- 您现在的位置：买卖IC网 > PDF目录13117 > LTC1844ES5-2.8#TRMPBF (Linear Technology)IC REG LDO 2.8V .15A TSOT23-5 PDF资料下载
参数资料
| 型号： | LTC1844ES5-2.8#TRMPBF |
| 厂商： | Linear Technology |
| 文件页数： | 6/12页 |
| 文件大小： | 0K |
| 描述： | IC REG LDO 2.8V .15A TSOT23-5 |
| 产品培训模块： | More Information on LDOs |
| 标准包装： | 1 |
| 稳压器拓扑结构： | 正，固定式 |
| 输出电压： | 2.8V |
| 输入电压： | 最高 6.5V |
| 电压 - 压降（标准）： | 0.105V @ 150mA |
| 稳压器数量： | 1 |
| 电流 - 输出： | 150mA（最小值） |
| 电流 - 限制（最小）： | 160mA |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | SOT-23-5 细型，TSOT-23-5 |
| 供应商设备封装： | TSOT-23-5 |
| 包装： | 剪切带 (CT) |
| 其它名称： | LTC1844ES5-2.8#TRMPBFCT |
LTC1844 Series
TYPICAL PERFOR A CE CHARACTERISTICS
RMS Output Noise vs Load
Current (10Hz to 100kHz)
Input Ripple Rejection
vs Frequency
Input Ripple Rejection
vs Temperature
C OUT = 10 μ F
300
250
200
C BYP = 0 μ F
100
90 C BYP = 1000pF
I L = 100 μ A
80
70
60
50
40
60
150
100
50
40
30
30
20
50
C BYP = 0.1 μ F
20
10
10
0
0.01
0.1
1 10 100
1000
0
10
100
1k 10k
100k
1M
0
–50 –25
0
25
50
75
100
125
LOAD CURRENT (mA)
PI FU CTIO S
1844 G10
FREQUENCY (Hz)
1844 G11
TEMPERATURE ( ° C)
1844 G12
IN (Pin 1): Power for LTC1844 and Load. Power is supplied
to the device through the IN pin. The IN pin should be
locally bypassed to ground if the LTC1844 is more than a
few inches away from another source of bulk capacitance.
In general, the output impedance of a battery rises with
frequency, so it is usually advisable to include an input
bypass capacitor in battery-powered circuits. A capacitor
in the range of 0.1 μ F to 1 μ F is usually sufficient. The
LTC1844 is designed to withstand reverse voltages on the
IN pin with respect to both ground and the output pin. In
the case of a reversed input, which can happen if a battery
is plugged in backwards, the LTC1844 will act as if there
is a large resistor in series with its input and only a small
amount of current will flow.
GND (Pin 2): Ground and Heat Sink. Solder to a ground
plane or large pad to maximize heat dissipation.
SHDN (Pin 3, Fixed and SD Devices): Shutdown, Active
Low. This pin is used to put the LTC1844 into shutdown.
The SHDN pin current is typically less than 10nA. The
SHDN pin cannot be left floating and must be tied to the
input pin if not used. If reverse-battery protection is
desired, the SHDN pin must be tied to the input pin through
a large value resistor (10k to 1M).
ADJ (Pin 4, Adjustable Devices): Output Adjust. For the
adjustable versions of the LTC1844, this is the input to the
error amplifier. It has a typical bias current of 30nA flowing
into the pin. The ADJ pin reference voltage is 1.25V
referenced to ground. The output voltage range is 1.25V to
6V and is typically set by connecting ADJ to a resistor
divider from OUT to GND. See Figure 2.
BYP (Pin 4, Fixed/Pin 3, BYP Devices): Noise Bypass.
The BYP pin is used to augment the internal noise filter to
improve low noise performance. A small low leakage
bypass capacitor from this pin to ground will filter the input
of the error amplifier to lower the output voltage noise.
Any value may be used; larger values will result in lower
output noise, but will increase initial power-up time.
Shutdown exit delay time after a brief shutdown (<10ms)
will not be affected. If not used, this pin must be left
unconnected.
OUT (Pin 5): Voltage Regulated Output. The OUT pin
supplies power to the load. A minimum output capacitor of
1 μ F is required to ensure stability. Larger output capacitors
may be required for applications with large transient loads
to limit peak voltage transients. See the Applications
Information section for more information on output
capacitance.
1844fa
6
相关PDF资料 |
PDF描述 |
|---|---|
| GCM25DTMS-S189 | CONN EDGECARD 50POS R/A .156 SLD |
| RCA44DRMD-S288 | CONN EDGECARD 88POS .125 EXTEND |
| RCC30DREF-S734 | CONN EDGECARD 60POS .100 EYELET |
| 200VXR390MEFCSN30X25 | CAP ALUM 390UF 200V 20% SNAP-IN |
| VE-J12-CZ-B1 | CONVERTER MOD DC/DC 15V 25W |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC1844ES5-3.3#PBF | 制造商:Linear Technology 功能描述:LDO Regulator Pos 3.3V 0.15A 5-Pin TSOT-23 制造商:Linear Technology 功能描述:DP-LINREG, CUT TAPE 3.3V, Micropower, Low Noise VLDO Regulator |
| LTC1844ES5-3.3#TR | 功能描述:IC REG LDO 3.3V .15A TSOT23-5 RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - 线性 系列:- 标准包装:1 系列:- 稳压器拓扑结构:正，固定式 输出电压:3.3V 输入电压:2.5 V ~ 5.5 V 电压 - 压降（标准）:0.1V @ 200mA 稳压器数量:2 电流 - 输出:300mA 电流 - 限制（最小）:350mA 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:8-UFQFN 供应商设备封装:8-MLPQ-UT（1.5x1.5） 包装:剪切带 (CT) 产品目录页面:1358 (CN2011-ZH PDF) 其它名称:SC560HULCT |
| LTC1844ES5-3.3#TRM | 功能描述:IC REG LDO 3.3V .15A TSOT23-5 RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - 线性 系列:- 标准包装:1 系列:- 稳压器拓扑结构:正，固定式 输出电压:3.3V 输入电压:2.5 V ~ 5.5 V 电压 - 压降（标准）:0.1V @ 200mA 稳压器数量:2 电流 - 输出:300mA 电流 - 限制（最小）:350mA 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:8-UFQFN 供应商设备封装:8-MLPQ-UT（1.5x1.5） 包装:剪切带 (CT) 产品目录页面:1358 (CN2011-ZH PDF) 其它名称:SC560HULCT |
| LTC1844ES5-3.3#TRMPBF | 功能描述:IC REG LDO 3.3V .15A TSOT23-5 RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 线性 系列:- 产品培训模块:MIC5365/66 Ultra-small LDO Regulators 标准包装:1 系列:- 稳压器拓扑结构:正，固定式 输出电压:3V 输入电压:最高 5.5V 电压 - 压降（标准）:0.155V @ 150mA 稳压器数量:1 电流 - 输出:150mA 电流 - 限制（最小）:200mA 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:4-UDFN 裸露焊盘，4-TMLF? 供应商设备封装:4-TMLF?（1x1） 包装:Digi-Reel® 其它名称:576-3192-6 |
| LTC1844ES5-3.3#TRPBF | 功能描述:IC REG LDO 3.3V .15A TSOT23-5 RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 线性 系列:- 标准包装:1 系列:- 稳压器拓扑结构:正，固定式 输出电压:3.3V 输入电压:2.5 V ~ 5.5 V 电压 - 压降（标准）:0.1V @ 200mA 稳压器数量:2 电流 - 输出:300mA 电流 - 限制（最小）:350mA 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:8-UFQFN 供应商设备封装:8-MLPQ-UT（1.5x1.5） 包装:剪切带 (CT) 产品目录页面:1358 (CN2011-ZH PDF) 其它名称:SC560HULCT |
发布紧急采购，3分钟左右您将得到回复。