- 您现在的位置：买卖IC网 > PDF目录14013 > LTC1875EGN (Linear Technology)IC REG BUCK SYNC ADJ 1.5A 16SSOP PDF资料下载
参数资料
| 型号： | LTC1875EGN |
| 厂商： | Linear Technology |
| 文件页数： | 14/20页 |
| 文件大小： | 0K |
| 描述： | IC REG BUCK SYNC ADJ 1.5A 16SSOP |
| 标准包装： | 100 |
| 类型： | 降压（降压） |
| 输出类型： | 可调式 |
| 输出数： | 1 |
| 输出电压： | 0.8 V ~ 6 V |
| 输入电压： | 2.65 V ~ 6 V |
| PWM 型： | 电流模式，混合 |
| 频率 - 开关： | 550kHz |
| 电流 - 输出： | 1.5A |
| 同步整流器： | 是 |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 16-SSOP（0.154"，3.90mm 宽） |
| 包装： | 管件 |
| 供应商设备封装： | 16-SSOP |
LTC1875
APPLICATIO S I FOR ATIO
To avoid the LTC1875 from exceeding the maximum
junction temperature, the user will need to do some
thermal analysis. The goal of the thermal analysis is to
determine whether the power dissipated exceeds the
maximum junction temperature of the part. Normally,
some iterative calculation is required to determine a rea-
sonably accurate value. The temperature rise is given by:
T R = P ? θ JA
where P is the power dissipated by the regulator and θ JA
is the thermal resistance from the junction of the die to the
ambient temperature.
The junction temperature is given by:
T J = T A + T R
where T A is the ambient temperature. Because the power
transistor R DS(ON) is a function of temperature, it is
usually necessary to iterate 2 to 3 times through the
equations to achieve a reasonably accurate value for the
junction temperature.
As an example, consider the LTC1875 in dropout at an
input voltage of 3V, a load current of 0.8A and an ambient
temperature of 70 ° C. From the typical performance graph
of switch resistance, the R DS(ON) of the P-channel switch
at 70 ° C is 0.35 ? . Therefore, power dissipated by the IC is:
P = I 2 ? R DS(ON) = 0.224W
For the SSOP package, the θ JA is 110 ° C/W. Thus the
junction temperature of the regulator is:
T J = 70 ° C + (0.224)(110) = 95 ° C
However, at this temperature, the R DS(ON) is actually 0.4 ? .
Therefore:
T J = 70 ° C + (0.256)(140) = 98 ° C
which is below the maximum junction temperature of
125 ° C.
Note that at higher supply voltages, the junction tempera-
ture is lower due to reduced switch resistance (R DS(ON) ).
Checking Transient Response
The regulator loop response can be checked by looking at
the load transient response. Switching regulators take
several cycles to respond to a step in load current. When
a load step occurs, V OUT immediately shifts by an amount
equal to ( ? I LOAD ? ESR), where ESR is the effective series
resistance of C OUT . ? I LOAD also begins to charge or
discharge C OUT , generating a feedback error signal. The
regulator loop then acts to return V OUT to its steady-state
value. During this recovery time, V OUT can be monitored
for overshoot or ringing that would indicate a stability
problem. The I TH pin can be used for external compensa-
tion as shown in Figure 9. (The capacitor, C C2 , is typically
needed for noise decoupling.)
A second, more severe transient is caused by switching in
loads with large (> 1 μ F) supply bypass capacitors. The
discharged bypass capacitors are effectively put in parallel
with C OUT , causing a rapid drop in V OUT . No regulator can
deliver enough current to prevent this problem if the load
switch resistance is low and it is driven quickly. The only
solution is to limit the rise time of the switch drive so that
the load rise time is limited to approximately (25 ? C LOAD ).
Thus, a 10 μ F capacitor charging to 3.3V would require a
250 μ s rise time, limiting the charging current to about
130mA.
1875f
14
相关PDF资料 |
PDF描述 |
|---|---|
| VE-JWW-CZ-F2 | CONVERTER MOD DC/DC 5.5V 25W |
| VE-JWV-CZ-F1 | CONVERTER MOD DC/DC 5.8V 25W |
| MAX6718AUKLTD1+T | IC SUPERVISOR MPU SOT23-5 |
| MAX6718AUKMRD2+T | IC SUPERVISOR MPU SOT23-5 |
| MAX6718AUKMSD6+T | IC SUPERVISOR MPU SOT23-5 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC1875EGN#PBF | 功能描述:IC REG BUCK SYNC ADJ 1.5A 16SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:250 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.2V 输入电压:2.05 V ~ 6 V PWM 型:电压模式 频率 - 开关:2MHz 电流 - 输出:500mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:6-UFDFN 包装:带卷 (TR) 供应商设备封装:6-SON（1.45x1） 产品目录页面:1032 (CN2011-ZH PDF) 其它名称:296-25628-2 |
| LTC1875EGN#TR | 功能描述:IC REG BUCK SYNC ADJ 1.5A 16SSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.2V，1.5V，1.8V，2.5V 输入电压:2.7 V ~ 20 V PWM 型:- 频率 - 开关:- 电流 - 输出:50mA 同步整流器:是 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:10-TFSOP，10-MSOP（0.118"，3.00mm 宽）裸露焊盘 包装:带卷 (TR) 供应商设备封装:10-MSOP 裸露焊盘 |
| LTC1875EGN#TRPBF | 功能描述:IC REG BUCK SYNC ADJ 1.5A 16SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.2V，1.5V，1.8V，2.5V 输入电压:2.7 V ~ 20 V PWM 型:- 频率 - 开关:- 电流 - 输出:50mA 同步整流器:是 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:10-TFSOP，10-MSOP（0.118"，3.00mm 宽）裸露焊盘 包装:带卷 (TR) 供应商设备封装:10-MSOP 裸露焊盘 |
| LTC1876EG | 功能描述:IC REG CTRLR BST PWM CM 36-SSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LTC1876EG#PBF | 功能描述:IC REG CTRLR BST PWM CM 36-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
发布紧急采购，3分钟左右您将得到回复。