- 您现在的位置：买卖IC网 > PDF目录79697 > LTC3565IDD#TRPBF (LINEAR TECHNOLOGY CORP) 2.5 A SWITCHING REGULATOR, 4000 kHz SWITCHING FREQ-MAX, PDSO10 PDF资料下载
参数资料
| 型号： | LTC3565IDD#TRPBF |
| 厂商： | LINEAR TECHNOLOGY CORP |
| 元件分类： | 稳压器 |
| 英文描述： | 2.5 A SWITCHING REGULATOR, 4000 kHz SWITCHING FREQ-MAX, PDSO10 |
| 封装： | 3 X 3 MM, LEAD FREE, PLASTIC, MO-229WEED-2, DFN-10 |
| 文件页数： | 9/22页 |
| 文件大小： | 587K |
| 代理商： | LTC3565IDD#TRPBF |
LTC3565
3565fa
applications inForMation
lossesincludingdiodeconductionlossesduringdead-time
and inductor core losses, which generally account for less
than 2% total additional loss.
Thermal Considerations
In a majority of applications, the LTC3565 does not dis-
sipate much heat due to its high efficiency. However, in
applicationswheretheLTC3565isrunningathighambient
temperature with low supply voltage and high duty cycles,
such as in dropout, the heat dissipated may exceed the
maximum junction temperature of the part. If the junction
temperature reaches approximately 150°C, both power
switches will be turned off and the SW node will become
high impedance.
To avoid the LTC3565 from exceeding the maximum junc-
tion temperature, the user will need to do some thermal
analysis. The goal of the thermal analysis is to determine
whether the power dissipated exceeds the maximum
junction temperature of the part. The temperature rise is
given by:
TRISE = PD θJA
where PD is the power dissipated by the regulator and θJA
is the thermal resistance from the junction of the die to
the ambient temperature.
The junction temperature, TJ, is given by:
TJ = TRISE + TAMBIENT
As an example, consider the case when the LTC3565 is
in dropout at an input voltage of 3.3V with a load current
of 1A. From the Typical Performance Characteristics
graph of Switch Resistance, the RDS(ON) resistance of the
P-channel switch is 0.160Ω. Therefore, power dissipated
by the part is:
PD = IOUT2 RDS(ON) = 160mW
TheMSEpackagejunction-to-ambientthermalresistance,
θJA, will be in the range of about 40°C/W. Therefore, the
junction temperature of the regulator operating in a 70°C
ambient temperature is approximately:
TJ = 0.16 40 + 70 = 76.4°C
Remembering that the above junction temperature is
obtained from an RDS(ON) at 25°C, we might recalculate
the junction temperature based on a higher RDS(ON) since
it increases with temperature. However, we can safely as-
sume that the actual junction temperature will not exceed
the absolute maximum junction temperature of 125°C.
Design Example
As a design example, consider using the LTC3565 in a
portable application with a Li-Ion battery. The battery pro-
vides a VIN = 2.5V to 4.2V. The load requires a maximum
of 1.25A in active mode and 10mA in standby mode. The
output voltage is VOUT = 2.5V. Since the load still needs
power in standby, Burst Mode operation is selected for
good low load efficiency.
First, calculate the timing resistor for 1MHz operation:
RT = 1.21 106 (103)–1.2674 = 190.8k
Use a standard value of 191k. Next, calculate the inductor
value for about 40% ripple current at maximum VIN:
L =
2.5V
1MHz 500mA
1 2.5V
4.2V
= 2H
Choosing the closest inductor from a vendor of 2.2H,
results in a maximum ripple current of:
Δ
IL =
2.5V
1MHz 2.2H
1 2.5V
4.2V
= 460mA
For cost reasons, a ceramic capacitor will be used. COUT
selection is then based on load step droop instead of ESR
requirements. For a 5% output droop:
COUT ≈ 2.5
1.25A
1MHz (5% 2.5V)
= 25F
The closest standard value is 22F. Since the output
impedance of a Li-Ion battery is very low, CIN is typically
22F. In noisy environments, decoupling SVIN from PVIN
with an R6/C8 filter of 1Ω/0.1F may help, but is typically
not needed.
相关PDF资料 |
PDF描述 |
|---|---|
| LS75-12 | 1-OUTPUT DC-DC UNREG PWR SUPPLY MODULE |
| LED15-48S05W | 1-OUTPUT 15 W DC-DC REG PWR SUPPLY MODULE |
| LFFSWG-TTL-70F | SQUARE, 0.07 MHz, WAVEFORM GENERATION, PDIP4 |
| LFFSWG-TTL-55J | SQUARE, 0.055 MHz, WAVEFORM GENERATION, PDSO4 |
| LH2540-2-V3 | 2-OUTPUT 51 W AC-DC REG PWR SUPPLY MODULE |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3565IMSE | 制造商:LINER 制造商全称:Linear Technology 功能描述:1.25A, 4MHz, Synchronous Step-Down DC/DC Converter |
| LTC3565IMSE#PBF | 功能描述:IC REG BUCK SYNC ADJ 10MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:升压（升压） 输出类型:可调式 输出数:1 输出电压:1.24 V ~ 30 V 输入电压:1.5 V ~ 12 V PWM 型:电流模式，混合 频率 - 开关:600kHz 电流 - 输出:500mA 同步整流器:无 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:8-SOIC（0.154"，3.90mm 宽） 包装:带卷 (TR) 供应商设备封装:8-SOIC |
| LTC3565IMSE#TRPBF | 功能描述:IC REG BUCK SYNC ADJ 10MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:升压（升压） 输出类型:可调式 输出数:1 输出电压:1.24 V ~ 30 V 输入电压:1.5 V ~ 12 V PWM 型:电流模式，混合 频率 - 开关:600kHz 电流 - 输出:500mA 同步整流器:无 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:8-SOIC（0.154"，3.90mm 宽） 包装:带卷 (TR) 供应商设备封装:8-SOIC |
| LTC3565IMSEPBF | 制造商:LINER 制造商全称:Linear Technology 功能描述:1.25A, 4MHz, Synchronous Step-Down DC/DC Converter |
| LTC3565IMSE-PBF | 制造商:LINER 制造商全称:Linear Technology 功能描述:1.25A, 4MHz, Synchronous Step-Down DC/DC Converter |
发布紧急采购，3分钟左右您将得到回复。