参数资料
型号: LTC1628IG#PBF
厂商: LINEAR TECHNOLOGY CORP
元件分类: 稳压器
英文描述: 3 A SWITCHING CONTROLLER, 310 kHz SWITCHING FREQ-MAX, PDSO28
封装: 0.209 INCH, PLASTIC, SSOP-28
文件页数: 3/32页
文件大小: 360K
代理商: LTC1628IG#PBF
11
LTC1628/LTC1628-PG
Frequency Setting
The FREQSET pin provides frequency adjustment of the
internal oscillator from approximately 140kHz to 310kHz.
This input is nominally biased through an internal resistor
to the 1.19V reference, setting the oscillator frequency to
approximately 220kHz. This pin can be driven from an
external AC or DC signal source to control the instanta-
neous frequency of the oscillator.
INTVCC/EXTVCC Power
Power for the top and bottom MOSFET drivers and most
other internal circuitry is derived from the INTVCC pin.
When the EXTVCC pin is left open, an internal 5V low
dropout linear regulator supplies INTVCC power. If EXTVCC
is taken above 4.7V, the 5V regulator is turned off and an
internal switch is turned on connecting EXTVCC to INTVCC.
This allows the INTVCC power to be derived from a high
efficiency external source such as the output of the regu-
lator itself or a secondary winding, as described in the
Applications Information.
Standby Mode Pin
The STBYMD pin is a three-state input that controls
common circuitry within the IC as follows: When the
STBYMD pin is held at ground, both controller RUN/SS
pins are pulled to ground providing a single control pin to
shut down both controllers. When the pin is left open, the
internal RUN/SS currents are enabled to charge the
RUN/SS capacitor(s), allowing the turn-on of either con-
troller and activating necessary common internal biasing.
When the STBYMD pin is taken above 2V, both internal
linear regulators are turned on independent of the state on
the RUN/SS pins of the two switching regulator control-
lers, providing an output power source for “wake-up”
circuitry. Decouple the pin with a small capacitor (0.01
F)
to ground if the pin is not connected to a DC potential.
Output Overvoltage Protection
An overvoltage comparator, OV, guards against transient
overshoots (>7.5%) as well as other more serious condi-
tions that may overvoltage the output. In this case, the top
MOSFET is turned off and the bottom MOSFET is turned on
until the overvoltage condition is cleared.
Fault Coupling Pin
The FLTCPL pin (LTC1628 only) controls two functions
that can operate individually (FLTCPL = 0V) or unilaterally
(FLTCPL = INTVCC) between the two controllers. When the
FLTCPL pin is grounded (internally tied default mode for
the LTC1628-PG), 1) the FCB input forces continuous
operation only on the first controller when the applied
voltage drops below 0.8V and 2) the short-circuit latchoff
function only latches off the controller having the shorted
output. When the FLTCPL pin is tied to INTVCC, 1) the FCB
input forces continuous operation on
both controllers
when the applied voltage drops below 0.8V and 2) the
short-circuit latchoff function latches off
both controllers
when either has a shorted output.
Power Good (PGOOD) Pin
The PGOOD pin (LTC1628-PG only) is connected to an
open drain of an internal MOSFET. The MOSFET turns on
and pulls the pin low when both the outputs are not within
±7.5% of their nominal output levels as determined by
their resistive feedback dividers. When both outputs meet
the
±7.5% requirement, the MOSFET is turned off within
10
s and the pin is allowed to be pulled up by an external
resistor to a source of up to 7V.
Foldback Current, Short-Circuit Detection
and Short-Circuit Latchoff
The RUN/SS capacitors are used initially to limit the inrush
current of each switching regulator. After the controller
has been started and been given adequate time to charge
up the output capacitors and provide full load current, the
RUN/SS capacitor is used in a short-circuit time-out
circuit. If the output voltage falls to less than 70% of its
nominal output voltage, the RUN/SS capacitor begins
discharging on the assumption that the output is in an
overcurrent and/or short-circuit condition. If the condition
lasts for a long enough period as determined by the size of
the RUN/SS capacitor, the controller (or both controllers
as determined by the FLTCPL pin, LTC1628 only) will be
shut down until the RUN/SS pin(s) voltage(s) are recycled.
This built-in latchoff can be overridden by providing a
>5
A pull-up at a compliance of 5V to the RUN/SS pin(s).
This current shortens the soft start period but also pre-
vents net discharge of the RUN/SS capacitor(s) during an
(Refer to Functional Diagram)
OPERATIO
U
相关PDF资料
PDF描述
LTC1628IG-SYNC#TR 3 A SWITCHING CONTROLLER, 360 kHz SWITCHING FREQ-MAX, PDSO28
LTC1643HCGN#PBF 4-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO16
LTC1643LCGN#TR 4-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO16
LTC1728HS5-5 3-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO5
LTC1729CS8-8.4#TR 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO8
相关代理商/技术参数
参数描述
LTC1628IG-PG 功能描述:IC REG CTRLR BUCK PWM CM 28-SSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX
LTC1628IG-PG#PBF 功能描述:IC REG CTRLR BUCK PWM CM 28-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX
LTC1628IG-PG#TR 功能描述:IC REG CTRLR BUCK PWM CM 28-SSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX
LTC1628IG-PG#TRPBF 功能描述:IC REG CTRLR BUCK PWM CM 28-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX
LTC1628IGSYNC 制造商:Linear Technology 功能描述: