- 您现在的位置：买卖IC网 > PDF目录15237 > LTC1629IG-PG (Linear Technology)IC REG CTRLR BUCK PWM CM 28-SSOP PDF资料下载
参数资料
| 型号： | LTC1629IG-PG |
| 厂商： | Linear Technology |
| 文件页数： | 11/28页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR BUCK PWM CM 28-SSOP |
| 标准包装： | 47 |
| 系列： | PolyPhase® |
| PWM 型： | 电流模式 |
| 输出数： | 1 |
| 频率 - 最大： | 360kHz |
| 占空比： | 99.5% |
| 电源电压： | 4 V ~ 36 V |
| 降压： | 是 |
| 升压： | 无 |
| 回扫： | 无 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 28-SSOP（0.209"，5.30mm 宽） |
| 包装： | 管件 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页当前第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页
LTC1629/LTC1629-PG
OPERATIO
(Refer to Functional Diagram)
INTV CC /EXTV CC Power
Power for the top and bottom MOSFET drivers and most
of the IC circuitry is derived from INTV CC . When the
EXTV CC pin is left open, an internal 5V low dropout
regulator supplies INTV CC power. If the EXTV CC pin is
taken above 4.7V, the 5V regulator is turned off and an
internal switch is turned on connecting EXTV CC to INTV CC .
This allows the INTV CC power to be derived from a high
efficiency external source such as the output of the regu-
lator itself or a secondary winding, as described in the
Applications Information section. An external Schottky
diode can be used to minimize the voltage drop from
EXTV CC to INTV CC in applications requiring greater than
the specified INTV CC current. Voltages up to 7V can be
applied to EXTV CC for additional gate drive capability.
Differential Amplifier
This amplifier provides true differential output voltage
sensing. Sensing both V OUT + and V OUT – benefits regula-
tion in high current applications and/or applications hav-
ing electrical interconnection losses. The AMPMD pin
(available on the LTC1629 only) allows selection of inter-
nal precision feedback resistors for high common mode
rejection differencing applications, or direct access to the
actual amplifier inputs without these internal feedback
resistors for other applications. The AMPMD pin is
grounded to connect the internal precision resistors in a
unity-gain differencing application or tied to the INTV CC
pin to bypass the internal resistors and make the amplifier
inputs directly available. The amplifier is a unity-gain
stable, 2MHz gain-bandwidth, >120dB open-loop gain
design. The amplifier has an output slew rate of 5V/ μ s and
is capable of driving capacitive loads with an output RMS
current typically up to 25mA. The amplifier is not capable
APPLICATIO S I FOR ATIO
The basic LTC1629 application circuit is shown in Figure 1
on the first page. External component selection is driven
by the load requirement, and begins with the selection of
R SENSE1, 2 . Once R SENSE1, 2 are known, L1 and L2 can be
chosen. Next, the power MOSFETs and D1 and D2 are
selected. The operating frequency and the inductor are
chosen based mainly on the amount of ripple current.
of sinking current and therefore must be resistively loaded
to do so. The differential amplifier is configured as a unity-
gain differencing amplifier in the LTC1629-PG.
Power Good (PGOOD) (LTC1629-PG Only)
The PGOOD pin is connected to the drain of an internal
MOSFET. The MOSFET turns on when the output is not
within ± 7.5% of its nominal output level as determined by
the feedback divider. When the output is within ± 7.5% of
its nominal value, the MOSFET is turned off within 10 μ s
and the PGOOD pin should be pulled up by an external
resistor to a source of up to 7V.
Short-Circuit Detection
The RUN/SS capacitor is used initially to limit the inrush
current from the input power source. Once the controllers
have been given time, as determined by the capacitor on
the RUN/SS pin, to charge up the output capacitors and
provide full load current, the RUN/SS capacitor is then
used as a short-circuit timeout circuit. If the output voltage
falls to less than 70% of its nominal output voltage the
RUN/SS capacitor begins discharging assuming that the
output is in a severe overcurrent and/or short-circuit
condition. If the condition lasts for a long enough period
as determined by the size of the RUN/SS capacitor, the
controller will be shut down until the RUN/SS pin voltage
is recycled. This built-in latchoff can be overidden by
providing a >5 μ A pull-up current at a compliance of 5V to
the RUN/SS pin. This current shortens the soft-start
period but also prevents net discharge of the RUN/SS
capacitor during a severe overcurrent and/or short-circuit
condition. Foldback current limiting is activated when the
output voltage falls below 70% of its nominal level whether
or not the short-circuit latchoff circuit is enabled.
Finally, C IN is selected for its ability to handle the input
ripple current (that PolyPhase operation minimizes) and
C OUT is chosen with low enough ESR to meet the output
ripple voltage and load step specifications (also minimized
with PolyPhase). The circuit shown in Figure 1 can be
configured for operation up to an input voltage of 28V
(limited by the external MOSFETs).
11
相关PDF资料 |
PDF描述 |
|---|---|
| LTC3703IGN-5#PBF | IC REG CTRLR BST PWM VM 16-SSOP |
| LT3757MPMSE#TRPBF | IC REG CTRLR PWM CM 10-MSOP |
| NCP304HSQ30T1G | IC VOLT DETECT CMOS 3.0V SC-82AB |
| ISC1210EB150J | INDUCTOR WW 15UH 5% 1210 |
| LTC3890HUH#TRPBF | IC REG CTRLR BUCK PWM CM 32-QFN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC1629IG-PG#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 28-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LTC1629IG-PG#TR | 功能描述:IC REG CTRLR BUCK PWM CM 28-SSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LTC1629IG-PG#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 28-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LTC1642ACGN | 制造商:Linear Technology 功能描述:Hot Swap Controller 1-CH 16.5V 16-Pin SSOP N |
| LTC1642ACGN#PBF | 功能描述:IC CONTROLLER HOTSWAP ADJ 16SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 热交换 系列:- 产品培训模块:Obsolescence Mitigation Program 标准包装:100 系列:- 类型:热插拔开关 应用:通用 内部开关:是 电流限制:可调 电源电压:9 V ~ 13.2 V 工作温度:-40°C ~ 150°C 安装类型:表面贴装 封装/外壳:10-WFDFN 裸露焊盘 供应商设备封装:10-TDFN-EP（3x3） 包装:管件 |
发布紧急采购，3分钟左右您将得到回复。