- 您现在的位置：买卖IC网 > PDF目录14013 > LTC1875EGN (Linear Technology)IC REG BUCK SYNC ADJ 1.5A 16SSOP PDF资料下载
参数资料
| 型号： | LTC1875EGN |
| 厂商： | Linear Technology |
| 文件页数： | 10/20页 |
| 文件大小： | 0K |
| 描述： | IC REG BUCK SYNC ADJ 1.5A 16SSOP |
| 标准包装： | 100 |
| 类型： | 降压（降压） |
| 输出类型： | 可调式 |
| 输出数： | 1 |
| 输出电压： | 0.8 V ~ 6 V |
| 输入电压： | 2.65 V ~ 6 V |
| PWM 型： | 电流模式，混合 |
| 频率 - 开关： | 550kHz |
| 电流 - 输出： | 1.5A |
| 同步整流器： | 是 |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 16-SSOP（0.154"，3.90mm 宽） |
| 包装： | 管件 |
| 供应商设备封装： | 16-SSOP |
LTC1875
OPERATIO
Slope Compensation and Inductor Peak Current
Slope compensation is required in order to prevent sub-
harmonic oscillation at high duty cycles. It is accom-
plished by internally adding a compensating ramp to the
inductor current signal at duty cycles in excess of 40%. As
a result, the maximum inductor peak current is reduced for
duty cycles > 40%. This is shown in the decrease of the
inductor peak current as a function of duty cycle graph in
Figure 3.
2200
2000
1800
1600
1400
1200
1000
V IN = 3V
800
0
20
40 60
80
100
DUTY CYCLE (%)
1875 F03
Figure 3. Maximum Inductor Peak Current vs Duty Cycle
APPLICATIO S I FOR ATIO
The basic LTC1875 application circuit is shown on the first
page of this data sheet. External component selection is
driven by the load requirement and begins with the selec-
tion of L followed by C IN and C OUT .
Inductor Value Calculation
The inductor selection will depend on the operating fre-
quency of the LTC1875. The internal nominal frequency is
550kHz, but can be externally synchronized from 350kHz
to 750kHz.
The operating frequency and inductor selection are inter-
related in that higher operating frequencies allow the use
of smaller inductor and capacitor values. However, oper-
ating at a higher frequency results in lower efficiency
because of increased switching losses.
The inductor value has a direct effect on ripple current. The
ripple current ? I L decreases with higher inductance or
frequency and increases with higher input voltages.
A reasonable starting point for setting ripple current is
? I L = 0.3(I MAX ).
The inductor value also has an effect on Burst Mode
operation. The transition to low current operation begins
when the inductor current peaks fall to approximately
500mA. Lower inductor values (higher ? I L ) will cause this
to occur at lower load currents, which can cause a dip in
efficiency in the upper range of low current operation. In
Burst Mode operation, lower inductance values will cause
the burst frequency to increase.
Inductor Selection
The inductor should have a saturation current rating
greater than the peak inductor current set by the current
comparator of LTC1875. Also, consideration should be
given to the resistance of the inductor. Inductor conduc-
tion losses are directly proportional to the DC resistance
of the inductor. Manufacturers sometimes provide maxi-
mum current ratings based on the allowable losses in the
V OUT ? 1 – OUT ?
? I L =
1
( f )( L )
? V ?
? V IN ?
(1)
inductor.
Suitable inductors are available from Coilcraft, Coiltron-
Accepting larger values of ? I L allows the use of smaller
inductors, but results in higher output voltage ripple.
ics, Dale, Sumida, Toko, Murata, Panasonic and other
manufacturers.
1875f
10
相关PDF资料 |
PDF描述 |
|---|---|
| VE-JWW-CZ-F2 | CONVERTER MOD DC/DC 5.5V 25W |
| VE-JWV-CZ-F1 | CONVERTER MOD DC/DC 5.8V 25W |
| MAX6718AUKLTD1+T | IC SUPERVISOR MPU SOT23-5 |
| MAX6718AUKMRD2+T | IC SUPERVISOR MPU SOT23-5 |
| MAX6718AUKMSD6+T | IC SUPERVISOR MPU SOT23-5 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC1875EGN#PBF | 功能描述:IC REG BUCK SYNC ADJ 1.5A 16SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:250 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.2V 输入电压:2.05 V ~ 6 V PWM 型:电压模式 频率 - 开关:2MHz 电流 - 输出:500mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:6-UFDFN 包装:带卷 (TR) 供应商设备封装:6-SON（1.45x1） 产品目录页面:1032 (CN2011-ZH PDF) 其它名称:296-25628-2 |
| LTC1875EGN#TR | 功能描述:IC REG BUCK SYNC ADJ 1.5A 16SSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.2V，1.5V，1.8V，2.5V 输入电压:2.7 V ~ 20 V PWM 型:- 频率 - 开关:- 电流 - 输出:50mA 同步整流器:是 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:10-TFSOP，10-MSOP（0.118"，3.00mm 宽）裸露焊盘 包装:带卷 (TR) 供应商设备封装:10-MSOP 裸露焊盘 |
| LTC1875EGN#TRPBF | 功能描述:IC REG BUCK SYNC ADJ 1.5A 16SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.2V，1.5V，1.8V，2.5V 输入电压:2.7 V ~ 20 V PWM 型:- 频率 - 开关:- 电流 - 输出:50mA 同步整流器:是 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:10-TFSOP，10-MSOP（0.118"，3.00mm 宽）裸露焊盘 包装:带卷 (TR) 供应商设备封装:10-MSOP 裸露焊盘 |
| LTC1876EG | 功能描述:IC REG CTRLR BST PWM CM 36-SSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LTC1876EG#PBF | 功能描述:IC REG CTRLR BST PWM CM 36-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
发布紧急采购，3分钟左右您将得到回复。