- 您现在的位置：买卖IC网 > PDF目录10252 > LTC2449IUHF#PBF (Linear Technology)IC ADC 24BIT HI SPEED 38QFN PDF资料下载
参数资料
| 型号： | LTC2449IUHF#PBF |
| 厂商： | Linear Technology |
| 文件页数： | 25/28页 |
| 文件大小： | 0K |
| 描述： | IC ADC 24BIT HI SPEED 38QFN |
| 标准包装： | 52 |
| 位数： | 24 |
| 采样率（每秒）： | 8k |
| 数据接口： | MICROWIRE?，串行，SPI? |
| 转换器数目： | 1 |
| 功率耗散（最大）： | 40mW |
| 电压电源： | 单电源 |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 38-WFQFN 裸露焊盘 |
| 供应商设备封装： | 38-QFN（5x7） |
| 包装： | 管件 |
| 输入数目和类型： | 16 个单端，双极；8 个差分，双极 |
| 配用： | DC742A-ND - BOARD DELTA SIGMA ADC LTC2449 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页当前第25页第26页第27页第28页
LTC2444/LTC2445/
LTC2448/LTC2449
6
2444589fb
determines if a new channel/speed is selected. If this bit is
low the following conversion remains at the same speed
and selected channel. The serial data input is applied to the
device under control of the serial clock (SCK) during the
data output cycle. The first conversion following a new
channel/speed is valid.
FO (Pin 35): Frequency Control Pin. Digital input that
controls the internal conversion clock. When FO is con-
nected to VCC or GND, the converter uses its internal
oscillator running at 9MHz. The conversion rate is deter-
mined by the selected OSR such that tCONV (ms) = 40
OSR + 170/fOSC (kHz). The first digital filter null is located
at 8/tCONV, 7kHz at OSR = 256 and 55Hz (Simultaneous 50/
60Hz) at OSR = 32768. This pin may be driven with a
maximum external clock of 10.24MHz resulting in a maxi-
mum 8kHz output rate (OSR = 64, 2X Mode).
CS (Pin 36): Active Low Chip Select. A LOW on this pin
enables the SDO ditital output and wakes up the ADC.
Following each conversion the ADC automatically enters
the sleep mode and remains in this low power state as long
as CS is HIGH. A LOW-to-HIGH transition on CS during the
Data Output aborts the data transfer and starts a new
conversion.
SDO (Pin 37): Three-State Digital Output. During the data
output period, this pin is used as serial data output. When
the chip select CS is HIGH (CS = VCC) the SDO pin is in a
high impedance state. During the conversion and sleep
periods, this pin is used as the conversion status output.
The conversion status can be observed by pulling CS
LOW. This signal is HIGH while the conversion is in
progress and goes LOW once the conversion is complete.
SCK (Pin 38): Bidirectional Digital Clock Pin. In internal
serial clock operation mode, SCK is used as a digital output
for the internal serial interface clock during the data output
period. In the external serial clock operation mode, SCK is
used as the digital input for the external serial interface
clock during the data output period. The serial clock
operation mode is determined by the logic level applied to
the EXT pin.
Exposed Pad (Pin 39): Ground. The exposed pad on the
bottom of the package must be soldered to the PCB ground.
For prototyping purposes, this pin may remain floating.
GND – 0.3V to VCC + 0.3V. Within these limits, the two
selected inputs (IN+ and IN–) provide a bipolar input range
(VIN = IN+ – IN–) from –0.5 VREF to 0.5 VREF. Outside this
input range, the converter produces unique over-range
and under-range output codes.
CH0 to CH15 (Pins 8-23): LTC2448/LTC2449 Analog
Inputs. May be programmed for single-ended or differen-
tial mode.
CH0 to CH7 (Pins 9, 10, 13, 14, 17, 18, 21, 22): LTC2444/
LTC2445 Analog Inputs. May be programmed for single-
ended or differential mode.
NC (Pins 8, 11, 12, 15, 16, 19, 20, 23): LTC2444/
LTC2445 No Connect/Channel Isolation Shield. May be
left floating or tied to any voltage 0 to VCC in order to
provide isolation for pairs of differential input channels.
NC (Pins 24, 25, 26, 27): LTC2444/LTC2448 No Connect.
These pins can either be tied to ground or left floating.
MUXOUTP (Pin 24): LTC2445/LTC2449 Positive Multi-
plexer Output. Used to drive the input to an external buffer/
amplifier.
ADCINP (Pin 25): LTC2445/LTC2449 Positive ADC Input.
Tie to output of buffer/amplifier driven by MUXOUTP.
ADCINN (Pin 26): LTC2445/LTC2449 Negative ADC Input.
Tie to output of buffer/amplifier driven by MUXOUTN.
MUXOUTN (Pin 27): LTC2445/LTC2449 Negative Multi-
plexer Output. Used to drive the input to an external buffer/
amplifier.
VCC (Pin 28): Positive Supply Voltage. Bypass to GND with
a 10
F tantalum capacitor in parallel with a 0.1F ceramic
capacitor as close to the part as possible.
