参数资料
型号: LTC1702IGN#TR
厂商: Linear Technology
文件页数: 23/36页
文件大小: 0K
描述: IC REG CTRLR BUCK PWM VM 24-SSOP
标准包装: 2,500
系列: PolyPhase®
PWM 型: 电压模式
输出数: 2
频率 - 最大: 750kHz
占空比: 93%
电源电压: 3 V ~ 7 V
降压:
升压:
回扫:
反相:
倍增器:
除法器:
Cuk:
隔离:
工作温度: -40°C ~ 85°C
封装/外壳: 24-SSOP(0.154",3.90mm 宽)
包装: 带卷 (TR)
LTC1702
APPLICATIO N S I N FOR M ATIO N
nodes don’t corrupt the measurements or damage the
analyzer.
If breadboard measurement is not practical, a SPICE
simulation can be used to generate approximate gain/
phase curves. Plug the expected capacitor, inductor and
MOSFET values into the following SPICE deck and gener-
ate an AC plot of V(V OUT )/V(COMP) in dB and phase of
V(OUT) in degrees. Refer to your SPICE manual for details
of how to generate this plot.
Finally, choose a convenient resistor value for R1 (10k is
usually a good value). Now calculate the remaining values:
(K is a constant used in the calculations)
? = chosen crossover frequency
G = 10 (GAIN/20) (this converts GAIN in dB to G in absolute
gain)
Type 2 Loop:
K = Tan ?
+ 45 ° ?
*1702  modulator  gain/phase
* ? 1999 Linear Technology
*this file written to run with PSpice 8.0
*may require modifications for other SPICE
? BOOST
? 2
?
?
C 2 =
( )
R 2 =
( )
simulators
*MOSFETs
rfet mod sw 0.02
*inductor
lext sw out1 1u
rl out1 out 0.005
*output cap
cout out out2 1000u
resr out2 0 0.01
*1702 internals
emod mod 0 comp 0 5
vstim comp 0 0 ac 1
.ac dec 100 1k 1meg
;MOSFET rdson
;inductor value
;inductor series R
;capacitor value
;capacitor ESR
;3.3 for 3.3V supply
;ac stimulus
1
2 π ? GKR 1
C 1 = C 2 K 2 – 1
K
2 π ? C 1
V REF R 1
R B =
V OUT – V REF
Type 3 Loop:
K = Tan 2 ?
+ 45 ° ?
C 2 =
( )
R 2 =
.probe
.end
With the gain/phase plot in hand, a loop crossover fre-
quency can be chosen. Usually the curves look something
like Figure 8. Choose the crossover frequency in the rising
or flat parts of the phase curve, beyond the external LC
poles. Frequencies between 10kHz and 50kHz usually
work well. Note the gain (GAIN, in dB) and phase (PHASE,
in degrees) at this point. The desired feedback amplifier
gain will be – GAIN to make the loop gain 0dB at this
? BOOST
? 4
1
2 π ? GR 1
C 1 = C 2 K – 1
K
2 π ? C 1
?
?
frequency. Now calculate the needed phase boost, assum-
ing 60 ° as a target phase margin:
BOOST = – (PHASE + 30 ° )
If the required BOOST is less than 60 ° , a type 2 loop can
be used successfully, saving two external components.
BOOST values greater than 60 ° usually require type 3
loops for satisfactory performance.
R 3 =
C 3 =
R B =
R 1
( K – 1 )
1
2 π ? K R 3
V REF ( R 1 )
V OUT – V REF
1702fa
23
相关PDF资料
PDF描述
LTC1703IG#TRPBF IC REG SW DUAL SYNC VID 28SSOP
LTC1707IS8#TRPBF IC REG BUCK SYNC ADJ 0.6A 8SOIC
LTC1708EG-PG#TRPBF IC REG CTRLR BUCK PWM CM 36-SSOP
LTC1709EG-7#TRPBF IC REG CTRLR BUCK PWM CM 36-SSOP
LTC1709EG-8#TRPBF IC REG CTRLR BUCK PWM CM 36-SSOP
相关代理商/技术参数
参数描述
LTC1703CG 功能描述:IC REG SW DUAL SYNC VID 28SSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - 专用型 系列:- 标准包装:43 系列:- 应用:控制器,Intel VR11 输入电压:5 V ~ 12 V 输出数:1 输出电压:0.5 V ~ 1.6 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:48-VFQFN 裸露焊盘 供应商设备封装:48-QFN(7x7) 包装:管件
LTC1703CG#PBF 功能描述:IC REG SW DUAL SYNC VID 28SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 专用型 系列:- 标准包装:2,000 系列:- 应用:控制器,DSP 输入电压:4.5 V ~ 25 V 输出数:2 输出电压:最低可调至 1.2V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:30-TFSOP(0.173",4.40mm 宽) 供应商设备封装:30-TSSOP 包装:带卷 (TR)
LTC1703CG#TR 制造商:Linear Technology 功能描述:LDO Cntrlr REG CTRLR 0.9V to 2V 28-Pin SSOP T/R
LTC1703CG#TRPBF 功能描述:IC REG SW DUAL SYNC VID 28SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 专用型 系列:- 标准包装:43 系列:- 应用:控制器,Intel VR11 输入电压:5 V ~ 12 V 输出数:1 输出电压:0.5 V ~ 1.6 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:48-VFQFN 裸露焊盘 供应商设备封装:48-QFN(7x7) 包装:管件
LTC1703IG 功能描述:IC REG SW DL SYNC W/VID 28-SSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - 专用型 系列:- 标准包装:43 系列:- 应用:控制器,Intel VR11 输入电压:5 V ~ 12 V 输出数:1 输出电压:0.5 V ~ 1.6 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:48-VFQFN 裸露焊盘 供应商设备封装:48-QFN(7x7) 包装:管件