- 您现在的位置：买卖IC网 > PDF目录10153 > LTC2140CUP-14#TRPBF (Linear Technology)IC ADC DUAL 14BIT 25 MSPS 64-QFN PDF资料下载
参数资料
| 型号： | LTC2140CUP-14#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 17/38页 |
| 文件大小： | 0K |
| 描述： | IC ADC DUAL 14BIT 25 MSPS 64-QFN |
| 标准包装： | 2,000 |
| 位数： | 14 |
| 采样率（每秒）： | 25M |
| 数据接口： | 并联，串行，SPI |
| 转换器数目： | 2 |
| 功率耗散（最大）： | 202mW |
| 电压电源： | 模拟和数字 |
| 工作温度： | 0°C ~ 70°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 64-WFQFN 裸露焊盘 |
| 供应商设备封装： | 64-QFN（9x9） |
| 包装： | 带卷 (TR) |
| 输入数目和类型： | 2 个差分 |
| 配用： | DC890B-ND - BOARD USB DATA COLLECTION |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页当前第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页
LTC2142-14/
LTC2141-14/LTC2140-14
24
21421014fa
APPLICATIONS INFORMATION
Full Rate CMOS Mode
In full rate CMOS mode the data outputs (D1_0 to D1_13
and D2_0 to D2_13), overflow (OF2, OF1), and the data
output clocks (CLKOUT+, CLKOUT–) have CMOS output
levels. The outputs are powered by OVDD and OGND which
are isolated from the A/D core power and ground. OVDD
can range from 1.1V to 1.9V, allowing 1.2V through 1.8V
CMOS logic outputs.
For good performance, the digital outputs should drive
minimal capacitive loads. If the load capacitance is larger
than 10pF a digital buffer should be used.
Double Data Rate CMOS Mode
In double data rate CMOS mode, two data bits are
multiplexed and output on each data pin. This reduces
the number of digital lines by fifteen, simplifying board
routing and reducing the number of input pins needed
to receive the data. The data outputs (D1_0_1, D1_2_3,
D1_4_5,D1_6_7,D1_8_9,D1_10_11,D1_12_13,D2_0_1,
D2_2_3, D2_4_5, D2_6_7, D2_8_9, D2_10_11,
D2_12_13), overflow (OF2_1), and the data output clocks
(CLKOUT+, CLKOUT–) have CMOS output levels. The out-
puts are powered by OVDD and OGND which are isolated
from the A/D core power and ground. OVDD can range
from 1.1V to 1.9V, allowing 1.2V through 1.8V CMOS logic
outputs. Note that the overflow for both ADC channels is
multiplexed onto the OF2_1 pin.
For good performance, the digital outputs should drive
minimal capacitive loads. If the load capacitance is larger
than 10pF a digital buffer should be used.
Double Data Rate LVDS Mode
In double data rate LVDS mode, two data bits are multi-
plexed and output on each differential output pair. There
are seven LVDS output pairs per ADC channel (D1_0_1+/
D1_0_1– through D1_12_13+/D1_12_13– and D2_0_1+/
D2_0_1– through D2_12_13+/D2_12_13–) for the digital
output data. Overflow (OF2_1+/OF2_1–) and the data
output clock (CLKOUT+/CLKOUT–) each have an LVDS
output pair. Note that the overflow for both ADC channels
is multiplexed onto the OF2_1+/OF2_1– output pair.
By default the outputs are standard LVDS levels: 3.5mA
output current and a 1.25V output common mode volt-
age. An external 100Ω differential termination resistor
is required for each LVDS output pair. The termination
resistors should be located as close as possible to the
LVDS receiver.
The outputs are powered by OVDD and OGND which are
isolated from the A/D core power and ground. In LVDS
mode, OVDD must be 1.8V.
Programmable LVDS Output Current
In LVDS mode, the default output driver current is 3.5mA.
This current can be adjusted by serially programming mode
control register A3. Available current levels are 1.75mA,
2.1mA, 2.5mA, 3mA, 3.5mA, 4mA and 4.5mA.
