- 您现在的位置：买卖IC网 > PDF目录15237 > LTC1629IG-PG (Linear Technology)IC REG CTRLR BUCK PWM CM 28-SSOP PDF资料下载
参数资料
| 型号： | LTC1629IG-PG |
| 厂商： | Linear Technology |
| 文件页数： | 18/28页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR BUCK PWM CM 28-SSOP |
| 标准包装： | 47 |
| 系列： | PolyPhase® |
| PWM 型： | 电流模式 |
| 输出数： | 1 |
| 频率 - 最大： | 360kHz |
| 占空比： | 99.5% |
| 电源电压： | 4 V ~ 36 V |
| 降压： | 是 |
| 升压： | 无 |
| 回扫： | 无 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 28-SSOP（0.209"，5.30mm 宽） |
| 包装： | 管件 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页当前第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页
LTC1629/LTC1629-PG
APPLICATIO S I FOR ATIO
( )
t DELAY =
= 1 . 25 s / μ F C
1 . 2 μ A
rent thus ramps up slowly, reducing the starting surge
current required from the input power supply. If RUN/SS
has been pulled all the way to ground there is a delay before
starting of approximately:
1 . 5 V
C SS SS
The time for the output current to ramp up is then:
shown in Figure 6. This resistance shortens the soft-start
period and prevents the discharge of the RUN/SS capaci-
tor during a severe overcurrent and/or short-circuit con-
dition. When deriving the 5 μ A current from V IN as in the
figure, current latchoff is always defeated. Diode-
connecting this pull-up resistor to INTV CC , as in
Figure 6, eliminates any extra supply current during shut-
down while eliminating the INTV CC loading from prevent-
ing controller start-up.
t RAMP =
3 V ? 1. 5 V
1 . 2 μ A
C SS = ( 1 . 25 s / μ F ) C SS
Why should you defeat current latchoff? During the
prototyping stage of a design, there may be a problem with
noise pickup or poor layout causing the protection circuit
By pulling the RUN/SS pin below 0.8V the LTC1629 is put
into low current shutdown (I Q < 40 μ A). RUN/SS can be
driven directly from logic as shown in Figure 6. Diode D1
in Figure 6 reduces the start delay but allows C SS to ramp
up slowly providing the soft-start function. The RUN/SS
pin has an internal 6V zener clamp (see Functional Dia-
gram).
Fault Conditions: Overcurrent Latchoff
The RUN/SS pin also provides the ability to latch off the
controllers when an overcurrent condition is detected. The
RUN/SS capacitor, C SS , is used initially to limit the inrush
current of both controllers. After the controllers have been
started and been given adequate time to charge up the
output capacitors and provide full load current, the RUN/
SS capacitor is used for a short-circuit timer. If the output
to latch off the controller. Defeating this feature allows
troubleshooting of the circuit and PC layout. The internal
short-circuit and foldback current limiting still remains
active, thereby protecting the power supply system from
failure. A decision can be made after the design is com-
plete whether to rely solely on foldback current limiting or
to enable the latchoff feature by removing the pull-up
resistor.
The value of the soft-start capacitor C SS may need to be
scaled with output voltage, output capacitance and load
current characteristics. The minimum soft-start capaci-
tance is given by:
C SS > (C OUT )(V OUT )(10 -4 )(R SENSE )
The minimum recommended soft-start capacitor of C SS =
0.1 μ F will be sufficient for most applications.
voltage falls to less than 70% of its nominal value after C SS
V IN
INTV CC
reaches 4.1V, C SS begins discharging on the assumption
that the output is in an overcurrent condition. If the
condition lasts for a long enough period as determined by
the size of C SS , the controller will be shut down until the
3.3V OR 5V
D1
RUN/SS
R SS *
C SS
D1*
R SS *
RUN/SS
RUN/SS pin voltage is recycled. If the overload occurs
during start-up, the time can be approximated by:
C SS
t LO1 ≈ (C SS ? 0.6V)/(1.2 μ A) = 5 ? 10 5 (C SS )
If the overload occurs after start-up, the voltage on C SS will
*OPTIONAL TO DEFEAT OVERCURRENT LATCHOFF
Figure 6. RUN/SS Pin Interfacing
1629 F06
continue charging and will provide additional time before
latching off:
t LO2 ≈ (C SS ? 3V)/(1.2 μ A) = 2.5 ? 10 6 (C SS )
This built-in overcurrent latchoff can be overridden by
providing a pull-up resistor, R SS , to the RUN/SS pin as
18
Phase-Locked Loop and Frequency Synchronization
The LTC1629 has a phase-locked loop comprised of an
internal voltage controlled oscillator and phase detector.
This allows the top MOSFET turn-on to be locked to the
rising edge of an external source. The frequency range of
the voltage controlled oscillator is ± 50% around the
相关PDF资料 |
PDF描述 |
|---|---|
| LTC3703IGN-5#PBF | IC REG CTRLR BST PWM VM 16-SSOP |
| LT3757MPMSE#TRPBF | IC REG CTRLR PWM CM 10-MSOP |
| NCP304HSQ30T1G | IC VOLT DETECT CMOS 3.0V SC-82AB |
| ISC1210EB150J | INDUCTOR WW 15UH 5% 1210 |
| LTC3890HUH#TRPBF | IC REG CTRLR BUCK PWM CM 32-QFN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC1629IG-PG#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 28-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LTC1629IG-PG#TR | 功能描述:IC REG CTRLR BUCK PWM CM 28-SSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LTC1629IG-PG#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 28-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LTC1642ACGN | 制造商:Linear Technology 功能描述:Hot Swap Controller 1-CH 16.5V 16-Pin SSOP N |
| LTC1642ACGN#PBF | 功能描述:IC CONTROLLER HOTSWAP ADJ 16SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 热交换 系列:- 产品培训模块:Obsolescence Mitigation Program 标准包装:100 系列:- 类型:热插拔开关 应用:通用 内部开关:是 电流限制:可调 电源电压:9 V ~ 13.2 V 工作温度:-40°C ~ 150°C 安装类型:表面贴装 封装/外壳:10-WFDFN 裸露焊盘 供应商设备封装:10-TDFN-EP（3x3） 包装:管件 |
发布紧急采购，3分钟左右您将得到回复。