REF+ (Pin 29), REF– (Pin 30): Differential Reference
Input. The voltage on these pins can have any value
between GND and VCC as long as the reference positive
input, REF+, is maintained more positive than the negative
reference input, REF+, by at least 0.1V.
SDI (Pin 34): Serial Data Input. This pin is used to select
the speed, 1X or 2X mode, resolution, and input channel,
for the next conversion cycle. At initial power up, the
default mode of operation is CH0-CH1, OSR of 256, and 1X
mode. The serial data input contains an enable bit which
PI FU CTIO S
UU
U
相关PDF资料 |
PDF描述 |
|---|---|
| VE-26F-IU-S | CONVERTER MOD DC/DC 72V 200W |
| AD7829BRU | IC ADC 8BIT 8CH 2MSPS 28TSSOP |
| LTC2447IUHF#TRPBF | IC ADC 24BIT 8CH HI SPEED 38QFN |
| LTC1867CGN | IC ADC 16BIT 8CH 200KSPS 16SSOP |
| VE-22V-MX-F3 | CONVERTER MOD DC/DC 5.8V 75W |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC2450CDC#PBF | 制造商:Linear Technology 功能描述:ADC Single Delta-Sigma 30sps 16-bit Serial 6-Pin DFN EP 制造商:Linear Technology 功能描述:ADC Single Delta-Sigma 0.03KSPS 16-Bit Serial 6-Pin DFN EP 制造商:Linear Technology 功能描述:ADC Single Delta-Sigma 0.03KSPS 16-Bit Serial 6-Pin DFN EP Bulk 制造商:Linear Technology 功能描述:ADC 16BIT 30SPS SPI DFN-6 制造商:Linear Technology 功能描述:ADC, 16BIT, 30SPS, SPI, DFN-6; Resolution (Bits):16bit; Sampling Rate:30SPS; Supply Voltage Type:Single; Supply Voltage Min:2.7V; Supply Voltage Max:5.5V; Supply Current:350A; Digital IC Case Style:DFN; No. of Pins:6 ;RoHS Compliant: Yes |
| LTC2450CDC#TRMPBF | 功能描述:IC ADC 16BIT DELTA SIG 6-DFN RoHS:是 类别:集成电路 (IC) >> 数据采集 - 模数转换器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:1 系列:- 位数:10 采样率（每秒）:357k 数据接口:DSP，MICROWIRE?，QSPI?，串行，SPI? 转换器数目:1 功率耗散（最大）:830µW 电压电源:单电源 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:10-WFDFN 裸露焊盘 供应商设备封装:10-TDFN-EP（3x3） 包装:剪切带 (CT) 输入数目和类型:2 个单端，单极；2 个单端，双极；1 个差分，单极；1 个差分，双极 产品目录页面:1396 (CN2011-ZH PDF) 其它名称:MAX1395ETB+TCT |
| LTC2450CDC#TRPBF | 功能描述:IC ADC 16BIT DELTA SIG 6-DFN RoHS:是 类别:集成电路 (IC) >> 数据采集 - 模数转换器 系列:- 标准包装:2,500 系列:- 位数:16 采样率（每秒）:15 数据接口:MICROWIRE?，串行，SPI? 转换器数目:1 功率耗散（最大）:480µW 电压电源:单电源 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:38-WFQFN 裸露焊盘 供应商设备封装:38-QFN（5x7） 包装:带卷 (TR) 输入数目和类型:16 个单端，双极；8 个差分，双极 配用:DC1011A-C-ND - BOARD DELTA SIGMA ADC LTC2494 |
| LTC2450CDC-1#PBF | 制造商:Linear Technology 功能描述:EASY-TO-USE, ULTRA-TINY 16-BIT DELTA SEGMA ADC 制造商:Linear Technology 功能描述:Bulk 制造商:Linear Technology 功能描述:ADC 16BIT DEL SIG 60HZ 6DF 制造商:Linear Technology 功能描述:ADC, 16BIT, 60SPS, SPI, DFN-6; Resolution (Bits):16bit; Sampling Rate:60SPS; Supply Voltage Type:Single; Supply Voltage Min:2.7V; Supply Voltage Max:5.5V; Supply Current:350A; Digital IC Case Style:DFN; No. of Pins:6 ;RoHS Compliant: Yes |
| LTC2450CDC-1#TRMPBF | 功能描述:IC ADC 16BIT DELTA SIG 6-DFN RoHS:是 类别:集成电路 (IC) >> 数据采集 - 模数转换器 系列:- 标准包装:1 系列:microPOWER™ 位数:8 采样率（每秒）:1M 数据接口:串行，SPI? 转换器数目:1 功率耗散（最大）:- 电压电源:模拟和数字 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:24-VFQFN 裸露焊盘 供应商设备封装:24-VQFN 裸露焊盘（4x4） 包装:Digi-Reel® 输入数目和类型:8 个单端，单极 产品目录页面:892 (CN2011-ZH PDF) 其它名称:296-25851-6 |
发布紧急采购，3分钟左右您将得到回复。