Optional LVDS Driver Internal Termination
In most cases, using just an external 100Ω termination
resistor will give excellent LVDS signal integrity. In addi-
tion, an optional internal 100Ω termination resistor can
be enabled by serially programming mode control register
A3. The internal termination helps absorb any reflections
caused by imperfect termination at the receiver. When the
internal termination is enabled, the output driver current
is doubled to maintain the same output voltage swing.
Overflow Bit
The overflow output bit outputs a logic high when the analog
input is either overranged or underranged. The overflow
bit has the same pipeline latency as the data bits. In full
rate CMOS mode each ADC channel has its own overflow
pin (OF1 for channel 1, OF2 for channel 2). In DDR CMOS
or DDR LVDS mode the overflow for both ADC channels
is multiplexed onto the OF2_1 output.
相关PDF资料 |
PDF描述 |
|---|---|
| LTC1605IG#TR | IC ADC 16BIT 5V SAMPLING 28SSOP |
| VE-22P-IW-F1 | CONVERTER MOD DC/DC 13.8V 100W |
| MS3100E28-11PX | CONN RCPT 22POS WALL MNT W/PINS |
| MS3100E28-11P | CONN RCPT 22POS WALL MNT W/PINS |
| SF4282-11EPG-3ES | CONN RCPT 11POS PNL MNT PIN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC2140IUP-12#PBF | 功能描述:IC ADC DUAL 12BIT 25MSPS 64-QFN RoHS:是 类别:集成电路 (IC) >> 数据采集 - 模数转换器 系列:- 标准包装:1,000 系列:- 位数:12 采样率（每秒）:300k 数据接口:并联 转换器数目:1 功率耗散（最大）:75mW 电压电源:单电源 工作温度:0°C ~ 70°C 安装类型:表面贴装 封装/外壳:24-SOIC（0.295"，7.50mm 宽） 供应商设备封装:24-SOIC 包装:带卷 (TR) 输入数目和类型:1 个单端，单极；1 个单端，双极 |
| LTC2140IUP-12#TRPBF | 功能描述:IC ADC DUAL 12BIT 25MSPS 64-QFN RoHS:是 类别:集成电路 (IC) >> 数据采集 - 模数转换器 系列:- 标准包装:1,000 系列:- 位数:12 采样率（每秒）:300k 数据接口:并联 转换器数目:1 功率耗散（最大）:75mW 电压电源:单电源 工作温度:0°C ~ 70°C 安装类型:表面贴装 封装/外壳:24-SOIC（0.295"，7.50mm 宽） 供应商设备封装:24-SOIC 包装:带卷 (TR) 输入数目和类型:1 个单端，单极；1 个单端，双极 |
| LTC2140IUP-14#PBF | 功能描述:IC ADC DUAL 14BIT 25 MSPS 64-QFN RoHS:是 类别:集成电路 (IC) >> 数据采集 - 模数转换器 系列:- 标准包装:1 系列:- 位数:14 采样率（每秒）:83k 数据接口:串行，并联 转换器数目:1 功率耗散（最大）:95mW 电压电源:双 ± 工作温度:0°C ~ 70°C 安装类型:通孔 封装/外壳:28-DIP（0.600"，15.24mm） 供应商设备封装:28-PDIP 包装:管件 输入数目和类型:1 个单端，双极 |
| LTC2140IUP-14#TRPBF | 功能描述:IC ADC DUAL 14BIT 25 MSPS 64-QFN RoHS:是 类别:集成电路 (IC) >> 数据采集 - 模数转换器 系列:- 标准包装:1 系列:- 位数:14 采样率（每秒）:83k 数据接口:串行，并联 转换器数目:1 功率耗散（最大）:95mW 电压电源:双 ± 工作温度:0°C ~ 70°C 安装类型:通孔 封装/外壳:28-DIP（0.600"，15.24mm） 供应商设备封装:28-PDIP 包装:管件 输入数目和类型:1 个单端，双极 |
| LTC2141-14 | 制造商:LINER 制造商全称:Linear Technology 功能描述:12-Bit, 65Msps/ 40Msps/25Msps Low Power Dual ADCs |
发布紧急采购，3分钟左右您将得到回复。