参数资料
| 型号： | LTC3565IMSE#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 13/22页 |
| 文件大小： | 0K |
| 描述： | IC REG BUCK SYNC ADJ 10MSOP |
| 标准包装： | 2,500 |
| 类型： | 降压（降压） |
| 输出类型： | 可调式 |
| 输出数： | 1 |
| 输出电压： | 0.6 V ~ 5 V |
| 输入电压： | 2.5 V ~ 5.5 V |
| PWM 型： | 电流模式，混合 |
| 频率 - 开关： | 最高 4MHz |
| 电流 - 输出： | 1.25A |
| 同步整流器： | 是 |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 10-TFSOP，10-MSOP（0.118"，3.00mm 宽）裸露焊盘 |
| 包装： | 带卷 (TR) |
| 供应商设备封装： | 10-MSOP 裸露焊盘 |
LTC3565
APPLICATIONS INFORMATION
C OUT ≈ 2.5
V OUT ≈ 0.6V ? 1 +
?
dropofthefirstcycle.Thus,agoodplacetostartiswith
the output capacitor value of approximately:
Δ I OUT
f O ? V DROOP
More capacitance may be required depending on the duty
cycle and load step requirements.
In most applications, the input capacitor is merely required
to supply high frequency bypassing, since the impedance
to the supply is very low. A 10μF ceramic capacitor is
usually enough for these conditions.
Setting the Output Voltage
The LTC3565 develops a 0.6V reference voltage between
the feedback pin, V FB , and the signal ground as shown in
Figure 4. The output voltage is set by a resistive divider
according to the following formula:
? R2 ?
? R1 ?
Keeping the current small (<5μA) in these resistors maxi-
mizes efficiency, but making them too small may allow
stray capacitance to cause noise problems and reduce the
phase margin of the error amp loop.
To improve the frequency response, a feed-forward capaci-
tor C F may also be used. Great care should be taken to
route the V FB line away from noise sources, such as the
inductor or the SW line.
Shutdown and Soft-Start
Pulling the RUN pin high allows an internal soft-start circuit
to slowly ramp the output voltage up until regulation.
Soft-start prevents surge currents from V IN by gradually
ramping the output voltage up during start-up. The output
will ramp from zero to full scale over a time period of ap-
proximately 0.9ms. This prevents the LTC3565 from having
to quickly charge the output capacitor and thus supplying
an excessive amount of instantaneous current.
The LTC3565 can start into a back-biased output in force
continuous operation. When the output is pre-biased at
either a higher or lower value than the regulated output
voltage, the LTC3565 will sink or source current as needed
to bring the output back into regulation. However, during
soft-start the regulator will always start in pulse skip
mode ignoring the mode selected with the SYNC/MODE
pin. This prevents the output from discharging to below
the regulation point when soft-starting.
Mode Selection and Frequency Synchronization
The SYNC/MODE pin is a multipurpose pin which provides
mode selection and frequency synchronization. Connect-
ing this pin to V IN enables Burst Mode operation, which
provides the best low current efficiency at the cost of a
higher output voltage ripple. When this pin is connected to
ground, pulse skipping operation is selected which provides
the lowest output voltage and current ripple at the cost
of low current efficiency. Applying a voltage that is half
the value of the input voltage results in forced continuous
mode, which creates a fixed output ripple and is capable of
sinking up to 0.4A. Since the switching noise is constant
in this mode, it is also the easiest to filter out.
The LTC3565 can also be synchronized to an external
clock signal by the SYNC/MODE pin. The internal oscilla-
tor frequency should be set to ±20% of the external clock
frequency to ensure adequate slope compensation, since
slope compensation is derived from the internal oscillator.
During synchronization, the mode is set to pulse skipping
and the top switch turn on is synchronized to the falling
edge of the external clock.
3565fc
For more information www.linear.com/LTC3565
13
相关PDF资料 |
PDF描述 |
|---|---|
| LTC3568IDD#TRPBF | IC REG BUCK SYNC ADJ 1.8A 10DFN |
| LTC3569IFE#TRPBF | IC REG BUCK SYNC ADJ 16TSSOP |
| LTC3600EMSE#PBF | IC REG BUCK SYNC ADJ 1.5A 12MSOP |
| LTC3601IUD#TRPBF | IC REG BUCK SYNC ADJ 1.5A 16QFN |
| LTC3602IFE#TRPBF | IC REG BUCK SYNC ADJ 16TSSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3566 | 制造商:LINER 制造商全称:Linear Technology 功能描述:High Efficiency USB Power Manager |
| LTC3566EUF#PBF | 功能描述:IC USB POWER MANAGER 24-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 电源管理 - 专用 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:50 系列:- 应用:热电冷却器 电流 - 电源:- 电源电压:3 V ~ 5.5 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:28-SOIC（0.173"，4.40mm 宽）裸露焊盘 供应商设备封装:28-TSSOP 裸露焊盘 包装:管件 产品目录页面:1410 (CN2011-ZH PDF) |
| LTC3566EUF#TRPBF | 功能描述:IC USB POWER MANAGER 24-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 电源管理 - 专用 系列:- 标准包装:1 系列:- 应用:手持/移动设备 电流 - 电源:- 电源电压:3 V ~ 5.5 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:14-WFDFN 裸露焊盘 供应商设备封装:14-LLP-EP（4x4） 包装:Digi-Reel® 配用:LP3905SD-30EV-ND - BOARD EVALUATION LP3905SD-30 其它名称:LP3905SD-30DKR |
| LTC3566EUF-2#PBF | 功能描述:IC POWER MANAGER USB 24-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 电源管理 - 专用 系列:- 标准包装:1 系列:- 应用:手持/移动设备 电流 - 电源:- 电源电压:3 V ~ 5.5 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:14-WFDFN 裸露焊盘 供应商设备封装:14-LLP-EP（4x4） 包装:Digi-Reel® 配用:LP3905SD-30EV-ND - BOARD EVALUATION LP3905SD-30 其它名称:LP3905SD-30DKR |
| LTC3566EUF-2#TRPBF | 功能描述:IC POWER MANAGER USB 24-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 电源管理 - 专用 系列:- 标准包装:1 系列:- 应用:手持/移动设备 电流 - 电源:- 电源电压:3 V ~ 5.5 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:14-WFDFN 裸露焊盘 供应商设备封装:14-LLP-EP（4x4） 包装:Digi-Reel® 配用:LP3905SD-30EV-ND - BOARD EVALUATION LP3905SD-30 其它名称:LP3905SD-30DKR |
发布紧急采购，3分钟左右您将得到回复。