- 您现在的位置：买卖IC网 > PDF目录1830 > LTC3532EDD#TRPBF (Linear Technology)IC REG BUCK BOOST SYNC ADJ 10DFN PDF资料下载
参数资料
| 型号： | LTC3532EDD#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 7/16页 |
| 文件大小： | 0K |
| 描述： | IC REG BUCK BOOST SYNC ADJ 10DFN |
| 标准包装： | 2,500 |
| 类型： | 降压（降压），升压（升压） |
| 输出类型： | 可调式 |
| 输出数： | 1 |
| 输出电压： | 2.4 V ~ 5.25 V |
| 输入电压： | 2.4 V ~ 5.5 V |
| PWM 型： | Burst Mode? |
| 频率 - 开关： | 300kHz ~ 2MHz |
| 电流 - 输出： | 500mA |
| 同步整流器： | 是 |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 10-WFDFN 裸露焊盘 |
| 包装： | 带卷 (TR) |
| 供应商设备封装： | 10-DFN（3x3） |
LTC3532
OPERATIO
The LTC3532 provides high ef?ciency, low noise power
for applications such as portable instrumentation, digital
cameras, and MP3 players. The LTC proprietary topology
allows input voltages above, below or equal to the output
voltage by properly phasing the output switches. The error
amp output voltage on V C determines the output duty cycle
of the switches. Since V C is a ?ltered signal, it provides
rejection of frequencies well below the switching frequency.
The low R DS(ON) , low gate charge synchronous switches
provide high frequency pulse width modulation control at
high ef?ciency. Schottky diodes across the synchronous
switch D and synchronous switch B are not required, but
provide a lower voltage drop during the break-before-make
time (typically 15ns). Schottky diodes will improve peak
ef?ciency by typically 1% to 2%. High ef?ciency is achieved
at light loads when Burst Mode operation is entered and
the IC’s quiescent current drops to a low 35μA.
LOW NOISE FIXED FREQUENCY OPERATION
Oscillator
The frequency of operation is programmed by an external
resistor from R T to ground, according to the following
equation:
cally 50ns. A second ampli?er will begin to source current
into the FB pin to drop the output voltage once the peak
input current exceeds 1A typical. This method provides a
closed loop means of clamping the input current. During
conditions where V OUT is near ground, such as during a
short-circuit or during startup, this threshold is cut in half
providing a fold back feature. For this current limit feature
to be most effective, the Thevenin resistance from FB to
ground should be greater than 100k.
Reverse Current Limit
During ?xed frequency operation, the LTC3532 operates in
forced continuous conduction mode. The reverse current
limit ampli?er monitors the inductor current from the out-
put through switch D. Once the negative inductor current
exceeds 340mA typical, the IC will shut off switch D.
4-Switch Control
Figure 1 shows a simpli?ed diagram of how the four internal
switches are connected to the inductor, V IN , V OUT and GND.
Figure 2 shows the regions of operation for the LTC3532 as
a function of the internal control voltage, V CI . Depending
on the control voltage, the IC will operate in either buck,
buck/boost or boost mode. The V CI voltage is a level shifted
f(kHz) =
48,000
R T (k Ω )
voltage from the output of the error amp (V C ) (see Figure
5). The four power switches are properly phased so the
transfer between operating modes is continuous, smooth
Error Amp
The error ampli?er is a voltage mode ampli?er. The loop
compensation components are con?gured around the
ampli?er (from FB to V C ) to obtain stability of the converter.
For improved bandwidth, an additional RC feedforward
and transparent to the user. When V IN approaches V OUT
the buck/boost region is reached where the conduction
time of the 4-switch region is typically 150ns. Referring
to Figures 1 and 2, the various regions of operation will
now be described.
network can be placed across the upper feedback divider
resistor. The voltage on SHDN /SS clamps the error amp
output, V C , to provide a soft-start function.
V IN
7
PMOS A
V OUT
6
PMOS D
Internal Current Limit
There are two different current limit circuits in the LTC3532.
They have internally ?xed thresholds which vary inversely
SW1
3
NMOS B
SW2
4
NMOS C
with V IN . The ?rst circuit is a high speed peak current limit
comparator that will shut off switch A if the current exceeds
1.1A typical. The delay to output of this ampli?er is typi-
3532 F01
Figure 1. Simpli?ed Diagram of Output Switches
3532fc
7
相关PDF资料 |
PDF描述 |
|---|---|
| LTC3533EDE#TRPBF | IC REG BUCK BOOST SYNC ADJ 14DFN |
| LTC3534EGN#TRPBF | IC REG BUCK BST SYNC 0.5A 16SSOP |
| LTC3535EDD#PBF | IC REG BST SYNC ADJ 0.55A 12DFN |
| LTC3536IMSE#TRPBF | IC REG BUCK BST SYNC ADJ 12MSOP |
| LTC3538EDCB#TRPBF | IC REG BUCK BOOST SYNC ADJ 8DFN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3532EMS | 制造商:Linear Technology 功能描述:Conv DC-DC Single Non-Inv/Inv/Step Up/Step Down 2.4V to 5.5V 10-Pin MSOP |
| LTC3532EMS#PBF | 功能描述:IC REG BUCK BST SYNC 0.5A 10MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:250 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.2V 输入电压:2.05 V ~ 6 V PWM 型:电压模式 频率 - 开关:2MHz 电流 - 输出:500mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:6-UFDFN 包装:带卷 (TR) 供应商设备封装:6-SON（1.45x1） 产品目录页面:1032 (CN2011-ZH PDF) 其它名称:296-25628-2 |
| LTC3532EMS#TR | 制造商:Linear Technology 功能描述:Conv DC-DC Single Non-Inv/Inv/Step Up/Step Down 2.4V to 5.5V 10-Pin MSOP T/R |
| LTC3532EMS#TRPBF | 功能描述:IC REG BUCK BST SYNC 0.5A 10MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:升压（升压） 输出类型:可调式 输出数:1 输出电压:1.24 V ~ 30 V 输入电压:1.5 V ~ 12 V PWM 型:电流模式，混合 频率 - 开关:600kHz 电流 - 输出:500mA 同步整流器:无 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:8-SOIC（0.154"，3.90mm 宽） 包装:带卷 (TR) 供应商设备封装:8-SOIC |
| LTC3532EMS-PBF | 制造商:LINER 制造商全称:Linear Technology 功能描述:Micropower Synchronous Buck-Boost DC/DC Converter |
发布紧急采购，3分钟左右您将得到回复。