回复。