- 您现在的位置：买卖IC网 > PDF目录15236 > LTC1438XCG (Linear Technology)IC REG CTRLR BUCK PWM CM 28-SSOP PDF资料下载
参数资料
| 型号： | LTC1438XCG |
| 厂商： | Linear Technology |
| 文件页数： | 10/32页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR BUCK PWM CM 28-SSOP |
| 标准包装： | 47 |
| PWM 型： | 电流模式 |
| 输出数： | 2 |
| 频率 - 最大： | 138kHz |
| 占空比： | 99% |
| 电源电压： | 3.5 V ~ 30 V |
| 降压： | 是 |
| 升压： | 无 |
| 回扫： | 无 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | 0°C ~ 70°C |
| 封装/外壳： | 28-SSOP（0.209"，5.30mm 宽） |
| 包装： | 管件 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页当前第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页
LTC1438/LTC1439
OPERATIO N
Main Control Loop
(Refer to Functional Diagram)
Low Current Operation
The LTC1438/LTC1439 use a constant frequency, current
mode step-down architecture. During normal operation,
the top MOSFET is turned on each cycle when the oscillator
sets the RS latch and turned off when the main current
comparator I1 resets the RS latch. The peak inductor
current at which I1 resets the RS latch is controlled by the
voltage on the I TH1 (I TH2 ) pin, which is the output of each
error amplifier (EA). The V PROG1 pin, described in the Pin
Functions, allows the EA to receive a selectively attenuated
output feedback voltage V FB1 from the SENSE – 1 pin while
V PROG2 and V OSENSE2 allow EA to receive an output feed-
back voltage V FB2 from either internal or external resistive
dividers on the second controller. When the load current
increases, it causes a slight decrease in V FB relative to the
1.19V reference, which in turn causes the I TH1 (I TH2 )
voltage to increase until the average inductor current
matches the new load current. After the large top MOSFET
has turned off, the bottom MOSFET is turned on until either
the inductor current starts to reverse, as indicated by
current comparator I2, or the beginning of the next cycle.
The top MOSFET drivers are biased from floating boot
strap capacitor C B , which normally is recharged during
each Off cycle. When V IN decreases to a voltage close to
V OUT , however, the loop may enter dropout and attempt to
turn on the top MOSFET continuously. The dropout detec-
tor counts the number of oscillator cycles that the top
MOSFET remains on and periodically forces a brief off
period to allow C B to recharge.
The main control loop is shut down by pulling the RUN/
SS1 (RUN/SS2) pin low. Releasing RUN/SS1 (RUN/SS2)
allows an internal 3 μ A current source to charge soft start
capacitor C SS . When C SS reaches 1.3V, the main control
loop is enabled with the I TH1 (I TH2 ) voltage clamped at
approximately 30% of its maximum value. As C SS contin-
ues to charge, I TH1 (I TH2 ) is gradually released allowing
normal operation to resume. When both RUN/SS1 and
RUN/SS2 are low, all LTC1438/LTC1439 functions are
shut down. Refer to the LTC1538-AUX/LTC1539 data
sheet for 5V keep-alive applications.
Adaptive Power mode allows the LTC1439 to automati-
cally change between two output stages sized for different
load currents. The TGL1 (TGL2) and BG1 (BG2) pins drive
large synchronous N-channel MOSFETs for operation at
high currents, while the TGS1 (TGS2) pin drives a much
smaller N-channel MOSFET used in conjunction with a
Schottky diode for operation at low currents. This allows
the loop to continue to operate at normal operating fre-
quency as the load current decreases without incurring the
large MOSFET gate charge losses. If the TGS1 (TGS2) pin
is left open, the loop defaults to Burst Mode operation in
which the large MOSFETs operate intermittently based on
load demand.
Adaptive Power mode provides constant frequency opera-
tion down to approximately 1% of rated load current. This
results in an order of magnitude reduction of load current
before Burst Mode operation commences. Without the
small MOSFET (i.e., no Adaptive Power mode) the transi-
tion to Burst Mode operation is approximately 10% of
rated load current.
The transition to low current operation begins when com-
parator I2 detects current reversal and turns off the
bottom MOSFET. If the voltage across R SENSE does not
exceed the hysteresis of I2 (approximately 20mV) for one
full cycle, then on following cycles the top drive is routed
to the small MOSFET at the TGS1 (TGS2) pin and the BG1
(BG2) pin is disabled. This continues until an inductor
current peak exceeds 20mV/R SENSE or the I TH1 (I TH2 )
voltage exceeds 0.6V, either of which causes drive to be
returned to the TGL1 (TGL2) pin on the next cycle.
Two conditions can force continuous synchronous opera-
tion, even when the load current would otherwise dictate
low current operation. One is when the common mode
voltage of the SENSE + 1 (SENSE + 2) and SENSE – 1
(SENSE – 2) pins are below 1.4V, and the other is when the
SFB1 pin is below 1.19V. The latter condition is used to
assist in secondary winding regulation, as described in the
Applications Information section.
Comparator OV guards against transient overshoots > 7.5%
by turning off the top MOSFET and keeping it off until the
fault is removed.
14389fb
10
相关PDF资料 |
PDF描述 |
|---|---|
| H2AAT-10104-R8-ND | JUMPER-H1502TR/A3048R/H1502TR 4" |
| ISC1210EB180J | INDUCTOR WW 18UH 5% 1210 |
| LTC1629IG-PG#TR | IC REG CTRLR BUCK PWM CM 28-SSOP |
| LTC1629IG-PG#TRPBF | IC REG CTRLR BUCK PWM CM 28-SSOP |
| LTC1629IG#TRPBF | IC REG CTRLR BUCK PWM CM 28-SSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC1438XCG#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 28-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LTC1438XCG#TR | 功能描述:IC REG CTRLR BUCK PWM CM 28-SSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LTC1438XCG#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 28-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LTC1439CG | 功能描述:IC REG CTRLR BUCK PWM CM 36-SSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,000 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:1MHz 占空比:50% 电源电压:9 V ~ 10 V 降压:无 升压:是 回扫:是 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 85°C 封装/外壳:8-TSSOP（0.173"，4.40mm 宽） 包装:带卷 (TR) |
| LTC1439CG#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 36-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,000 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:1MHz 占空比:50% 电源电压:9 V ~ 10 V 降压:无 升压:是 回扫:是 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 85°C 封装/外壳:8-TSSOP（0.173"，4.40mm 宽） 包装:带卷 (TR) |
发布紧急采购，3分钟左右您将得到回复。